2006 Subaru Outback

ERROR CODE P2138, LOTS OF PEOPLE ARE TALKING ABOUT HOW SUBARU IS NOT FIXING OR CALLING OUT THE DEFECT IN THE ACCELERATOR PEDAL POSITION SENSOR. ISSUES WITH CONNECTIONS OF THE PLUG, WATER/DIRT CAUSING CORROSION TO NOT ALLOW IT TO WORK, AND DEALERS NOT FIXING THE REAL ISSUE. I WAS DRIVING AND SLOWING DOWN AS LIGHT WAS RED BUT THEN IT CHANGED TO GREEN. I PUSHED GAS AND WOULDN'T ALLOW ME TO ACCELERATE AND CHECK ENGINE LIGHT CAME ON. 30 SECONDS LATER PRETTY MUCH ALL OF MY INDICATOR LIGHTS CAME ON. CRUISE LIGHT WAS EVEN BLINKING. VIDEOS I'VE BEEN WATCHING TALK ABOUT FLY BY WIRE PEDALS AND HOW IT PUTS CARS INTO LIMP MODE. WHICH IS WHAT IT WAS DOING WHEN I FIRST TRY TO ACCELERATE. I CLEARED A LOT OF CODES BY DOING THE CRUISE BUTTON RESET WHICH FOR NOW TURNED MOST LIGHTS OFF BUT STILL HAVE LIMP MODE ISSUES WHEN FIRST TRYING TO ACCELERATE AFTER A COMPLETE STOP.

CAR WILL SUDDENLY GO LIMP. WITH NO WARNING OR ANYTHING THE CAR IS STILL RUNNING BUT THERE IS NO THROTTLE OR THROTTLE PEDAL RESPONSE. YOU CAN FLOOR THE GAS PEDAL AND NOTHING HAPPENS. IT HAS HAPPENS WHILE DRIVING DOWN A ROAD AND ALL YOU CAN DO IS HOPE THAT YOU CAN GET TO THE SIDE OF THE ROAD. I WAS DRIVING DOWN A COUNTRY ROAD WHEN THIS LAST HAPPENED. I CAME TO A TURN WHERE YOU EITHER HAVE TO STOP OR MERGE TO THE RIGHT ONTO ANOTHER ROAD. AS I WENT TO ACCERERATE THERE WAS NO RESPONSE FROM THE CAR. I LOOKED DOWN AND THE CHECK ENGINE LIGHT IS ON AS WELL AS THE CRUISE CONTROL LIGHT IS NOW FLASHING. I TRIED TURNING THE CAR OFF AND BACK ON SEVERAL TIMES. I FINALLY SHUT THE CAR OFF FOR 3-5 MINUTES BEFORE THE THROTTLE WOULD RESPOND. IF THIS HAPPENED ON THE A BUSY FREEWAY WITH HEAVY TRAFFIC, IT COULD BE VERY DANGEROUS!!

WHILE IN MOTION, RAPIDLY APPLYING THE BRAKES CAUSES CHECK ENGINE LIGHT TO COME ON, THE CRUISE CONTROL INDICATOR FLASHES AND CONTROL OF THE ACCELERATOR PEDAL LOST. THE CAR ESSENTIALLY BECOMES LIMP AND IS NOT ABLE TO RECEIVE INPUT FROM THE ACCELERATOR PEDAL AT THIS TIME. TURNING THE CAR OFF AND LETTING IT SIT FOR 30 SECONDS AND THEN TURNING THE CAR BACK ON RE-PROVIDES CONTROL TO THE ACCELERATOR PEDAL. AT THIS TIME THE CHECK ENGINE LIGHT IS STILL ON. AFTER A COUPLE OF DAYS THE CHECK ENGINE LIGHT GOES OFF. MY LOCAL AUTHORIZED SUBARU SHOP TRACED THE ISSUE TO A FAULTY ACCELERATOR PEDAL SENSOR. THE ENTIRE ASSEMBLY WAS REPLACED AND THE CAR IS OPERATING NOMINALLY. TWO TWO INSTANCES WHERE THIS CAUSED A SERIOUS CONCERN WAS WHEN I WAS LEFT STRANDED IN THE MIDDLE OF AN INTERSECTION WHEN A CAR IN FRONT OF ME SLAMMED ON IT'S BRAKES AND CHOSE TO TURN RIGHT INSTEAD OF THE INTENDED DIRECTION OF TRAVEL STRAIGHT THROUGH THE INTERSECTION. THE SECOND TIME WAS TO AVOID AN ANIMAL RUNNING ACROSS THE ROAD IN FRONT OF THE CAR. IN BOTH INSTANCES THE CAR WAS MOVING AT ROUGHLY 25MPH.

WHILE DRIVING CAR CHECK ENGINE LIGHT WILL COME ON AND CRUISE CONTROL LIGHT WILL FLASH. CAR GOES INTO LIMP MODE AND THE ACCELERATOR WILL NOT LONGER RESPOND DROPPING THE CARS SPEED DRASTICALLY. THIS CAN HAPPEN ON ANY ROAD, AT ANY SPEED, AND ANY WEATHER CONDITION. TEMPORARY FIX IS TO STOP AND CYCLE THE CARS POWER THREE OR FOUR TIMES. MORE PERMANENT FIX IS TO REPLACE THE PEDAL ASSEMBLY-ACCELERATOR AT A COST OF $199. HAPPENED A FEW DOZEN TIMES BEFORE I FINALLY GOT THE PEDAL ASSEMBLY REPLACED. ISSUED STARTED EARLY 2016, AND REPLACED THE ASSEMBLY IN 2018.

ACCELERATOR PEDAL GOES LIMP AND UNRESPONSIVE AT RANDOM MOMENTS INCLUDING HIGHWAY DRIVING. IT HAS HAPPENS MORE AND MORE OFTEN AND OTHER SUBARU OWNERS HAVE SAID THE SAME. IT SEEMS TO HAPPEN THE MOST DURING COLDER WEATHER AND THE CARS GAS PEDAL BECOMES COMPLETELY UNRESPONSIVE AND REQUIRES THE CAR TO BE PULLED OVER OVER AND TURNED OFF TO SIT FOR A SOME TIME. WHEN PUTTING THE CAR INTO PARK THE RPMS JUMP UP AND REV HIGHER TO AROUND 4000, UNSURE OF WHAT'S CAUSING IT.

WHILE TRAVELING AT HIGHWAY SPEED THE GAS PEDAL QUITS WORKING AND CAR GOES INTO LIMP MODE, THIS IS WHERE CAR TRAVELS AT 30 MPH WITH NO CONTROL FROM THE GAS PEDAL, THE CHECK ENGINE LIGHT COMES ON AND THE CRUISE CONTROL LIGHT FLASHES, THE ONLY WAY TO RESET THE FUEL PEDAL IS TO PULL OVER, SHUT CAR OFF FOR 1 MIN. AND RESTART PEDAL WILL WORK BUT CHECK ENGINE LIGHT AND CRUISE CONTROL LIGHT WILL FLASH UNTIL ERROR CODE IS RESET. CODE IS P2138 . THIS MAY FIX PEDAL TEMPORARY BUT IT WILL HAPPEN AGAIN. WHEN PEDAL QUITS WORKING THIS IS VERY DANGEROUS IN HEAVY TRAFFIC. THIS HAS HAPPENED TO THE CAR AT LEASED 20 TIMES, HAVE NOT FOUND A PERMANENT FIX YET. NEEDS TO BE RECALLED AND REPAIRED

ON STREET, FROM PARK WITH ENGINE IDLING, CAR IN DRIVE, ACCELERATOR PEDAL DEAD AT FIRST, THEN HIGH RPM 3000+ WITH PEDAL RELEASED. NO CONTROL OF ENGINE RPM. CEL AND CC ILLUMINATED ON INSTRUMENT PANEL. PUT TRANSMISSION IN NEUTRAL. KILLED IGNITION SWITCH. ENGINE SHUT DOWN. RESTARTED ENGINE AND RPM WAS NORMAL. VERY FRIGHTENING! FOUND DTC P2138 ACC PEDAL SENSOR FAILURE. CALLED SUBARU SUPPORT, NO SUCH RECORD OF FAILURE. CALLED DEALER FROM WHICH CAR WAS PURCHASED, ANSWER WAS BRING CAR IN AND WILL TRY TO REPAIR. THIS IS A SERIOUS FAILURE AND DANGER. PLEASE SEE THIS FAILURE ON GOOGLE. MANY PEOPLE ARE REPORTING THE SAME ISSUE. I AM APPREHENSIVE TO PUT THIS CAR ON THE ROAD ESPECIALLY WITH OTHER PEOPLE IN IT. AN INVESTIGATION SHOULD BE PURSUED IN THESE DRIVE BY WIRE VEHICLES AS THIS CAR IS. PLEASE TAKE THIS SERIOUSLY.. THANK YOU