2019 Subaru Crosstrek

The contact owns a 2019 Subaru Crosstrek. The contact stated that while driving approximately 60 MPH, the vehicle lost power steering functionality, and the vehicle decelerated and lost drive power. The contact was able to coast to the side of the road, where the vehicle completely shut off and lost power. The vehicle was towed to the dealer and was diagnosed with battery failure. The battery was replaced; however, the following morning, while attempting to start the vehicle, there was no electrical power to the vehicle. The Hybrid System Check error message was displayed. The contact researched and found information related to NHTSA Campaign Number: 23V080000 (Electrical System). The contact stated that there was corrosion on the battery. The vehicle was returned to the dealer, and the contact was informed that the VIN was not included in the recall. The vehicle was not repaired. The manufacturer was informed of the failure and confirmed that the VIN was not included in the recall. The failure mileage was approximately 60,000.

The car started shaking and shuddering at 40 mph on a straight road and I had several losses of motive power, with sluggish acceleration of a busy road. All dashboard lights began to turn on. The Oil Temp light was flashing, indicating an powertrain issue. After slowly driving it to a Subaru dealership, I was told that the CVT needed to be replaced. This model year also had a loss of motive power when cylinder 4 short circuited (after full replacement due to a recall). These are two examples of loss of motive power at high speeds on a single vehicle which in my opinion constitute a severe safety issue

Subaru owners have reported experiencing premature parasitic battery drain in vehicles equipped with Starlink in-vehicle technology. The defect presents itself when the equipped data communications module (DCM) attempts to communicate with 3G cellular networks. As 3G networks within the U.S. are no longer functioning, the call will continuously fail even after the vehicle has been turned off, draining the battery and resulting in a no-start safety risk for drivers. According to those familiar with the issue, the only solution to the battery drain defect is to remove the DCM fuse, thus disabling vital safety features such as hands-free calling. This issue is happening to me specifically, as I have had to jump my car multiple times within a week long period if in a bad cell range area. I have brought this into the dealership multiple times, under warranty, and presented this to them. They refuse to fix, even though multiple online threads and lawsuits point to this issue being known.

The contact owns a 2019 Subaru Crosstrek. The contact stated that after starting the vehicle, there was an abnormal ringing sound coming from underneath the dashboard. The contact turned off and restarted the vehicle, but the ringing sound persisted. After the contact connected the Bluetooth, the ringing stopped. The vehicle was not taken to the dealer. The vehicle was not diagnosed or repaired. The manufacturer was not informed of the failure. The failure mileage was 49,158.

Vehicle had a parasitic draw, was in the shop for an extended amount of time, I believe wiring issues were caused from this as well, I had to replace my driver side window switch, buy an optima battery, and drive 3.5hrs to a Subaru dealership in the middle of the winter hoping I’d make it safely and without stalling, the DCM was found to be at fault similarly to other vehicle owners included in another recall that somehow excluded 2019 Crosstrek drivers and included other MY variants such as the Outback and Forester of which also had a bulletin posted about this parasitic draw and how to go about warrantying the costs associated with the repair. I incurred many costs travelling, horrible gas mileage during this time, and a battery replacement. Additionally I lost My workstudy position the following semester due to the unstable vehicle issues and attendance concerns when shuttling the car to the dealer for these warranty repairs (if even covered at all)

. I expect a full recall on this model years and relative MY vehicles with this specific engine due to its obsolescence in the subsequent years. I feel as if I was sold a lemon and defective engine that will eventually become a death trap Dear Bloomington Subaru Service Manager, I want to reiterate that this is not an isolated incident limited to your facility. Over the course of this vehicle’s history, I have visited more than five different Subaru dealerships — including White Bear Luther Subaru, Miller Hill Subaru, Walser Subaru, Morrie’s Minnetonka Subaru, and your own Luther Bloomington Subaru — for recurring ECM and engine-related concerns. Despite multiple ignition coil replacements, repeated ECM flashes/reprogramming, and assurances that the most recent updates would permanently resolve the issue, my Crosstrek continues to suffer from clunking, rattling, difficulties accelerating, rough idling, and even complete stalling when idling or in hot temperatures. At my most recent visit to Bloomington Subaru, the ECM was not loaded with the current software, ECM C1424 and C1422 and Diag Trouble Code P0011 code. There are 5-7 Subaru bulletins about ECM and these codes. I had this b4 2yrs ago yet the dealership won’t assist with repairs or costs associated with this defective oil control valve part as well as the defective design in the ECM / ECU and this specific engine in the 2019 Crosstrek, of which is no longer produced or manufactured. The ECM or Oil control valve has since been “replaced” and swapped with other components in future generations of Subarus this is defective & mechanically related, not from wear and tear or personal useThere is a recall where the camshaft can break and the PCV too leading to complete catastrophic engine failure, which is a safety issue and expired, but despite 5 ECM flashes, 3/4 sets of ignition coils my vehicle still struggles with the same issues today, costing me $750 and months with my car in the shop, recall this engine

PCV problems and the dealership saying they fixed and completed this recall and have not done so and now CVT problems saying there’s no parts to fix it and have to re do the whole valve system Starter with thinking it was a wheel bar ring problem To trying to figure out if it was a pcv with the engine or cvt with the transmission These are major safety problem that should not be happening