2020 Subaru Ascent

In December 2025, I had brake replacement, tire service, and wheel alignment performed at Monro Auto Service located at [XXX] child were traveling on the highway during a winter storm when the brakes began making a loud banging noise. My wife was unable to immediately locate a service location and was forced to continue driving for an extended period in winter storm conditions while in fear for her safety and that of our child. When she was finally able to reach a second Monro location between [XXX] and [XXX] , a technician discovered that one brake caliper bolt was missing entirely and a second was dangerously loose. The vehicle had been driven at highway speeds in a winter storm with an improperly and incompletely assembled brake system for an extended distance before help was found. The second Monro location secured the caliper bolt and confirmed the vehicle safe to continue. The original Fairport location was contacted and their manager acknowledged the issue but has failed to provide any meaningful resolution after nearly four months. In a formal BBB complaint response, Monro Inc. confirmed that the caliper bolt had not been properly secured and acknowledged filing an insurance claim for resulting rim damage — an implicit admission of negligence. I am filing this complaint because an improperly assembled brake system — specifically a missing caliper bolt — represents a serious and potentially fatal safety hazard. If this is a pattern of negligence at Monro locations, other consumers may be at risk. BBB Complaint Case #XXX is on file documenting Monro's formal response and admission. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

My 2020 Subaru Ascent struggles to retain power when accelerating, especially from stopping and especially when the fuel is low. The vehicle stalls or loses some power when trying to accelerate. The check engine light is not on and there is no other indication that there is a problem with the vehicle. I have discussed it thoroughly with my mechanic and we both think it sounds like a fuel pump issue. He looked at the other Subaru recalls and thinks my vehicle should be included in the other Subaru fuel pump recall (NHTSA ID Number: 21V587000). Does my vehicle qualify for this fuel pump recall? Thank you.

Water intrusion occurred inside the vehicle, resulting in extensive mold contamination throughout the interior, including the seats, front and rear carpets, and a child’s car seat. The source of the water intrusion has not been identified. The vehicle was taken to an authorized Subaru retailer, which confirmed in writing that water was present inside the vehicle and that mold was covering interior surfaces, including the child’s car seat. The only diagnostic test performed was a car wash to check for a sunroof leak, which did not replicate the issue. The retailer indicated that further diagnostic work would require significant interior disassembly and cleaning at the owner’s expense before the source of the leak can be determined. The manufacturer was contacted regarding this issue and declined assistance, citing “lack of required maintenance.” The specific maintenance and its relationship to the water intrusion have not been identified, and the source of the leak has not yet been diagnosed. The retailer also stated that technicians would not enter the vehicle due to the extent of the mold contamination. As a result, standard recall repairs have not been performed while the vehicle remains in this condition. A dealership technician also documented in a recorded inspection that water was present beneath the carpet, that the source of the leak could not be identified without further disassembly, and that the extent of mold contamination created an unsafe working environment. This condition creates a potential health and safety concern due to mold exposure inside the passenger cabin, particularly for a child occupant. In addition, excessive interior moisture has caused window fogging, which may impair visibility while driving. No warning lights or prior indicators were observed before the issue was discovered. The problem has been confirmed by a Subaru retailer. The vehicle remains available for inspection.

I was driving and I got check engine light and all safety features disabled while I was in the freeway, luckily I was able to drive to nearby Subaru dealer for inspection and I found out that there was a recall on the engine for this vehicle and when I contacted the manufacturer they asked me to take it for diagnostics and I did that at a Subaru retailer, but the case manager told me that this recall is being completed for the previous owner of the vehicle and cannot help me with anything, which was never disclosed when I was buying the vehicle.

Vehicle: 2020 Subaru Ascent (Build Date: March 2020) Component: Power Train – Automatic Transmission – Hydraulic Pressure Sensor / Wiring Harness The vehicle developed a flashing "Transmission Service" warning and check engine light. It was inspected by a certified technician at Lithia Reno Subaru. Diagnostic scan identified multiple transmission-related codes including P0137, P0700, P2096, P1867, P0867, P2723, and P0841. The technician documented the root cause as: "Found pressure sensor leaking oil through all harnesses." According to the dealership diagnosis, the transmission hydraulic pressure sensor failed and allowed transmission fluid to migrate into the vehicle's electrical wiring harness system. Fluid traveled through the transmission harness and continued into the bulkhead and engine harnesses, contaminating multiple electrical systems. Due to the extent of contamination, the dealership determined that all three harnesses must be replaced. The repair estimate is approximately $8,933. Transmission fluid entering the wiring harness can disrupt communication between the transmission control system and other powertrain components. This electrical contamination can cause erratic transmission operation or sudden loss of propulsion while the vehicle is in motion, increasing crash risk. Subaru has issued recalls and service bulletins involving CVT transmission and hydraulic pressure sensor failures in earlier Ascent vehicles using the same drivetrain. My March 2020 vehicle appears to have experienced the same failure pattern. Despite the documented component failure and extensive wiring contamination, the manufacturer declined to fully cover the repair. I request that NHTSA review this failure mode to determine whether hydraulic pressure sensor seal failures allowing transmission fluid to migrate into wiring harness systems represent a broader defect affecting Subaru Ascent vehicles.

Oil Leak(s) (found cam carriers leaking, front timing cover leaking, oil cooler leaking, upper and lower oil pan leaking. recommend engine reseal). Massive oil leaks found in car due to RTV sealant. Subaru uses RTV silicone sealant (formed-in-place gaskets) instead of traditional rubber gaskets for many sealing surfaces (cam carriers to heads, timing cover, oil pans, etc.). Transmission failure at 37,000miles which needed replacement. In dealership service for 52 days at that time. Transmission symptoms continued after replacement. Car hesitates while accelerating making it dangerous to accelerate to speed needed to merge into traffic. Same transmission symptoms occurring now that were present prior to complete transmission failure in 11/2021 that left me in middle of busy freeway with a disabled car. Subaru not taking transmission symptoms seriously. Continuous brush off from service and Subaru. Car is a lemon. Subaru not standing by product. Oil should not be leaking from every orfice of engine.

I have had my lane assist come on by its self a few times, which is very dangerous because it seems to take over and will pull on the steering wheel. I’ve also brought my car back to the dealership a handful of times to have it hooked up to a computer and also someone ride with me because the car will either hesitate to accelerate or stutters and doesn’t seem to want to go when I am between 20-30 miles an hour. Other times when I’m at a light or stop sign it hesitates also. I was told there was nothing wrong with it and they reprogrammed to transmission but it didn’t help at all.

Although the NHTSA form does not include a transmission category, this complaint concerns a critical transmission-related defect in my 2020 Subaru Ascent, which caused oil migration into the wiring harness and contamination of the Engine Control Module (ECM). This complaint concerns a critical transmission-related defect in my 2020 Subaru Ascent. The vehicle has been inoperable since June 2025 due to a failure of the transmission secondary pressure sensor. This failure caused oil to migrate into the wiring harness and ultimately contaminated the Engine Control Module (ECM), rendering the vehicle undrivable. Authorized Subaru dealership Huberger Subaru in Colorado Springs documented the following: - Replacement of the transmission secondary pressure sensor - Replacement of the engine wiring harness - Check engine light returned after repair - Confirmed oil contamination of the ECM Despite repeated repairs and part replacements, the vehicle remains out of service for over seven months, with no confirmed timeline for resolution. Subaru of America has not provided meaningful updates or a clear repair plan, and corporate representatives have failed to respond to emails and phone calls. The extended downtime and lack of repair constitute a safety concern, as the vehicle could fail while in use under certain conditions. Additionally, $400 was improperly withdrawn from my account in July 2025 for rental reimbursement during the warranty repair period and has not been refunded. I am seeking prompt resolution, including repair or replacement of the vehicle, reimbursement for the rental charge, and any appropriate actions from Subaru to address this safety-related defect.