2019 Subaru Forester

The TCV Thermostat Control Valve has failed which is a known issue and Subaru is very aware. The vehicle will ultimately believe it is overheating and shut itself down. This is a very well known incident and should be a proactive recall but instead subaru insists on waiting for customers to fail and hope its outside of warranty so they can charge them $2k to replace a known faulty design and part.

When I turn the car on it flashes check engine eyesite failure which then turns off the ability to use cruise control, crash detection, lane assist, ext. we called Dick Hannah Subaru and the code came up as P26A5 engine coolant bypass valve A position sensor. They said a thermo valve needs replaced and they’ve seen that happen a lot in 2019/2020 Subarus

RAB disabled, eye sight disabled, I drive disabled, check engine light came on. Car drives like it's is in sport mode with very touchy throttle. Pulled a code and it's the TCV. It's a known issue by Subaru with a part that has since been revamped but with thousands of vehicles on the road affected. Should be a recall. Contacted Subaru of America with no response so now a $1,900-$2,500 depending on dealer cost is being pushed on the consumer. Vehicle currently has 80,000 miles but as a Subaru ambassador I used to put a lot of miles on going to events, meets and typical camping and outdoors activities you expect out of these vehicles so my milage is slightly higher than the normal work commuter.

According to an inspection from the Subaru dealership, my thermo control valve failed. Because of this, the check engine light came on and my safety "eyesight" feature (automatic breaking/collision prevention system) was disabled. This first occurred after starting my car after a visit to a park 2 miles away. When this occurred, I drove my car home and parked it until I could get it in to be inspected at the Subaru dealership who pinpointed the problem. Besides a quick check from AutoZone, this is the only representative that has inspective my vehicle.

Multiple incidences approximately 8 since 2022. Stopped for 8 months with new battery. No issues are recorded in the computer in any of the troubleshooting visits. Normal Sequenced of events: Stopped at a stop light, Start/Stop engages, take foot off brake, start providing gas, car stalls, dashboard lights up, alarms, provides instructions to place the car into park and restart, and the car restarts after that is performed. Danger situations that this has caused: Aggressive car behind not paying attention to the stall and Green light with no one behind and car coming up behind quickly while you are attempting to restart the car. As this cannot be disabled without modification to the car this created a dangerous situation.

Driving home for 15 minutes. parked on left turn lane, slight incline. when traffic light turned green, i stepped on the gas and the engine stalled. I remember seeing "eyesight disabled" warning light come on. I put vehicle in park, shut it off, and turned engine back on. I was able to drive home. possible system failure - fuel system, auto/stop feature? yes, available to inspect safety - 5:30pm heavy traffic on 4 lane highway0. blocked traffic turning left. no where to pull over. have not taken vehicle to mechanic or been inspected. I saw no warning lights prior to vehicle stalling, or experienced any engine anomalies.

The auto start/stop occasionally malfunctions where the auto stop turns on as expected but then doesn't turn off when you try to use the accelerator. It has happened when a red light turns green the car stalls, displays an error message and you have to restart the car to get moving again. This recently happened to me at a very busy intersection and was very dangerous.

I was driving my 2019 Subaru Forester on 5/16 and it was operating normally that morning with no visible warning lights. I got back into the car later and it started fine. While getting onto a local highway, accelerating to highway speeds, multiple warning lights including the check engine light turned on. I was subsequently unable to accelerate and needed to coast to a stop on the closest off ramp, fortunately avoiding an accident. After turning the vehicle off and back on again the check engine light was still illuminated and the car would only make short lurching movements. I needed to have the car towed to a local Subaru dealership (Maita Subaru in Sacramento, CA) and they diagnosed it as a problem with the engine's thermo control valve. This was replaced under warranty and the vehicle is now working normally. The dealership told me this is a known issue with 2019 Foresters and that they've repaired other vehicles under similar circumstances. Multiple other owners have detailed similar experiences on an online forum as well. There does not appear to be a recall but this is a serious safety issue.

* Eyesight disabled and Thermal Control Valve-P26A3 diagnostic code. Vehicle is available upon request. * Eyesight immediately disabled and maintaining that all safety features are disabled. Safety features that are relied upon, disengaged, and aborted for literally a Subaru known engine issue (TSB #09-80-21) - THAT IS SAFETY AT RISK to everyone that owns a Subaru with this issue. * 2 Independent services confirmed diagnostic- P26A3 *Subaru was requested to review when the vehicle was in for recall inspection. * No warning lamps, messages or any other symptoms of the problem prior to the failure. The warning lights and safety features disengaged all appeared at one time.