2020 Subaru Ascent

The contact owns a 2020 Subaru Ascent. The contact stated that while driving at an undisclosed speed, the vehicle was skipping. The failure was recurrent. The contact associated the failure with NHTSA Campaign Number: 21V955000 (Power Train); however, the dealer informed the contact that the recall repair was completed on July 15, 2025. The contact was the vehicle owner on that date and stated that the vehicle was never taken to the dealer for the recall repair. The dealer diagnosed the vehicle with CVT failure and advised that the vehicle was outside warranty coverage. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 145,000.

1. The vehicle is experiencing a transmission malfunction/failure. The dealership was able to replicate the issue and confirm the malfunction, which caused the check engine light to illuminate. The vehicle is currently being evaluated by the dealership, and any failed components should be available for inspection upon request while the vehicle remains in their possession. 2.The transmission malfunction is affecting the vehicle's ability to accelerate, maintain speed, and operate predictably. This creates a potential safety risk when the vehicle loses power or experiences unexpected changes in operation while driving, particularly in traffic or at highway speeds. The concern is heightened because transmission failure can leave the vehicle unable to safely continue operating and can cause collisions with other vehicles on the road. 3.Yes. The dealership was able to reproduce the issue, which caused the check engine light to illuminate and confirmed that there is an active problem requiring further diagnosis/repair. 4.The vehicle has been inspected and evaluated by the Subaru dealership/service center. To my knowledge, it has not been inspected by police or insurance representatives. Subaru of America has reviewed my case and the repair history but has declined assistance with the repair or to open a case. 5.Yes. The dealership was able to reproduce the issue, which caused the check engine light to illuminate. The transmission problem was also associated with operation that prompted me to have the vehicle inspected. The check engine light illuminated when the dealership replicated the condition. This current transmission is a replacement transmission done by Subaru do to a previous recall of the same issue. The current transmission only has 83,000 miles on it.

The Transmission is slipping on my 2020 Ascent. I had the recall wrk-21 performed in July of 2025. Over the last 6 months the car has been hesitant to go at low speeds and shakes at high speeds. Over the last month the transmission started to slip while accelerating , especially up hill. There would be a grinding noise and RPMs would jump. I took it to the dealer and they confirmed it was the transmission via camera test. I called Subaru of America for goodwill help with the cost knowing that there is a know issue with the transmission. They refused due to the mileage, 121,010. •What component or system failed or malfunctioned, and is it available for inspection upon request? The transmission is slipping •How was your safety or the safety of others put at risk? The car is hesitant to go from a starting position. The car will jerk back and forth when trying accelerate when merging or crossing a road. I am also very concerned of catastrophic failure at high speeds. •Has the problem been reproduced or confirmed by a dealer or independent service center? The dealer has confirmed the transmission is bad via camera teat. •Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? Just the dealership •Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? No dash lights just the feeling and sounds.

The pressure sensor coming out of the transmission has failed, and it's pushed transmission fluid throughout the engine harness, transmission harness, the bull harness in the dash and the 02 sensors. All of those have been damaged. The car is now unsafe to drive due to the pressure sensor failing. This information comes directly from the Subaru dealership. There was nothing prior to this that indicated there was a problem. I bought the car from a certified dealership 8 months ago and it was a certified pre owned vehicle.

The contact owns a 2020 Subaru Ascent. The contact stated that while driving on several occasions at various speeds, the steering wheel became loose and then tightened inadvertently. The vehicle was taken to a dealer where the failure could not be replicated. The contact also stated that on several occasions while driving, the vehicle puttered and a grinding noise was heard emanating from the engine compartment. The vehicle was towed to a dealer where it was diagnosed during the first visit to be the transmission module. The vehicle was repaired, but the failure persisted sporadically. The vehicle was taken back to the same dealer on the second visit where it was diagnosed that the transmission needed to be replaced. The vehicle was repaired, but the failures reoccurred approximately 5,000 miles later. The vehicle was taken to the same dealer on the third visit where it was diagnosed that the tie rod end and bushing needed to be replaced. The vehicle was repaired, but the failure persisted. The vehicle was then taken to the same dealer on the fourth visit where the failure could not be replicated. The vehicle towed to the same dealer on a fifth occasion where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired as of yet. The manufacturer was notified of the failure and a complaint was filed. The failure mileage was approximately 82,000.

My 2020 Subaru Ascent struggles to retain power when accelerating, especially from stopping and especially when the fuel is low. The vehicle stalls or loses some power when trying to accelerate. The check engine light is not on and there is no other indication that there is a problem with the vehicle. I have discussed it thoroughly with my mechanic and we both think it sounds like a fuel pump issue. He looked at the other Subaru recalls and thinks my vehicle should be included in the other Subaru fuel pump recall (NHTSA ID Number: 21V587000). Does my vehicle qualify for this fuel pump recall? Thank you.

Vehicle: 2020 Subaru Ascent (Build Date: March 2020) Component: Power Train – Automatic Transmission – Hydraulic Pressure Sensor / Wiring Harness The vehicle developed a flashing "Transmission Service" warning and check engine light. It was inspected by a certified technician at Lithia Reno Subaru. Diagnostic scan identified multiple transmission-related codes including P0137, P0700, P2096, P1867, P0867, P2723, and P0841. The technician documented the root cause as: "Found pressure sensor leaking oil through all harnesses." According to the dealership diagnosis, the transmission hydraulic pressure sensor failed and allowed transmission fluid to migrate into the vehicle's electrical wiring harness system. Fluid traveled through the transmission harness and continued into the bulkhead and engine harnesses, contaminating multiple electrical systems. Due to the extent of contamination, the dealership determined that all three harnesses must be replaced. The repair estimate is approximately $8,933. Transmission fluid entering the wiring harness can disrupt communication between the transmission control system and other powertrain components. This electrical contamination can cause erratic transmission operation or sudden loss of propulsion while the vehicle is in motion, increasing crash risk. Subaru has issued recalls and service bulletins involving CVT transmission and hydraulic pressure sensor failures in earlier Ascent vehicles using the same drivetrain. My March 2020 vehicle appears to have experienced the same failure pattern. Despite the documented component failure and extensive wiring contamination, the manufacturer declined to fully cover the repair. I request that NHTSA review this failure mode to determine whether hydraulic pressure sensor seal failures allowing transmission fluid to migrate into wiring harness systems represent a broader defect affecting Subaru Ascent vehicles.

Oil Leak(s) (found cam carriers leaking, front timing cover leaking, oil cooler leaking, upper and lower oil pan leaking. recommend engine reseal). Massive oil leaks found in car due to RTV sealant. Subaru uses RTV silicone sealant (formed-in-place gaskets) instead of traditional rubber gaskets for many sealing surfaces (cam carriers to heads, timing cover, oil pans, etc.). Transmission failure at 37,000miles which needed replacement. In dealership service for 52 days at that time. Transmission symptoms continued after replacement. Car hesitates while accelerating making it dangerous to accelerate to speed needed to merge into traffic. Same transmission symptoms occurring now that were present prior to complete transmission failure in 11/2021 that left me in middle of busy freeway with a disabled car. Subaru not taking transmission symptoms seriously. Continuous brush off from service and Subaru. Car is a lemon. Subaru not standing by product. Oil should not be leaking from every orfice of engine.

I have had my lane assist come on by its self a few times, which is very dangerous because it seems to take over and will pull on the steering wheel. I’ve also brought my car back to the dealership a handful of times to have it hooked up to a computer and also someone ride with me because the car will either hesitate to accelerate or stutters and doesn’t seem to want to go when I am between 20-30 miles an hour. Other times when I’m at a light or stop sign it hesitates also. I was told there was nothing wrong with it and they reprogrammed to transmission but it didn’t help at all.