2025 RAM 3500

While driving my truck under normal conditions and using the turn signals as expected, I noticed an issue after parking in my driveway. The turn signals began activating automatically without any driver input, alternating from left to right approximately every 5 seconds. The behavior stopped once I manually engaged the turn signal lever. My truck is one year old - Video Link [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2025 Ram 3500. The contact received notification of NHTSA Campaign Number: 25V826000 (ELECTRICAL SYSTEM); and the vehicle was taken to the dealer, where the instrument panel software update was completed; however, the instrument panel became inoperable after the update was completed. The dealer determined that the instrument panel needed to be replaced; however, the part to do the recall repair was not yet available. The dealer informed the contact that the estimated time for availability was May 11, 2026. The vehicle was not yet repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The failure mileage was unavailable.

The contact owns a 2025 Ram 3500. The contact received a recall notification of NHTSA Campaign Number: 26V059000 (Exterior Lighting, Electrical System); however, when the local dealer was contacted, the contact was informed that the manufacturer was shipping a very limited number of parts to dealers for the repair. The manufacturer was contacted, and the contact was informed that the dealer should request an expedited shipment. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was not repaired. The contact had not experienced a failure.

The contact owns a 2025 Ram 3500. The contact received notification of NHTSA Campaign Number: 26V059000 (EXTERIOR LIGHTING, ELECTRICAL SYSTEM). The contact noticed the failure on the drive back after the vehicle was purchased. The contact stated that on a separate occasion, while driving at an undisclosed speed, the brake lights and turn signals failed to function as intended. The contact lived in a rural area and stated that at night it is dark, and the brake lights nor the turn signals were operable. The contact felt that the vehicle was unsafe to drive. The local dealer was contacted, and the contact was informed that the parts for the recall repair were available. However, the parts were allocated to unsold vehicles first, and there was no estimated time for the recall part to be available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue and confirmed with the dealer about the part not being available. The contact was informed that the recall part was blocked from manual ordering. The failure mileage was approximately 500.

While driving down the street between 0 and 35 mph, with no load in the truck and no trailer attached, the trailer brake controller quite working completely and a service message appeared. The dealership ended up replacing the trailer brake gain adjustment switch. Had I been towing a trailer at the time, I would have had zero trailer brakes. I've had this message reappear several times since then. I've attached a picture showing both the message on the gauge cluster as well as a scan of the trouble codes at that time.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.

The 2025 and 2026 dually 3500 Ram trucks with the 12" AAM rear axle are having issues with the rear wheel speed sensors (different sensor for each side). They apparently fail or are not able to properly communicate to the computer. When this happens, the following are disabled: -ABS -Auto Emergency Braking -4x4 -Electronic Stability Control -Cruise Sometimes, the engine won't shut off. The gauge cluster will state it can't detect which position the transmission is in. So, you cannot shift, and you can't shut the truck off, and you can't drive. You are stuck in place with a running engine. Despite Stellantis releasing a new revision of wheel speed sensors (AB revision), they have failed in less than 2,000 miles on my truck. Many, many dually owners are experiencing these failures. I've had this problem occur over half a dozen times. It has been to the dealership to be repaired 3 times so far. After the 2nd time at the dealership, the sensors only last less than 23 miles.