OUTER REAR SEAT BELTS DO NOT WORK PROPERLY. THERE IS STITCHING IN THE SEAT BELT THAT DOES NOT ALLOW THE CLASP TO MOVE FREELY. THE CLASP GETS STUCK BELOW THE STITCHING AND IT GETS STUCK ABOVE THE STITCHING. I CHILD CANNOT WORK THE SEAT BELT PROPERLY. ONCE THE CLASP IS BELOW THE STITCHING WILL IT WORK PROPERLY IN AN ACCIDENT? …
Read full complaint
OUTER REAR SEAT BELTS DO NOT WORK PROPERLY. THERE IS STITCHING IN THE SEAT BELT THAT DOES NOT ALLOW THE CLASP TO MOVE FREELY. THE CLASP GETS STUCK BELOW THE STITCHING AND IT GETS STUCK ABOVE THE STITCHING. I CHILD CANNOT WORK THE SEAT BELT PROPERLY. ONCE THE CLASP IS BELOW THE STITCHING WILL IT WORK PROPERLY IN AN ACCIDENT? *NM
NHTSA ODI #10146225
340 miles · Nov 15, 2004
Seat Belts
FRONT DRIVER'S SIDE SEAT BELT FAILED TO STAY FASTENED. THE BELT PLATE POPPED BACK OUT OF THE BUCKLE WHEN FASTENED. THERE WASN'T ANYTHING JAMMED IN THE BUCKLE. DEALER WILL BE CONTACTED. *AK
ON CERTAIN MINI VANS EQUIPPED WITH A FOLDING THIRD ROW REAR SEAT, WHEN THE THIRD ROW SEAT IS RAISED FROM ITS STOWED POSITION, IT ENGAGES STRIKER BRACKETS, ONE ON EACH SIDE OF THE SEAT CUSHION. THE FOLD-AWAY STRIKER LOOP IS WELDED TO A MOUNTING BRACKET. THE STRIKER MAY BECOME DETACHED FROM ITS MOUNTING BRACKET DUE TO A BROKEN WELD AT THE POINT OF ATTACHMENT TO THE BRACKET.
Consequence & remedy
Consequence: IF THE THIRD ROW SEAT STRIKER WELD FAILS, THE STRIKER COULD SEPARATE FROM THE MOUNTING BRACKET. STRIKER SEPARATION COULD AFFECT THE RISK OF INJURY IN CERTAIN TYPES OF CRASHES.
Remedy: DEALERS WILL REPLACE THE THIRD ROW SEAT STRIKER BRACKETS FREE OF CHARGE. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
ON CERTAIN MINI VANS, THERE IS A SEAT ADJUSTMENT MECHANISM THAT CONTAINS EXPOSED MOVING COMPONENTS LOCATED AT THE REAR INSIDE EDGE OF THE SECOND ROW SEAT.
Consequence & remedy
Consequence: WHEN THE OPERATOR ATTEMPTS SEAT ADJUSTMENT, A FINGER MAY BE PINCHED IN THE MOVING SEAT ADJUSTMENT MECHANISM WHICH COULD CAUSE AN INJURY.
Remedy: ON EARLIER MODEL VEHICLES BUILT THROUGH JUNE 28, 2004, DEALERS WILL REPLACE THE INBOARD SECOND ROW SEAT ADJUSTMENT HANDLE, RIVET A PLASTIC REINFORCEMENT TO BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE TO THE INBOARD SIDE SHIELD. ON VEHICLES PRODUCED FROM JUNE 29, 2004 THROUGH SEPTEMBER 26, 2005, DEALERS WILL RIVET A PLASTIC REINFORCEMENT TO THE BACKSIDE OF THE EXISTING SEAT BACK COVER CARPETING, INSTALL TIE-DOWNS AND A FLANGE ON THE INBOARD SIDE SHIELD. THE RECALL BEGAN ON DECEMBER 19, 2005. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1
PE08004 · Side Air Bag NON-DEPLOYMENT
Opened Jan 25, 2008 · Closed May 30, 2008
Status: closed (inferred from source dates) · Air Bags:side/window
THE SUBJECT VEHICLES ARE EQUIPPED WITH OPTIONAL SEAT-MOUNTED SIDE AIR BAGS.ALL VEHICLES ARE EQUIPPED WITH STANDARD FRONTAL AIR BAGS AND SIDE AIR CURTAINS.INSTALLATION OF THE INCORRECT SRS DIAGNOSIS SENSOR UNIT DOES NOT IMPAIR DEPLOYMENT OF THE FRONTAL AIR BAG AND SIDE AIR CURTAIN IN THE EVENT OF A CRASH.NO REPORTS OF NON-DEPLOYMENT OF THE SUBJECT SEAT-MOUNTED SIDE AIR BAGS HAVE BEEN RECEIVED BY THE MANUFACTURER OR BY NHTSA.THE WARRANTY REPORTS CITED ABOVE REPRESENT VEHICLE INSPECTIONS CONDUCTED UNDER THE SERVICE CAMPAIGN AND SENSOR REPLACEMENT WAS REQUIRED IN 32 OF THESE CASES.THE MANUFACTURER REPORTS A TOTAL OF 151 SENSOR UNITS SOLD AS REPLACEMENT PARTS FOR ALL PURPOSES.INVESTIGATION DISCLOSED A LOW INCIDENCE OF SENSOR REPLACEMENT REQUIRED UNDER THE SERVICE CAMPAIGN TO DATE.NO INCIDENTS OF REAL WORLD NON-DEPLOYMENT OF THE SUBJECT AIR BAGS WERE IDENTIFIED.THIS PRELIMINARY EVALUATION IS CLOSED.
2005 Nissan Quest Problems, Complaints & Recalls | Skip That Year
Illustration