IllustrationBELIEVE MANUFACTURER MADE DEFECTIVE PARTS ENCLOSED IN WHEEL BEARING ASSEMBLY-LEFT REAR WHEEL MAKING NOISE FROM BEARING, BOTH ARE LEAKING GREASE-PREMATURE FAILURE. *AK
1996 Toyota Camry
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1996 Toyota Camry do not stand out strongly from the model-year median of 295.
About this comparison →How this year compares
Owner complaints by model year
Compare all Camry years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 98 of 417 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 76 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 52 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Vehicle Speed Control. Review the 50 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
55 crash reports8 fire reports44 injury reports
What owners actually said
417 reportsCONSUMER HEARS A CLUNKING NOISE WHEN THE VEHICLE IS STOPPED, PLACED IN REVERSE, PLACED IN DRIVE AND WHILE BRAKING. NLM
TURN SIGNAL FAILED, REPAIRED WIRING TO THE HAZARD SWITCH, HOWEVER CONTINUED TO EXPERIENCE INTERMITTENT FAILURE AFTER REPAIR. *MJS
WHEN ATTEMPTING TO QUICKLY STOP AT HIGH SPEEDS (50+ MPH), THE FRONT BRAKES GROAN/GRIND AND VIBRATE. THIS INCREASES STOPPING DISTANCE BY A FACTOR OF 2 AND IS UNSAFE. PADS AND ROTORS WHERE REPLACED BY DEALER AT MY COST BUT THE PROBLEM STILL OCCURS. TSBBR002-96 DESCRIBES THE PROBLEM BUT DID NOT HELP. I BELIEVE THIS IS A DESIGN FLAW…
Read full complaint
WHEN ATTEMPTING TO QUICKLY STOP AT HIGH SPEEDS (50+ MPH), THE FRONT BRAKES GROAN/GRIND AND VIBRATE. THIS INCREASES STOPPING DISTANCE BY A FACTOR OF 2 AND IS UNSAFE. PADS AND ROTORS WHERE REPLACED BY DEALER AT MY COST BUT THE PROBLEM STILL OCCURS. TSBBR002-96 DESCRIBES THE PROBLEM BUT DID NOT HELP. I BELIEVE THIS IS A DESIGN FLAW WITH POTENTIAL OF SERIOUS INJURY. *AK
STEERING WHEEL IS VERY HARD TO MANEUVER, ONLY IN WET CONDITIONS IS STEERING NORMAL. DEALER IS AWARE, AND WILL ONLY REPAIR UNDER RAINY CONDITIONS. *AK
WHILE DRIVING AT LOW SPEED VEHICLE WOULD STALL WITHOUT PRIOR WARNING. EVERY 7-8 MONTHS IT SHOWS SYMPTOMS OF INSTABILITY DURING IGNITION. THE RPM NEEDLE IS ALSO VERY UNSTABLE, ESPECIALLY ON COLDER DAYS. *AK *ML
VEHICLES OXYGEN SENSOR FAILURE CAUSED THE ENGINE TO SURGE AND DIE UNLESS THE ENGINE IS COMPLETELY WARM. *ET
VEHICLE EXPERIENCED FAILURE OF THE RECALL COMPONENT PRIOR TO NOTIFICATION. (99V-307) *MJS
VEHICLE WAS INVOLVED IN A FRONTAL COLLSION, AND AIRBAGS DID NOT DEPLOY. THE DEALER AND MANUFACTURER WILL BE NOTIFIED. *AK
WHILE DRIVING VEHICLE STALLS UNEXPECTEDLY WHICH MAY CAUSE A CRASH. DEALER CANNOT DETERMINE THE CAUSE. PLEASE PROVIDE FURTHER INFORMATION. *AK
Official recalls
299V307000 · Steering: Steering Wheel/handle Bar
Nov 1, 1999
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE STEERING WHEEL SET NUT MAY NOT HAVE BEEN SUFFICIENTLY TIGHTENED CAUSING STEERING VIBRATION AND LOOSENESS.
Consequence & remedy
Consequence: THIS CAN RESULT IN A LOSS OF VEHICLE CONTROL.
Remedy: DEALERS WILL TIGHTEN THE STEERING WHEEL SET NUT.
96V037000 · Exterior Lighting:tail Lights
Feb 20, 1996
THE PLASTIC MATERIAL OF THE BULB HOLDERS OF THE REAR TAIL LIGHT ASSEMBLY DOES NOT HAVE SUFFICIENT HEAT RESISTANCE. WHEN THE BULB IS ILLUMINATED, THE RESULTING HIGH TEMPERATURE CAN CAUSE THE BULB HOLDER TO DEFORM.
Consequence & remedy
Consequence: AS THE BULB HOLDER DEFORMS, THE BULB CAN LOSE ELECTRICAL CONTACT, RESULTING IN AN INOPERATIVE LAMP, INCREASING THE RISK OF A VEHICLE ACCIDENT.
Remedy: DEALERS WILL INSPECT THE REAR COMBINATION LAMP BULB HOLDER TO SEE IF IT IS THE DEFECTIVE MATERIAL. THE DEFECTIVE BULB HOLDER TOGETHER WITH THE WIRING HARNESS WILL BE REPLACED WITH A CORRECT BULB HOLDER AND HARNESS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2DP02004 · Engine Seizure
Opened Apr 30, 2002 · Closed Jun 20, 2002
Status: closed (inferred from source dates) · Engine And Engine Cooling
No summary supplied.
PE01024 · Suspension Coil Spring
Opened Jul 18, 2001 · Closed Jan 29, 2002
Status: closed (inferred from source dates) · Suspension
No summary supplied.