2020 RAM 1500

Vehicle experiences intermittent but repeatable safety-related electrical failures affecting turn signals and blind spot monitoring. The left turn signal remains engaged after canceling and does not shut off unless the opposite turn signal is activated, causing incorrect signaling to other drivers. This occurs without driver input. At the same time, the Blind Spot Monitoring system intermittently displays a “Blind Spot System Unavailable” warning and disables the safety feature while driving, increasing the risk of unsafe lane changes. Vehicle was inspected and diagnosed by an authorized Ram/Stellantis dealer. Dealer verified the concern and documented fault code B2225-00 – Steering Column Module Internal Failure, confirming the steering column control module is malfunctioning internally and not posting correct left/right turn signal inputs. Wiring, grounds, power, and CAN bus communication were inspected and ruled out. Dealer also documented fault code B285F-15 – Blind Spot Warning Light Control Circuit Short to Battery/Open, tracing the blind spot failure to a shorted passenger-side mirror harness, confirmed through load testing and a wiggle test. No aftermarket electrical modifications are present. These failures affect federally required signaling and driver-assist safety systems and occur intermittently, making them unpredictable and hazardous. Vehicle has approximately 48,877 miles and is a 2020 Ram 1500. Concern is ongoing and unresolved without replacement of safety-critical components.

The generator bearings are making a wining noise. It was confirmed by an experienced independent mechanic that the E-torque generator needs replacement. The dealer said the generator is not in stock. Further research showed the part is on back order for months, with thousands of others waiting and in the same boat of no parts available.

I own a 2020 Ram 1500 with approximately 61,000 miles. I started noticing a clicking/grinding around the motor area at around 59,000 miles. I brought the truck to a local mechanic, who diagnosed it as a possible alternator issue. He suggested bringing it to RAM service because it may be covered under warranty. I followed up by bringing it to RAM to diagnose the issue. After multiple visits, they could not pinpoint the issue, however recommended replacing the belts and adjusters. Over the course of the next month, the clicking/grinding got louder. I made another appointment with RAM, and while I was on my way over there the truck had catastrophic failure and seized all operations. Thankfully I wasn't going more then 20MPH or else something really bad could have happened. At that time, the truck was reading code U0594, which translates to "Invalid Data Received From Hybrid/EV Powertrain Control Module". I had to get the truck towed to RAM, where they have now had it for about one month. Originally they had said that I would need to buy a new alternator and associated belts/adjustors and battery because i was beyond any standard warranties on the truck, with estimates over what the vehicle is worth, however some personal research found that there is a federal emissions warranty that covers an issue like this. I was fortunate enough to get a loaner car from the dealer two weeks after my truck seized up. I have read online that this is becoming a more common issue with these trucks and feel the manufacturer should raise a warning to their consumers. Had I been on the highway when this happened, who knows where I could be.

On [XXX] driving from Joplin MO to McQueeney Tx on [XXX] at approximately [XXX] voltage dropped to 10.3 in Waco TX. I was to get to safe area. Vehicle lost steering, low braking and dim lights. Purchase a new battery from local Wamart. Vehicle started, working good, upon entering San Marcus, Tx low voltage again 10.0 volts. Had to get off hwy and pulled into gas station. Vehicle completely dead. Has it towed McQueeney tx . Contacted dealer next day engine generator kit unavailable. Contacted Mopar, order part on 9/16/2025. Still to dated no updated from Mopar. When engine generator shut down you have no steering control and very low braking power. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I had just started my vehicle and drove about 3 blocks and was running 40 miles per hour when the truck sounded like it was revving up and it went into neutral and slowed down. I was able to pull to the side of the road and put the truck into park. I put it back into drive and drove back home. It was scary because I had small children with me and it happened at an intersection.

This engine has failed by the head gaskets, literally all 4, cracking/breaking. This caused coolant to leak into the engine, mix with the oil, depleating the coolant, thereby causing the truck to overheat and break down. With repairs this continues to happen. 3 times to be exact! This cannot be normal for this engine especially when this happened with less than 90K miles on the engine.

To Whom It May Concern, I am submitting this email to document a vehicle safety issue involving my 2020 Ram 1500 (5.7L eTorque). In November 2025, the vehicle experienced a failure of the eTorque motorized alternator / belt starter generator system, resulting in a loss of the electrical and charging system. As a result, the vehicle became non-drivable. The vehicle was delivered to an authorized Ram dealership on November 18, 2025, and has remained there continuously. The manufacturer (MOPAR / Stellantis) has confirmed the failure is warranty-covered, but has advised that the required part is on indefinite backorder with no firm ETA. As of the date of this email, the vehicle has been out of service for over 60 days and cannot be safely operated. This issue appears to be widely reported nationwide (I was told by Landers Dodge in Norman, OK that the part is on backorder, and that there are currently 4,678 on Back Order. They also said that they’ve had a RAM there since last Oct. 2025 (this was on 12/12/2025 at 12pm) among vehicles equipped with the eTorque system, indicating a potential systemic defect affecting vehicle operability and safety. I am submitting this email in addition to my formal NHTSA complaint to ensure the issue is fully documented. Thank you for your attention. Sincerely, [XXX] 2020 Ram 1500 VIN: [XXX] Mileage: 79K INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

When fueling, gas pump kicks off due to pressure build up inside of tank/filler neck. Gas has spilled out on vehicle from filler neck when this has happened. Have to constantly hold gas nozzle in a very slow trickle to be able to fuel truck. Sensor is not serviceable due to being inside gas tank. Has been an ongoing issue since first starting with no remedy from dealerships.

On Thursday, January 8, 2026, I was operating my vehicle when an oncoming single vehicle traveling in the opposite direction entered a curve at an excessive speed, lost control, and crossed into my lane. I attempted to steer away to avoid the collision; however, the oncoming vehicle struck my vehicle along the driver’s side. The collision caused significant damage to the driver's side and resulted in a failure of the passenger-side rear wheel/tire assembly, complete detachment of the tire from the vehicle. During the collision, none of my vehicle’s airbags deployed, despite the side-impact nature of the crash and the force of the collision. 1. What component or system failed or malfunctioned, and is it available for inspection upon request? The airbag restraint system failed to deploy during a significant collision involving the driver. The vehicle and airbag system remain intact and are available for inspection upon request. 2. How was your safety or the safety of others put at risk? The lack of airbag deployment during a driver-side impact increased the risk of injury to me as the vehicle operator. Airbags are designed to provide supplemental protection in collisions of this type, and the absence of deployment reduced occupant protection. 3. Has the problem been reproduced or confirmed by a dealer or independent service center? No diagnostic inspection or reproduction testing has yet been performed. Evaluation by a dealer or manufacturer representative is pending. 4. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives, or others? Police responded to the accident scene. The incident has been reported to insurance representatives. Manufacturer inspection has not yet occurred, but the vehicle remains available for review. 5. Were there any warning lamps, messages, or other symptoms prior to the failure, and when did they first appear? No warning lights, dashboard messages, or other symptoms related to the airbag