2001 Toyota Sequoia

The contact owns a 2001 Toyota Sequoia. The contact stated while driving 15 MPH, the front driver’s side wheel bearing fracture causing the tire to detach from the vehicle. The vehicle was towed to the dealer and the front wheel bearing was repaired; however, the failure reoccurred. The manufacturer was not contacted. The failure mileage was 200,000.

I was coming off the highway goi g down the off ramp at a rate of speed in line with the speed limit, and the vsc/abs/brake lights all came on. The truck started making a grinding noise and was difficult to control. I pulled over and checked underneath. Everything was fine and there was no sign of an issue. I turned the truck off and on, and all the lights cleared; however, the lights turn on again when the vehicle is cold. Once it warms up, and you turn the car on and off, the clear. No codes on the scanner. Forums say this happens regularly with this make, model and year, but no one is sure what it is. Everything from emissions, to the brake sensor to the yaw rate sensor.

I have changed tires 2 times but I did not know that my sequoia has a recalled from the suspension and it seems to me that all the suspension is out eventhough that I replaced the struts upper and lower balljoint side arm rod tide even the racquet pinion may be out please help with the nesessary repair driving it like that I’m putting my family at having a accident cause the tire do not wear properly sincerely Joseluis saldana

Frame Replacement needed: I took my 2001 Toyota Sequoia (45,515 miles; always garaged) in for an Emissions & Safety Inspection. I was notified the excessive rust on the frame has cause damage to the lines for the brakes/bubbling on the lines, fuel line, power steering fluid lines and, eventually, other undercar items may soon fail. It is recommended that due to the excessive rusting/premature frame rotting, the SUV should be decommissioned and off the road. Toyota dealership actually suggested that it might be necessary for me to sign a waiver in order to take the vehicle out of the dealership. The waiver was to hold Toyota harmless should something result as a result of the defect. I was shocked at the request/I declined. Stated the severe rusting is from the front to the rear of the frame. Research shows the Toyota Corporation is fully aware of the excessive rusting on the Toyota Sequoia SUVs however no remedy has been in place to resolve the issue for current owners. I am advised to replace the fuel lines (approximately $1700 for parts and labor), however, upon replacement the excessive rusting to the frame may damage the other lines in the vehicle and the frame will need to be replaced as well (about $10,000). The 2nd technician stated he has done work on 20+ year old SUVs a lot, none with anywhere near this type of premature rusted frame. Stated he couldn't believe how bad it is. Said it flakes apart when you touch it anywhere. He stressed that I should not have my octogenarian mom, and 1st grader in the vehicle. This is our family vehicle. The 2001 Sequoia SUV was built on a tundra frame which had a structural recall (NHTSA action number: pe09049) for frames built in 2000 and 2001. The Sequoia was left out of this recall; a 2012 Spray Option was offered for the frame (I was told by "Israel" today / Brand Ambassador Department). I never received the notification. No dupport from Toyota. The frame, fuel lines need replacement. Pls help!

The contact owns a 2001 Toyota Sequoia. The contact stated while approaching the vehicle, she noticed rust and corrosion on the undercarriage of the entire vehicle. The contact stated that she had received a manufacturer recall notification and the vehicle was taken to the local dealer who sprayed the undercarriage with a rust coating inhibitor to prevent the undercarriage from rusting however, the failure occurred. The contact took the vehicle to another local dealer Millennium Toyota (257 N. Franklin St, Hempstead, NY 11550, (516) 874-2581) who inspected the vehicle and stated that the vehicle was unsafe to drive. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 100,000.

Recently I took the vehicle in to investigate a clunking noise. I was informed by the shop that the frame had completely rusted through, causing the rear stabilizer arm to become detached. I also had a front stabilizer link fail twice in a year, presumably from the frame excessively flexing. Upon further investigation, I came to learn that Toyota is quite aware of this very issue, they’ve issued recalls where insufficient measures may have been taken to temporarily stop the rusting, and that many many other Sequoia owners have the same exact problems that I’m having, and Toyota refuses to take responsibility for this premature failure and provide some sort of relief. Given the frequency and number of complaints, I’m kind of shocked that NHTSA hasn’t banned these vehicles from the roadways. Seems like a serious accident waiting to happen. It’s not like the facts are in question in this case. There must be hundreds or thousands of examples. If you do a web search for “2001-2004 toyota sequoia rust corrosion on frame” you’ll find a bunch of examples, as well as accounts of Toyota’s numerous refusals to stand behind their mistakes. I still have the vehicle, and would gladly help you with any investigation. I did have part of the frame welded just so I could limp it back home to WI. I towed it on a trailer. It runs great, and is in very good condition, which is why this is all such a shame.