2013 Subaru Impreza

The brakes failed due to a leak in the brake lines (pedal to the floor). Location of the leak is just after a union on the passenger side rear (just in front of the rear tire). Location is not well protected from corrosion similar to other recalls for the wrx and sti version of the impreza. Image shows the corroded area, and is taken after the protective coating was cut bqck to expose well maintained lines. The corrosion occurred where no protective coating was present. Both the left and right rear brake lines were found to be leaking. Luckily this was noticed in the driveway and did not result in a crash.

Vehicle Fire Summary – Arvada, CO On [XXX] at approximately [XXX], the Arvada Fire Department responded to a report of a vehicle fire on [XXX] . The vehicle involved was a 2013 gray Subaru Impreza WRX. The driver reported noticing smoke coming from the engine compartment before pulling over to the shoulder. Within minutes, flames became visible. Fire crews arrived promptly and extinguished the fire. Both the driver and one passenger were able to evacuate the vehicle safely, and no injuries were reported. The vehicle sustained a total loss due to fire damage. Preliminary findings suggest a possible mechanical or electrical malfunction, though the exact cause remains under investigation. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2013 Subaru Impreza. The contact stated that the key would become stuck in the ignition switch. The failure would occur intermittently however it was progressively worsening. The contact contacted the dealer who stated that the CVT parking brake switch needed to be replaced. The vehicle had not been repaired. The manufacturer was made aware of the failure and confirmed the extended warranty however they did not qualify due to the vehicle being a rebuilt vehicle. The approximate failure mileage was unknown.

The contact owns a 2013 Subaru Impreza. The contact stated while driving approximately 20-25 MPH, the brake pedal was depressed but hesitated to respond causing a 3-feet stopping distance delay. The contact also stated that the brake pedal was vibrating and would rest on the floorboard when depressed. The vehicle was taken to the dealer who diagnosed that the front brake rotors, brake pads, and calipers needed to be replaced. The contact stated that the vehicle was repaired however, the failure persisted. The vehicle was taken to an independent mechanic who diagnosed that no issues were found. The contact stated that the failure had been reoccurring while driving. The ABS warning light and the traction control warning light were illuminated. The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure mileage was 138,000.

On Friday July 23, 2021 my 1013 Subaru Impressa experienced a failure of the hydraulic braking system, exhibited by the brake warning light and loss of braking ability. Fortunately I was able to safely get to the Subaru dealer (Bath Subaru in Woolwich, Maine) where they determined that the problem was corrosion of the 4 way joint connector which is totally exposed (no cover or protective shield). This is a particular hazard on my car because both hydraulic braking circuits pass through through this connector. Currently the dealer is preparing and estimate for repair but I am concerned that this issue is a design defect and serious safety hazard that should have been subject to recall. I have since noted that a June 27, 2014 letter from Subaru to the NHTSA (Ref No.: GR14-042) identified this exact issue in many of the other Subaru models manufactured between 2005 and 2014. From my comparison of the descriptions and photos shown in the referenced letter, I believe that my car has the same identified defect and should also have been subject to this recall and the exclusion of my car from the original recall was an oversight. i am hopeful that Subaru will stand behind their product, provide a timely repair and provide assurance that the underlying cause has been corrected.

Slowing down to pull into a parking space when I put my foot on the brake to shift into park, the car lurched forward and accelerated over a parking barrier and into a brick wall. Unexplained acceleration. This was not driver error. I felt a few unexplained accelerations previously but thought it was a mistake on my end. In this instance, my foot was nowhere near the acceleration pedal. It was very very frightening. I am now waiting for the insurance adjusters. My car was damaged. I damaged the building and another car tat was parked inside the building. This is a significant safety issue. Consumer stated insurance provider stated it is a total loss and wants to take possession of the car.

Brake line is rusted at rear distribution block. We were driving the vehicle on a highway (~60mph). When the driver pressed the brake pedal, it did not respond and we had to pull the emergency brake. When the brake pedal is depressed, it takes much longer (and more pressure) to stop the vehicle than it did previously. We had it inspected by a mechanic who had the brake line at the rear distribution block is rusted out. The car is registered in Upstate NY where there is a lot of road salt. Our safety and the safety of the others was at risk because the brakes did not respond as expected making stopping time much longer. There were no warnings or symptoms prior to the problem.

CAR WAS PARKED DIRECTLY IN FRONT OF RESIDENTIAL GARAGE. I STARTED THE CAR TO PULL IT INTO THE GARAGE. AS SOON AS I PUT THE CAR IN DRIVE, WITH MY FOOT STILL ON THE BRAKE, IT SHOT FORWARD AT FULL SPEED AND CRASHED INTO A TRAILER AT THE BACK OF THE GARAGE. THE IMPACT FROM THE TRAILER BROKE A HOLE IN THE GARAGE WALL. TOTAL DISTANCE TRAVELED WAS ABOUT 25'.