1993 Mazda 626

THE 626, MX6 AND FORD PROBE (ALL RELATED DESIGNS) APPEAR TO HAVE A DEFECT THAT CAUSED THE REAR CALIPERS AND PARKING BRAKE TO SEIZE. THE PARKING BRAKE ARM THAT THE CABLE PULLS BACK SEIZES ??ON??. THIS MIGHT BE DUE TO POOR DESIGN WHERE THE SPRING CAN NOT PULL THE ARM BACK DUE TO THE MATERIALS USED AND THE RUST. THE ARM AND PIVOT MATERIAL SHOULD BE CHANGED AND THE SPRING SHOULD BE STRONGER. ONCE THE PARKING BRAKE SEIZES THE ROTOR, CALIPERS AND THE WHOLE WHEEL RIM GETS *EXTREMELY* HOT. DRAG, HEAT AND BURNING SMELLS MAY BE NOTICED. IF NOT NOTICED THE ROTOR AND PADS WEAR AWAY UNTIL THE BRAKE DOES NOT FUNCTION. THE DAMAGE TO THE ROTORS AND CALIPERS REQUIRES REPLACEMENT HOWEVER THE ROOT CAUSE APPEARS TO BE THE POOR PARKING BRAKE DESIGN. BEFORE I STARTED TO TRY TO UNDERSTAND THIS MYSELF I HAD 3 DIFFERENT SERVICE CENTERS REPAIR THE PROBLEM ON 3 OCCASIONS. EACH TIME THEY DID NOT DO ANYTHING TO THE PARKING BRAKE AND JUST REPLACED ALL THE CALIPERS, ROTORS, PADS, ETC. THE SERVICE CENTERS DO NOT UNDERSTAND THE ROOT CAUSE AND THEY DO NOT FIX IT. I FOUND OUT A BIT FROM INTERNET SEARCHES AND THE REPAIR MANUAL. (THE REPAIR MANUAL IS COMMON TO THE FORD PROBE WITH MANY OWNERS COMPLAINING ABOUT SEIZED BRAKES.) I TOOK A LOOK AT THE PARKING BRAKE ARM WHEN I NEXT PULLED OVER WITH DRAG, HEAT AND BURNING SMELLS. THE ARM WAS SEIZED AND I FORCED IT FREE WITH MY HAND WHICH TEMPORARILY SOLVED THE PROBLEM. FROM WORKING THE PARKING BRAKE CABLE IT APPEARS THAT THE CABLE IS FINE AND THAT THE PROBLEM IS FROM THE RUSTED ARM & PIVOT. THE MATERIAL OF THE ARM & PIVOT RUSTS AND SEIZES. THESE SHOULD BE REPLACED WITH A MORE SUITABLE MATERIAL. THIS IS A SAFETY ISSUE FOR MANY REASONS. OWNERS ARE DRIVING AROUND WITH FLAMING HOT ROTORS, DEFECTIVE BRAKES AND STRANGE DRAG AND VIBRATION ON A REGULAR BASIS. MAZDA AND FORD SHOULD BE REQUIRED TO MAKE AVAILABLE PROPERLY DESIGNED REPLACEMENT PARTS AND TO COMPENSATE THE OWNERS FOR THE REPAIR BILLS. *JB

ON A VERY SNOWY DAY AFTER A 20 MINUTE RIDE WE EXPERIENCED TOTAL BRAKE FAILURE. DEALER TOWED CAR. THE NEXT DAY THE DEALER TOLD ME THE REPAIRS WOULD COST ABOUT $2000.00 DOLLARS. THEY SAID BOTH BRAKE LINES BURST DUE TO SEVERE CORROSION. SINCE THIS WAS AN EXTREME EXPENSE. WE PURCHASED A NEW CAR. I FEEL NO BRAKING SYSTEM SHOULD EVER EXPERIENCE TOTAL BRAKE FAILURE, AND FEEL THAT MAZDA SHOULD AT LEAST REPLACE ONE OF THE BRAKE LINES TO MAKE SURE THAT SOMEONE DOESNT GET KILLED. *JB

I OWN A 1993 MAZDA 626 ES (6 CYLINDER) AUTOMOBILE WITH MAJOR PROBLEMS IN THE AUTOMATIC TRANSMISSION. I HAD THE TRANSMISSION REBUILT IN 1999. IN MARCH 2002, IT BEGAN TO FAIL AGAIN, WAS REBUILT AGAIN, FAILED LESS THAN ONE MONTH LATER, REBUILT AGAIN, FAILED AGAIN AND HAS BEEN SITTING IN A SHOP FOR 4 MONTHS AWAITING A NEW TRANMSSION BY MAZDA. MAZDA HAS BEEN NON-COOPERATIVE TO BOTH THE DEALERSHIP PARTS DEPARTMENT AND TO THE TRANSMISSION REPAIRMAN. THERE ARE TWO POSSIBLE TRANSMISSIONS HOWEVER MAZDA REFUSES TO MANUFACTURE THE ONE RECOMMENDED BY THE DEALER SAYING "IF WE MAKE IT AND IT DOES NOT WORK, YOU WILL KEEP IT!" PLEASE HELP!

QUICK VERSION: TRANSMISSION DIED IN CAR TWICE. FIRST TIME IT DIED AROUND 112500 MILES. SECOND TIME IT DIED 11500 MILES LATER. STILL RUNNING ON SECOND REPAIR JOB AS OF 12/12/2002. AUTOMATIC TRANSMISSION SHIFTED ROUGH (WHICH I WAS TOLD WAS "STANDARD" BEHAVIOR) FOR THE ENTIRE TIME I OWNED THE CAR. THE TRANSMISSION DIED A YEAR AGO AND THE LOCAL MAZDA DEALERSHIP SAID THAT IT WOULD COST ME ABOUT $4000 TO REPLACE IT. I WENT TO A PRIVATE TRANSMISSION SHOP INSTEAD AND CUT THAT COST IN HALF. REPAIR JOB DIDN'T LAST VERY LONG, HOWEVER AND I WOUND UP GOING TO A DIFFERENT SHOP THE SECOND TIME. STILL RUNNING FOR THE MOMENT. I FULLY BELIEVE THAT I SHOULD NOT HAVE EXPERIENCED SUCH PROBLEMS WITH MY CAR IN THE FIRST PLACE. GIVEN THE AMOUNT OF ANECDOTAL EVIDENCE REGARDING THE 626'S TRANSMISSION PROBLEMS, MY OPINION IS SHARED BY MANY.