2004 Nissan Altima

TL*THE CONTACT OWNS A 2004 NISSAN ALTIMA. THE CONTACT TOOK HER VEHICLE IN FOR EMISSION TESTING; HOWEVER, IT FAILED BECAUSE THE ENGINE WARNING AND CRANK ANGLE SENSOR LIGHTS ILLUMINATED ON THE INSTRUMENT CONTROL PANEL. SHE THEN RECEIVED A NOTICE FOR NHTSA CAMPAIGN ID NUMBER 06V242000 (ENGINE AND ENGINE COOLING); HOWEVER, THE MANUFACTURER INFORMED HER THAT SHE RECEIVED THE NOTICE IN ERROR. ALTHOUGH HER VIN WAS SPECIFIED IN THE RECALL LETTER, THE CONTACT WOULD BE RESPONSIBLE FOR THE REPAIR. SHE HAS A COPY OF THE NOTICE AND ALL OTHER DOCUMENTS PERTAINING TO THE FAILURE. THE POWERTRAIN WAS UNKNOWN. THE FAILURE AND CURRENT MILEAGES WERE 53,000.

TL*THE CONTACT OWNS A 2004 NISSAN ALTIMA. WHILE DRIVING APPROXIMATELY 60 MPH, THE ENGINE LIGHT ILLUMINATED. THE CONTACT TOOK HER VEHICLE TO A MECHANIC SHOP AND A DIAGNOSTIC WAS PERFORMED. SHE WAS INFORMED THAT THE CAMSHAFT SENSOR NEEDED TO BE REPLACED. THE MECHANIC ALSO STATED THAT THERE WAS A RECALL ON THE DEFECT, BUT HER VIN WAS NOT INCLUDED. THE CONTACT STATED THAT HER VEHICLE WOULD STALL WHILE DRIVING AND SHOULD BE INCLUDED IN THE RECALL. THE VEHICLE HAS NOT YET BEEN REPAIRED. THE RECALL NUMBER WAS UNKNOWN. THE FAILURE AND CURRENT MILEAGES WERE 84,000.

TL*THE CONTACT OWNS A 2004 NISSAN ALTIMA. WHILE DRIVING 35 MPH, THE CHECK ENGINE LIGHT ILLUMINATED THREE DIFFERENT TIMES. THE VEHICLE WAS TAKEN TO THE DEALER AND THEY STATED THAT THE CRANKSHAFT AND CAMSHAFT SENSORS NEEDED TO BE REPLACED. THE DEALER REPLACED THE SENSORS. ON MARCH 14, 2008, THE CHECK ENGINE SOON LIGHT ILLUMINATED AGAIN. THE DEALER STATED THAT THERE WAS EXHAUST FAILURE. NHTSA CAMPAIGN ID NUMBER 06V242000 (ENGINE AND ENGINE COOLING) WAS REFERENCED. THE VIN, ENGINE SIZE, PURCHASE DATE, AND POWERTRAIN WERE UNKNOWN. THE CURRENT AND FAILURE MILEAGES WERE 67,000.

CAR SHUT DOWN WHILE DRIVING. THERE WAS A RECALL TO RESET THE ECM THAT WAS CAUSING THIS PROBLEM. I WAS UNAWARE OF THIS RECALL BUT NOW LEARN THAT IF I HAD BROUGHT MY CAR IN TO HAVE THE SYSTEM RESET I WOULD NOT HAVE BEEN OUT ANY MONEY. BUT NOW THAT THE PROBLEM HAS ARISEN AND THE CAR SHUT DOWN ON ME, THIS CAUSED THE "CHECK ENGINE LIGHT" TO COME ON. NOW I MUST PAY TO HAVE THE SENSOR REPLACED NOT JUST RESET. *TR

I RECEIVED A RECALL NOTICE REGARDING THE CRANK ANGLE SENSOR THAT WAS DEFECTIVE. I HAD PREVIOUSLY HAD THE VEHICLE REPAIRED AT NISSAN AND PAID $284.60 FOR THE REPAIR. I CONTACTED NISSAN AND FAXED THE REQUESTED DOCUMENTATION TO THE MANUFACTURER. AFTER 3 FAXES, 2 DEALERSHIP REPAIR DOCUMENTATION AND NUMEROUS HOURS SPENT WITH INDIA NISSAN CUSTOMER SERVICE I HAVE NOT RECEIVED A REFUND FROM NISSAN AS PROMISED BY SEVERAL REPRESENTATIVES AND MANAGERS. *TR

2004 NISSAN ALTIMA 2.5 SHUTS OFF ON ME WHILE I'M DRIVING OR PARKED AT A STOP LIGHT. I HAD THE CAR TAKEN LAST YEAR FOR A ECM REPROGRAM RECALL LAST YEAR. NOW I'VE HEARD THAT CERTAIN YEARS MODELS ARE HAVING THE SAME PROBLEM 2005, 2006, POSSIBLY A CRANKSHAFT SENSOR. I SEARCHED FOR A RECALL FOR MY PARTICULAR CAR AND I HAVE NOT FIND ONE. ANY SUGGESTIONS? *TR

I WAS DRIVING MY GIRLFRIENDS 2004 NISSAN ALTIMA 2.5 DOWN THE HIGHWAY ON 2/15/2008 WHEN THE TRANSMISSION DOWN SHIFTED AND THEN DIRECTLY UPSHIFTED HARD. I GOT TO MY DESTINATION AND TRIED TO RESTART THE CAR WHEN I LEFT IT CRANKED LONGER THAN USUALLY, IN FACT UNUSUALLY LONG BUT IT DID START UP. I GOT BACK ON THE HIGHWAY TO GO HOME AND WHILE GETTING ON THE ON RAMP TO THE HIGHWAY THE CAR SHUT OFF AND THE STEERING WHEEL LOCKED UP AND THE SERVICE ENGINE SOON LIGHT CAME ON. I DID WHAT I COULD TO GET THE CAR TO THE SHOULDER AND WAITING A COUPLE OF MINUTES AND TRIED TO RESTART THE CAR. I DID GET IT RESTARTED AND TOOK CITY STREETS TO AUTOZONE TO HAVE THE CODES READ FROM THE SERVICE ENGINE SOON LIGHT. I HAD 2 CODES, ONE BEING P0725 AND P0355. I ONCE AGAIN TOOK CITY STREETS HOME TO AVOID THE SAME THING HAPPENING GOING 70MPH. I GOT IT HOME THAT FRIDAY THE 15TH AND PUT IT IN THE GARAGE. I GOT ONLINE AND WENT TO NISSANCLUB.COM AND RESEARCHED THE PROBLEM. I FOUND OUT THAT THE P0335 IS THE CRANK POSITION SENSOR MALFUNCTION AND THAT CAUSED MY CODE OF P0725 BEING THE ENGINE SPEED SENSOR. THROUGH RESEARCHING THIS IS A VERY BIG PROBLEMS WITH THE 2002-2006 ALTIMAS, MAINLY THE 2.5 4CYLINDERS. NISSAN ISSUED A RECALL FOR THE 2002-2005 AND 2006 ALTIMAS BUT FAILED TO INCLUDE THE 2003 AND 2004 IN IT. NOW WHY WOULD THEY NOT PUT THE SAME FAULTY SENSORS IN THE 2003'S AND 2004'S AND SKIP AHEAD AND PUT THEM IN THE 05'S AND 06'S. I WENT TO THE DEALERSHIP ON MONDAY THE 18TH TO VERIFY HER CAR WAS NOT INCLUDED IN THE RECALL AND IT WASN'T. THIS IS NISSANS DELIBERATE ATTEMPT TO NOT TAKE FULL RESPONSIBILITY FOR THE FAULTY CRANKSHAFT POSITION SENSORS PUT IN THE 2002-2006 ALTIMAS. I PAID FOR THE $30.00 SENSOR, ALSO ANOTHER $30 SENSOR THAT IS RECOMMENDED REPLACED WITH THE CRANKSHAFT SENSOR AND SPENT 3 1/2 HOURS OUTTA MY DAY TO REPLACE THE HARD TO GET SENSOR. IT IS MY BELIEF THAT NISSAN NEEDS TO INCLUDE THE 2003 AND 2004 ALTIMAS IN THE RECALL WITH THE 2002-05, 06. *TR

ON 2/5/08 WE STARTED OUR 2004 NISSAN ALTIMA AND HAD NO POWER STEERING. UPON OBSERVATION THE SERPENTINE BELT WAS NOT TURNING. WE HAD THE CAR TOWED TO THE MECHANIC AND FOUND THAT THE BOLT ON THE MAIN PULLEY ON THE CRANKSHAFT HAD FALLEN OUT AND THE PULLEY HAD FALLEN OFF OF THE CRANKSHAFT. HAD THIS OCCURRED WHILE DRIVING DOWN THE INTERSTATE AT 65MPH, THE RESULTS COULD HAVE BEEN HORRIFIC POSSIBLY LEADING TO FATALITIES. *TR

TL*THE CONTACT OWNS A 2004 NISSAN ALTIMA. THE VEHICLE WOULD NOT START AND THE CHECK ENGINE WARNING LIGHT ILLUMINATED. THE VEHICLE FINALLY STARTED AFTER 2 OR 3 ATTEMPTS. THE DEALER STATED THAT THE CRANK ANGLE SENSOR FAILED AND THEY REPROGRAMMED THE ECM. THE MANUFACTURER STATED THAT THE VIN WAS NOT INCLUDED IN NHTSA CAMPAIGN ID NUMBER 06V242000 (ENGINE AND ENGINE COOLING). THE CURRENT AND FAILURE MILEAGES WERE 77,750.

2004 NISSAN ALTIMA WITH A RECALL FOR THE INTAKE MANIFOLD. CONSUMER STATES THAT HE DID NOT RECEIVE THE RECALL NOTICE. HIS VEHICLE BEGAN SHAKING VIOLENTLY AND THE CHECK ENGINE LIGHT ILLUMINATED DUE TO THE DEFECT OF THE INTAKE MANIFOLD. *KB THE CONSUMER TOOK THE VEHICLE TO HIS MECHANIC, WHO DISCOVERED THAT THE FLAP FROM THE INTAKE MANIFOLD HAD WORKED ITS WAY LOOSE AND FALLEN INSIDE THE ENGINE. THE FLAP WAS UNABLE TO BE RE-ATTACHED INDEPENDENTLY AND THE ENTIRE INTAKE MANIFOLD HAD TO BE REPLACED. *JB