IllustrationCONSUMER WAS DRIVING ON WET ROADS AND ON A TURN VEHICLE SLID AND FILPPED OVER AND RAN INTO A TREE. BUT, SEAT BELTS DID NOT HOLD IN PLACE. HAS NOT CONTACTED DEALERSHIP.*AK
1989 Mazda Mpv
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1989 Mazda Mpv do not stand out strongly from the model-year median of 36.
About this comparison →How this year compares
Owner complaints by model year
Compare all Mpv years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 22 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 8 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Fuel System, Gasoline. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
4 crash reports0 fire reports2 injury reports
Seat Belts complaints
8 reports2 POINT SEAT BELT FOR MIDDLE SEAT FAILED AFTER FACTORY REPLACEMENT. YH
RECALL 95V103005 REGARDING SEAT ELT BUCKLES, CONSUMER STATED THAT HE SET AN APPOINTMENT WITH DEALER ONE YEAR AGO AND AS OF YET THEY HAVEN'T RECEIVED THE PARTS TO FIX VEHICLE. *AK
DEALER DOES NOT HAVE PARTS TO REPAIR RECALL NO 95V03005. *AK
PASSENGER SIDE SEAT BELT DOES NOT WORK. PLEASE GIVE MORE DETAILS. *AK
CENTER SEATBELT WHEN POSITION IN ITS SMALLEST LENGTH, DOES NOT FIT A CHILD SAFETY SEAT, IMPROPERLY ADJUSTED. TT
SEAT BELT BUCKLE FAILURE, BROKEN BELT BUCKLE. TT
DRIVERS SEAT BELT NO LONGER WORKS, SEEMS TO BUCKLE BUT IS NOT ACTUALLY LOCKED. TT
Official recalls
515V674000 · Electrical System:ignition:switch
Oct 19, 2015
Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
Consequence & remedy
Consequence: If the ignition switch overheats there would be an increased risk of a fire.
Remedy: Mazda will notify owners, and dealers will replace the ignition switch, free of charge. The recall began on December 17, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8715J.
95V103005 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
91V161000 · Service Brakes, Hydraulic:foundation Components:drum
Sep 11, 1991
WHEN APPLYING THE FOOT (SERVICE) BRAKE IN THE LOW VEHICLE SPEED CONDITION, THE BRAKING POWER PRODUCED MAY BE MORE THAN EXPECTED.
Consequence & remedy
Consequence: THE UNEXPECTED BRAKING POWER COULD RESULT IN REAR BRAKELOCKUP AND THE VEHICLE BECOMING DIFFICULT TO CONTROL.
Remedy: REPLACE BRAKE SHOE ASSEMBLY WITH IMPROVED ASSEMBLY.
91V013000 · Service Brakes, Hydraulic:power Assist:vacuum:hoses, Lines/piping, And Fittings
Jan 22, 1991
WHEN THE VEHICLE IS EXPOSED TO TEMPERATURES BELOW 5 DEGREES FAHRENHEIT (-15 DEGREES C), THE NEUTRAL DETERGENT USED AS AN ASSEMBLY LUBRICANT MAY STICK TO THE CHECK VALVE, PREVENTING VALVE FROM FUNCTIONING.
Consequence & remedy
Consequence: THIS COULD CAUSE AN INOPERATIVE BRAKE POWER ASSIST WHICHDESCREASES BRAKING ABILITY, AND PRESENTS A POTENTIAL FOR AN ACCIDENT.
Remedy: REPLACE VACUUM HOSE ASSEMBLY.
89V194000 · Seat Belts:front:anchorage
Nov 7, 1989
THE CENTER SAFETY BELT ATTACHMENT HARDWARE BRACKETS FOR THE THIRD SEAT MAY NOT WITHSTAND THE SPECIFIED TENSILE LOAD.
Consequence & remedy
Consequence: VANS WOULD NOT COMPLY WITH FMVSS 210
Remedy: REPLACE SAFETY BELT ASSEMBLIES WITH BRACKETS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA95005 · Takata Seat Belt Buckle Failure
Opened Mar 10, 1995 · Closed Aug 1, 1995
Status: closed (inferred from source dates) · Seat Belts:front:buckle Assembly
There is no summary currently available
PE91088 · Throttle Sticking
Opened Jun 18, 1991 · Closed Oct 21, 1991
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available