2016 Jeep Renegade

WENT TO CHANGE THE REAR LEFT SIDE LIGHTS, (TAIL, TUNR SIGNAL AND BRAKE). Found that the circuit board holding the lights and the connector pin was burned. The connector pin was actually melted. Research this on-line and found that numerous complaints regarding these circuit boards and connectors have this same problem. Reached out to Jeep and no comments from them. The only place to find a replacement circuit board and connector is on E-bay. Cannot find it elsewhere.

Had this car since 2016,only 39,289miles,no problems whatsoever,and then I did this recall thing the 12th of July 2021,and today the 14th of July 2021 I have an engine light on,I have this horrible noise when I turn it on,I am so pissed and mad!!!really mad!!!Techs should not touch anything else than whats is called for to be fixed!!!i feel that when we take the cars they mess things out so we,the customers have to end up putting money since is free,they need customers to go back and spend on something that it didn’t needed it from the beginning!!!like I said 6yrs and not a problem,even have a multi point inspection sheet that it shows everything was great!!!i am scare to take back,because now I’m going to end up paying for their mistakes/fault/unprofessional work.I am so disappointed,upset,mad.I was planning to buy there again,but now I’m re thinking bout it!it won’t get fixed I know I will end up paying,but I want to make a complaint so that way at least it will pile with other people who end up having the same problems!why do Mechanics do that,or Techs do it!if is not broken,don’t fix it please.They should take an integrity test and not take advantage of the situation.

MY PASSENGER SIDE FOG LIGHT KEEPS GOING OUT. I HAVE CHANGED IT 3X IN A VERY SHORT AMOUNT OF TIME. I HAVEN'T RECOGNIZED ANY PATTERN OR CAUSE BEHIND THIS. I'M SEEING ON FORUMS THAT BECAUSE YOU HAVE TO ACCESS THE BULB THROUGH THE WHEEL WELL, POSSIBLE MOISTURE MAY BE GETTING INTO THE COMPARTMENT CAUSING THE LIGHT TO GET WET AND SHORT. I'VE BEEN TO THE DEALERSHIP AND THEY WANT ME TO PAY A DIAGNOSTIC FEE AND SAY IT'S NOT COVERED UNDER WARRANTY. THIS TO ME SOUNDS LIKE A DESIGN FLAW AND I THINK THEY NEED TO FIX IT.

MY VEHICLE'S CONNECTOR TO THE PASSENGER SIDE TAIL LIGHT HAS A BURN MARK ON THE MIDDLE PIN OF THE CONNECTOR. I HAVE FOUND COUNTLESS OTHERS ON FORUMS WITH THE SAME ISSUE, WHERE THE CONNECTOR TO THEIR TAIL LIGHT FRIED, THUS CAUSING THE BRAKE LIGHT, BLINKER, AND REVERSE LIGHTS TO BE UNUSABLE WHICH IS A SAFETY ISSUE THAT CAN NOT BE FIXED BY SIMPLY CHANGING A BULB. THE VEHICLE WAS STATIONARY WHEN THE ERROR FIRST OCCURRED. *TR

ALL RIGHT REAR LAMPS FAILED DUE TO WIRING HARDNESS WITH CENTER GROUNDING WIRE BURNT. REAR LAMPS ARE NO LONGER FUNCTIONAL. ALSO THIS WOULD HAVE CAUSE A SPARK, ENOUGH IN THE RIGHT CIRCUMSTANCES TO CAUSE A FIRE, AND CONSIDER IT A SAFETY CONCERN. BULBS WHEN OUT WHEN OUT AFTER REPLACING WHEN OUT AGAIN THIS LEAD ME TO INVESTIGATE AND SAW THE BURNT GROUND WIRE. I CALLED THE DEALERSHIP AND ASK IF ANY RECALLS AND TOLD ME THEY WOULD LOOK AT IT AND ALSO CHARGE 130 DIAGNOSTIC CHARGE . I BELIEVE YOU HAVE A SIMILAR COMPLAINT ON THIS ISSUE. PLEASE INVESTIGATE. *TR

TL* THE CONTACT OWNS A 2016 JEEP RENEGADE. THE CONTACT STATED THE FRONT PASSENGER'S SIDE FOG LIGHT REFLECTOR MELTED, WHICH CAUSED THE LIGHT TO BECOME INOPERABLE. THE CONTACT STATED THAT FAILURE MADE IT DIFFICULT TO SEE THE ROADWAY WHILE DRIVING AT NIGHT. THE VEHICLE WAS TAKEN TO LARRY H. MILLER CHRYSLER JEEP DODGE RAM SANDY LOCATED AT 10905 AUTO MALL DR, SANDY, UT 84070, AND THE CONTACT WAS INFORMED THAT THE BULB NEEDED TO BE REPLACED. THE BULB WAS REPLACED HOWEVER, THE CONTACT STATED THAT THE DRIVER'S SIDE BULB EXPERIENCED A SIMILAR FAILURE. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 65,000.

ALL RIGHT REAR LAMPS FAILED AT THE SAME TIME, SHOWING FAILURES ON THE INSTRUMENT PANEL. AFTER ONLINE INVESTIGATION, I FOUND THAT SEVERAL PEOPLE HAD THE SAME ISSUE. THERE WERE PICTURES OF THE WIRING HARNESS WITH THE CENTER (GROUNDING) PIN BURNT OFF. I FOUND THE SAME ISSUE WITH MINE. THE FAILURE OCCURRED DURING NORMAL DRIVING WITH NO LIGHTS ON ON AN OPEN COUNTY ROAD, IN GOOD WEATHER. NO SIGNS OF ANY MOISTURE IN THE TAIL LIGHT ENCLOSURE. I WAS ABLE TO SOLDER IN A WIRE TO COMPLETE THE GROUND CIRCUIT AND ALLOW THE LIGHTS TO FUNCTION AGAIN. BUT DUE TO THE FAILURE, I WAS WITHOUT A RIGHT REAR TURN SIGNAL UNTIL I GOT HOME, WHICH IS A SAFETY CONCERN. AND APPARENTLY I'M NOT THE ONLY ONE IT'S HAPPENED TO.