IllustrationELECTRICAL PROBLEM, CAUSING VEHICLE TO STALL.
1992 Pontiac Grand Am
Owner reports · Recalls · Investigations
More warning signs than most Grand Am years
Owner complaints for the 1992 Pontiac Grand Am are substantially higher than the model-year median of 82.
About this comparison →How this year compares
Owner complaints by model year
Compare all Grand Am years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 5 of 168 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 62 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 33 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 28 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
12 crash reports4 fire reports8 injury reports
What owners actually said
168 reportsDESIGN OF THE ALTERNATOR/ELECTRICAL SYSTEM ALLOWS FOR DAMAGE OF OTHER COMPONENTS WHEN THE ALTERNATOR FAILS (DRAINING BATTERY AND DESTROYING ECM COMPUTER AND IGNITION MODULE).
WHEN USING HEATER AND DEFROSTER ALONG WITH OTHER COMPONENTS ELECTRICAL SYSTEM SHUT DOWN, RESULTING IN SHUT DOWN OF VEHICLE POWER. *AK
MECHANISM IN THE TILT STEERING WHEEL IS BROKEN, CAUSING THE STEERING NOT TO STAY IN POSTION WHICH COULD RESULT IN LOSS OF VEHICLE CONTROL. PLEASE GIVE FURTHER DETAILS. *AK
AUTO-TRANSMISSION; WHILE DRIVING ATTEMPTED TO PASS ANOTHER VEHICLE, (4 LANE HWY) VEHICLE FAILED TO GO INTO PASSING GEAR, SUBSEQUENTLY WENT INTO PASSING GEAR, ACCELERATOR STUCK, ENGINE ACCELERATED FROM 60 TO 90 MPH, LOW TRAFFIC, NO ACCIDENT. *AK
REAR WHEEL BEARINGS FAILED.
WHEN DRIVING THE VEHICLE STALLS/HESITATES/STUMBLES. *AK
WHILE DRIVING VEHICLE TRIED TO APPLY THE BRAKES (ABS), VEHICLE DID NOT SLOW UP, TURNED VEHICLE INTO A PARKING LOT, TRYING TO BRAKE STEERING WENT, LOST CONTROL OF VEHICLE, NO BRAKES, HIT POLE; DRIVER HAD SEAT BELT ON, ALSO REPLACED PITTED ROTORS. *AK
BODY RUST.
REAR BRAKES FAILED AFTER MAJOR WORK WA SDONE ON VEHICLE. *AK
Official recalls
392V106000 · Fuel System, Gasoline:storage:tank Assembly:filler Pipe And Cap
Jul 17, 1992
THE VEHICLES WERE ASSEMBLED WITH AN INCORRECT SUSPENSION UPPER SPRING SEAT AT THE RIGHT-REAR POSITION. IF THE VEHICLE IS INVOLVED IN A REAR IMPACT ACCIDENT, THE RIGHT-HAND REAR WHEEL HOUSE FLANGE COULD SEVER THE FUEL TANK FILLER PIPE AND SPILL FUEL.
Consequence & remedy
Consequence: THESE VEHICLES ARE NOT IN COMPLIANCE WITH FMVSS 301,FUEL SYSTEM INTEGRITY. SPILLED FUEL IN A LOW SPEED ACCIDENT CAN RESULT IN AFIRE.
Remedy: INSPECT AND REPLACE INCORRECT UPPER SPRING SEAT WITH THE CORRECT PART.
91V204000 · Suspension:rear
Nov 19, 1991
THE BOLTS AND NUTS WHICH ATTACH THE BEARING-HUB ASSEMBLY TO THE REAR AXLE FLANGE ARE NOT SUFFICIENTLY TIGHTENED ON SOME VEHICLES.
Consequence & remedy
Consequence: THIS WOULD ALLOW EXCESSIVE MOVEMENT OF THE BEARING-HUBASSEMBLY RELATIVE TO THE REAR AXLE FLANGE AND COULD CAUSE ELONGATION ANDEVENTUAL SEPARATION OF THE ATTACHING BOLTS FROM THE REAR AXLE FLANGE. IF THISWERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE AFFECTED TIRE AND WHEEL COULDTRACK ERRATICALLY, EVENTUALLY CAUSING FAILURE OF THE OTHER ATTACHING BOLTS. THETIRE AND WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN AVEHICLE ACCIDENT.
Remedy: TIGHTEN REAR AXLE BEARING-HUB ASSEMBLY FASTENERS, AND REPLACE ALL THE FASTENERS ON A WHEEL IF TWO OR MORE BOLTS ARE FOUND TO BE LOOSE.
91V182000 · Seats:front Assembly:recliner
Oct 21, 1991
THE PASSENGER'S SIDE EASY-ENTRY SEAT ADJUSTER MAY FAIL FULLY LOCK INTO POSITION AFTER THE SEAT BACK HAS BEEN TILTED FORWARD AND THE SEAT SLID FORWARD, THEN RETURNED TO ITS ORIGINAL POSTITION.
Consequence & remedy
Consequence: IF THE SEAT ADJUSTER FAILS TO LOCK INTO POSITION, THEPASSENGER SEAT WOULD SLIDE FORWARD IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.OCCUPANTS OF THE PASSENGER SEAT WOULD FACE INCREASED RISK OF SERIOUS INJURY.
Remedy: REPLACE THE ADJUSTER ASSEMBLY ON THE SEAT.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.