IllustrationCPSC#X11C0561A & XX11C0565A. 1991 MITSUBISHI MIRAGE CONSUMER STATED AFTER INSTALLING CYLINDER HEAD, HE NOTICED THE VEHICLE RAN ROUGH. *LN THE CONSUMER WAS INFORMED THE VALVES NEEDED TO BE ADJUSTED. THE CONSUMER HAS SINCE LEARNED THE CYLINDER HEAD WAS BAD. *JB
1991 Mitsubishi Mirage
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Mirage years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 2 of 38 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 14 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 10 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
5 crash reports2 fire reports2 injury reports
Engine And Engine Cooling complaints
4 reportsI READ WITH INTEREST THE REPORTS OF PROBLEMS WITH MITSUBISHI AUTOMOBILES, AS ONE OF THE PROBLEMS REPORTED - A LOOSE CRANKSHAFT - IS EXACTLY THE PROBLEM WE HAD WITH OUR CAR. I AM REPORTING THIS TO YOU AS THE NEWS ACCOUNTS I'VE READ TALK ONLY ABOUT CARS IMPORTED IN THE LAST TWO YEARS AS POSSIBLY BE SUBJECT OF RECALL. I WONDER IF T…
Read full complaint
I READ WITH INTEREST THE REPORTS OF PROBLEMS WITH MITSUBISHI AUTOMOBILES, AS ONE OF THE PROBLEMS REPORTED - A LOOSE CRANKSHAFT - IS EXACTLY THE PROBLEM WE HAD WITH OUR CAR. I AM REPORTING THIS TO YOU AS THE NEWS ACCOUNTS I'VE READ TALK ONLY ABOUT CARS IMPORTED IN THE LAST TWO YEARS AS POSSIBLY BE SUBJECT OF RECALL. I WONDER IF THE RECALL SHOULDN'T COVER CARS, LIKE OURS, A GOOD DEAL OLDER THAN THAT. OUR SPECIFIC PROBLEM OCCURRED IN 1996 WHEN THE CAR HAS ABOUT 70,000 MILES ON IT. THE CRANKSHAFT PROBLEM WAS REPAIRED BY PHIL LONG MITSUBISHI IN COLORADO SPRINGS. CO.
VEHICLE HAS STALLED ON 3 OCCASIONS WITHOUT WARNING OR HESITATION ,CAUSING POTENTIAL SAFETY HAZARD. *AK
CRANKSHAFT SCREW HAS BACKED OUT OF THE CRANK, CAUSED DAMAGE TO THE ENGINE. TT
Official recalls
195V103004 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
3EA96015 · Automatic Shoulder Belt Failure
Opened Jun 28, 1996 · Closed Jun 12, 1997
Status: closed (inferred from source dates) · Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
Additional source detail variants (2)
Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
PE96006 · Auto Shoulder Belt Failure
Opened Jan 19, 1996 · Closed Jun 28, 1996
Status: closed (inferred from source dates) · Seat Belts
There is no summary currently available
EA95004 · Takata Seat Belt Buckle Failure
Opened Mar 10, 1995 · Closed Aug 1, 1995
Status: closed (inferred from source dates) · Seat Belts:front:buckle Assembly
There is no summary currently available