2020 MERCEDES-BENZ Sprinter 2500

The contact owns a 2020 Mercedes-Benz Sprinter 2500. The contact received notification of NHTSA Campaign Number: 21V411000 (Electrical System, Back Over Prevention) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The 2019+ Mercedes Sprinter EIS (Electronic Ignition System) module is bolted under the driver side dash board to the base of the A pillar where it meets with the firewall. The electrical connector of the module is pointing straight up - this is an issue because any liquids that might spill on the dash (dash cupholder) or any humidity from windshield interior condensation will drip right down the wiring and into the EIS module causing it to short out. _ If the EIS module shorts out, the vehicle will be inoperable until a new unit is fitted. _ The EIS module retails at $1800+ from Mercedes _ Had Mercedes installed the EIS module with the connector facing DOWNWARD - this moisture related issue would not exist. _ There is no drip loop provisions in the wiring. _ Mercedes is aware of the issue as they have created a plastic bag with part number A 638 546 00 35 and they are charging $20 for it. As of right now, Mercedes refuses to fix this issue preventatively. They will only repair it AFTER the EIS module has shorted out. They are refusing to treat this as a warranty claim even though it is clearly a manufacturer defect.

The 2020 Mercedes Sprinter EIS (Electronic Ignition System) module is placed directly to the base of A pillar. Its electrical connector is pointing straight up and cable entry does not have drop loop - this is an issue because any liquids that might spill on the dash (dash cupholder) or any humidity from windshield interior condensation will drip right down the wiring and into the EIS module causing it to short out. If the EIS module shorts out, the vehicle is inoperable and has to be towed to dealership for repair. MB retails EIS module at $1800+ MB knows it’s a product defect. In its service bulletin of LI54.21-N-069524, They had a temporary solution by using an plastic bag (part number A 638 546 00 35) to cover the top connector. As of right now, Mercedes refuses to fix this issue preventatively. They will only repair it AFTER the EIS module has shorted out. They are refusing to treat this as a warranty claim even though it is clearly a manufacturer defect. Please help? Thank you

Here's what I wrote: The 2019+ Mercedes Sprinter EIS (Electronic Ignition System) module is bolted under the driver side dash board to the base of the A pillar where it meets with the firewall. The electrical connector of the module is pointing straight up - this is an issue because any liquids that might spill on the dash (dash cupholder) or any humidity from windshield interior condensation will drip right down the wiring and into the EIS module causing it to short out. _ If the EIS module shorts out, the vehicle will be inoperable until a new unit is fitted. _ The EIS module retails at $1800+ from Mercedes _ Had Mercedes installed the EIS module with the connector facing DOWNWARD - this moisture related issue would not exist. _ There is no drip loop provisions in the wiring. _ Mercedes is aware of the issue as they have created a plastic bag with part number A 638 546 00 35 and they are charging $20 for it. As of right now, Mercedes refuses to fix this issue preventatively. They will only repair it AFTER the EIS module has shorted out. They are refusing to treat this as a warranty claim even though it is clearly a manufacturer defect. Please help? Thank you

On Sept 6 2021 the engine suddenly stalled/stopped while driving on 194 west of Pullman Wa. A partial restart enabled me to move to a safer location. The Check Engine light came on. I used myOBD scanner to identify engine failure fault codes. Electrical sensor short circuits were identified. Vehicle was transported to a MB dealer in Spokane where a chaffed engine wiring harness was identified as the cause. MB engineers in Stuttgart Germany confirmed this diagnosis. I have now learned that the factory harness installation rubbing against engine components has been an ongoing problem in the Sprinter Van. This defect has contributed to engine failures as acknowledged by several MB technicians. Owners of all affected MB Sprinter Vans should receive notice of this potentially dangerous wiring harness defect. MB USA should be mandated to recall and modify the harness attachment points where abrasion of the harness cover and wiring is occurring. Preventing unexpected engine shutdowns in Highway traffic must be a priority of any vehicle manufacturer. Rear end collisions endanger the safety and lives of vehicle occupants. The defective engine wiring harness installation should be addressed immediately. Please share my report with MB USA. Accident Prevention Saves Lives

My husband was stopped at a stop light on Sept. 9th when the van randomly (and without provocation) shifted itself from drive into park. We called the dealership to explain the problem and ask that they look into it. We made an appointment and dropped off the vehicle yesterday. Service Department called and verbally stated that they had taken a van on a test drive and that the van had acted "normally" and that they anticipated returning the van to us with the instruction that if we experienced the problem again to contact them. I was not happy with this response as I felt that the problem was a severe safety issue and not enough had been done to investigate it. I quickly googled "mercedes going into park on its own" and found an article detailing reports of 2010 mercedes sedans going into park on their own while the driver was slowing to stop (exactly as we experienced). An accompanying official mercedes benz service department memo in the article confirmed the problem, mentioned the "auto p" feature and blamed the problem on a faulty ignition switch. I called the service department back, referenced the memo and asked if a faulty ignition switch could be to blame. The service department stated that it would be impossible because the ignition switch has changed. They stated that my husband must have taken off his seat belt and engaged the auto p feature. My husband did not unbuckle his seat belt that day. The dealership returned the van noting that they were able to duplicate the issue and engage the auto p feature by unbuckling the driver's seat belt at low speed. My husband and I tried to duplicate and engage the auto p feature ourselves by unbuckling the driver's seat belt after it was returned but were unable to do so. Interestingly, mercedes benz has recently issued a recall for driver's manuals because they acknowledge that the directions for how to engage the feature as explained in the manual are incorrect. Unbuckling will not engage auto p.

The contact owns a 2020 Mercedes-Benz Sprinter 2500. The contact received notifications of NHTSA campaign numbers: 20V802000 (Service Brakes, Hydraulic), 21V055000 (Electrical System), and 21V411000 (Electrical System, Back Over Prevention) however, the dealer informed the contact that the parts for the recall repairs were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repairs. The manufacturer was not notified of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

BOUGHT VEHICLE 26 SEP 20 FROM GENERAL RV IN DRAPER, UTAH I WAS INFORMED OF THE WINNEBAGO REVEL 2ND ALTERNATOR RECALL NUMBER 162 HAD TO BE COMPLETED BEFORE I DROVE THE VEHICLE OFF THE LOT. SO, I WAS TOLD [PER MANAGER MIKE MALLORY] IT WAS COMPLETED ON OCTOBER 10TH AND THUS DROVE IT OFF THE LOT ON OCTOBER 22ND, 2020. FAST FORWARD FOUR MONTHS TO FEB 2021 AS STARTED TO NOTICE A GOD-AWFUL SQUEALING SOUND WHEN I STARTED THE VEHICLE NO MATTER WHAT TEMPERATURES AND IT HAS PROGRESSIVELY GOT WORSE UP UNTIL APRIL NOW. ON 8 APRIL 21 WHILE AT A MERCEDES-BENZ DEALER IN FARMINGTON, UT I WAS TOLD THE SECONDARY ALTERNATOR WAS OUT OF ALIGNMENT AND THE ONE AND ONLY SERPENTINE BELT HAD EXCESSIVE WEAR, PLUS THE ISSUE WAS NOT A MERCEDES-BENZ WARRANTY ISSUE,, BUT RATHER A AN UP-FITTER (WINNEBAGO) PROBLEM PER MECHANIC TREVOR AND SERVICE REP ALEX! SO, ON 9 APR 21 I CONTACTED GENERAL RV AGAIN & SAID WHAT THE MERCEDES DEALER TOLD ME AND ON THE 22ND OF APRIL I PROVIDED PHOTOS OF THE ALTERNATOR ISSUE, SO THEY (PAUL DELUCA LEAD SVC REP) ORDERED THE RECALL KIT #162 FROM WB. HOWEVER, HERE'S THE REAL KICK IN THE FACE AKA COMPLAINT... WHY WOULD THEY NEED TO ORDER ANOTHER RECALL KIT WHEN THEY TOLD ME THEY STALLED IT IN OCTOBER 2020 BEFORE I COULD EVEN DRIVE IT OFF THE LOT? THEREFORE, GENERAL RV FLAT OUT LIED TO ME WHICH IS UNBELIEVABLE AND TOTALLY UNACCEPTABLE ESPECIALLY WITH THE SEVERITY OF A SERPENTINE BELT FAILURE AT SPEED EQUALS LOSS OF STEERING AND CRASH AND/OR DEATH NO TO MENTION TOTALLED VEHICLE! SECOND ISSUE/COMPLAINT IS MY ACTIVE BRAKE AND DISTANCE SENSOR BEHIND THE GRILL HAS BEEN RANDOMLY FAILING ESPECIALLY AT THE WORST TIMES I.E. LONG ROAD TRIPS! SO, THIS RENDERS THE CRUISE CONTROL & SMART BRAKING INOPERABLE WHICH IS UNACCEPTABLE ON A NEW VEHICLE WITH ONLY A FEW THOUSAND MILES ON IT. SO, I HAVE BEEN TO THE SAME MB DEALER IN FARMINGTON, UT 3NOR 4 TIMES TO FINALLY FIX IT, BUT NO FIX!!

TL* THE CONTACT OWNS A 2020 MERCEDES-BENZ SPRINTER 2500. THE CONTACT STATED THAT THE COOLANT WARNING LIGHT INTERMITTENTLY ILLUMINATED ON THE INSTRUMENT PANEL. THE CONTACT HAD TAKEN THE VEHICLE TO MERCEDES-BENZ OF SPRINGFIELD (295 BURNETT RD, CHICOPEE, MA 01020) WHERE THEY DISCOVERED NO FAULT WITH THE COOLANT SYSTEM HOWEVER, THE WARNING LIGHT CONTINUED TO ILLUMINATE INTERMITTENTLY. THE CONTACT THEN PERFORMED A VIN SEARCH ON THE NHTSA WEBSITE AND DISCOVERED NHTSA CAMPAIGN NUMBER: 21V055000 (ELECTRICAL SYSTEM) AND 21V152000 (SERVICE BRAKES, HYDRAULIC) HOWEVER, THE PARTS TO DO THE RECALL REPAIRS WERE UNAVAILABLE. MERCEDES-BENZ OF SPRINGFIELD (295 BURNETT RD, CHICOPEE, MA 01020, (413) 624-4100) WAS CONTACTED AND IT WAS CONFIRMED THAT THE PARTS WERE NOT YET AVAILABLE. THE MANUFACTURER WAS MADE AWARE OF THE ISSUE. THE CONTACT STATED THAT THE MANUFACTURER HAD EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE FAILURE MILEAGE WAS APPROXIMATELY 1,000. VIN TOOL CONFIRMS PARTS NOT AVAILABLE.

MERCEDES HAS LOCATED A DASHBOARD DRINK HOLDER DIRECTLY ABOVE A VENT THAT OPENS TO THE STARTER ELECTRICAL MODULE AND CIRCUIT BOARD. THE DRINK HOLDERS ARE VERY SHALLOW, AND UNSTABLE. THE LOCATION ON THE DRIVER'S SIDE DASH, NEXT TO A VENT THAT LEADS TO THE STARTER CIRCUIT BOARD IS EXTREMELY DANGEROUS. I ACCIDENTLY SPILLED COFFEE ON THE DASH DRINK HOLDERS, AND THE SUBSEQUENT SPILL LED TO THE STARTER MODULE TO SHORT CIRCUIT, STRANDING OUR SPRINTER VAN, WHICH WOULD NOT START FOR OVER AN HOUR. ONCE STARTED AND DRIVEN FOR AWHILE, THE VAN WOULD NOT TURN OFF UNTIL PUSHING THE STARTER BUTTON CONTINUALLY FOR 20 MINUTES.