2018 Kia Stinger

The contact owns a 2018 Kia Stinger. The contact stated that occasionally while starting the vehicle, the vehicle failed to start immediately. The contact stated that oil was leaking from the vehicle during each failure. The contact stated that while attempting to accelerate from a light, at 5 MPH the vehicle lost automotive power, with the check engine and ABS warning lights illuminated. The vehicle was taken to a local dealer where the vehicle was diagnosed, and the contact was informed that the fuel pump and vacuum pump were faulty and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 99,000.

I bought front and rear drilled and slotted brake rotors. I installed these on my car using the same name brand of brake pads front and rear. The fronts were perfect. The rear rotors had defective black zinc coating that caked on my brake pads. This layer of coating prevented contact between the friction surface of the rotor and friction material of the pad. I only drove the car 1/2 mile. My rear brakes would not work properly. I sent Brake Performance 14 pictures and a series of emails describing this. They shrugged it off as cosmetic. I had the remaining defective coating machined off the friction surface of the rotors. I sanded and cleaned the layer of defective coating off my brake pads. After this cleaning, the brakes worked as expected. I have installed their products on 3 vehicles using 10 rotors and 2 drums. Only these last 2 rotors had defective coating. It's concerning that they never considered the safety implications of the defective coating. The front and rear rotors were stored together in the same environment prior to install.