IllustrationWHILE VEHICLE STOPPED TEMPERATURE GAUGE WOULD RISE. ON THE OTHER HAND, WHILE TRAVELING TEMPERATURE WOULD LOWER. MANUFACTURER HAS BEEN CONTACTED.*AK
1989 Mazda 929
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all 929 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 36 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Structure. Review the 19 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Latches/locks/linkages. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
Engine And Engine Cooling complaints
2 reportsCONSUMERS UNION RECOMMENDED I CONTACT YOU. CAM DRIVE BELT MANUFACTURED BY THE KELLY-SPRINGFIELD DIVSION OF GOODYEAR TIRE AND RUBBER, SEPARATED INTO SHREDS AFTER 49,800 MILES. LOCAL DEALER REPLACED BELT FREE OF CHARGE, BUT CLAIMED WARRANTY GOOD FOR ONLY 50,000 MILES. OWNER'S MANUAL RECOMMENDS CHANGING EVERY 60,000 MILES. BREA…
Read full complaint
CONSUMERS UNION RECOMMENDED I CONTACT YOU. CAM DRIVE BELT MANUFACTURED BY THE KELLY-SPRINGFIELD DIVSION OF GOODYEAR TIRE AND RUBBER, SEPARATED INTO SHREDS AFTER 49,800 MILES. LOCAL DEALER REPLACED BELT FREE OF CHARGE, BUT CLAIMED WARRANTY GOOD FOR ONLY 50,000 MILES. OWNER'S MANUAL RECOMMENDS CHANGING EVERY 60,000 MILES. BREAKAGE CAUSED WARPED VALVES AND GOUGED PISTONS. SUBMITTED DAMAGE CLAIM, #11153, TO GOODYEAR IN THE AMOUNT OF $2,830.70. GOODYEAR AFTER ANALYZING A COUPLE STRANDS, CLAIMED THE BELT WAS NOT AT FAULT. MACHANIC, ASE CERTIFIED, CAN NOT FIND PHYSICAL EVIDENCE OF ANY OTHER PART BEING AT FAULT. I WOULD LIKE REIMBURSEMENT FOR DAMAGE TO VEHICLE, AND CLARIFICATION AS TO WHY A COMPANY WOULD RATE A REPLACEMENT PRODUCT FOR FEWER MILES THAN RECOMMENDED IN THE AUTOMOBILE OWNER'S MANUAL, AND NOT NOTIFY THE REPAIR SHOP OR OWNER. I AM LUCKY BREAKAGE DID NOT OCCURRED IN HEAVY TRAFFIC! FOR MORE INFORMATION PLEASE CONTACT EITHER MYSELF, OR ENDY AUTO REPAIR, 1706 S. IOWA AVE, JOPLIN, MO. 64804, PH. #417-626-7755. THANK YOU!*AK
Official recalls
295V103005 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
93V174000 · Structure:body:door
Oct 29, 1993
RESIN MOLDED FRONT HANDLES FAIL AT THE DOOR LATCH ACTUATING ROD ATTACHMENT, FREEING THE ROD TO FALL INSIDE THE DOOR FRAME. SUBSEQUENT LOWERING OF THE ASSOCIATED WINDOW MAY FORCE THE ACTUATING ROD DOWNWARD AND RELEASE THE DOOR LATCH.
Consequence & remedy
Consequence: INADVERTENT ACTUATION OF THE DOOR LATCH CAUSES THE DOORTO OPEN UNEXPECTEDLY WHICH COULD RESULT IN AN OCCUPANT FALLING OUT OF THEVEHICLE.
Remedy: DEALERS WILL REPLACE THE DOOR HANDLE/LATCH ASSEMBLY.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA92031 · Inadvertent Door Opening
Opened Sep 25, 1992 · Closed Nov 30, 1993
Status: closed (inferred from source dates) · Structure
There is no summary currently available
PE91088 · Throttle Sticking
Opened Jun 18, 1991 · Closed Oct 21, 1991
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available