2005 Jeep Grand Cherokee

The contact owns a 2005 Jeep Grand Cherokee. The contact stated while driving 35–40 MPH, the engine seized. No warning lights were illuminated. The vehicle was able to restart after several attempts. The contact stated that the failure had occurred several times, including three times while driving to the dealer. The contact referenced NHTSA Campaign Number: 14V438000 (Electrical System) which was associated with the VIN. The vehicle was taken to the dealer, where the contact was informed that the recall repair might not be able to be performed because of the age of the vehicle. In addition, the contact was informed that if the repair was approved by the manufacturer, the labor fee might be at the owner's expense. The contact was informed that the manufacturer needed to approve the repair. The vehicle was not repaired. The dealer made the manufacturer aware of the failure. The failure mileage was approximately 184,111.

1. Engine over heating problems numerous times and coolant leak. Even after replacement of radiator and hoses. 2. Went to pick up jeep from mechanic due to oil leak, when they brought it around, I noticed pink fluid dripping. Had Transmission serviced in March/April 2020 due to a leak., Flushed system, new filters and fluid. Last few months vehicle says "Transmission over Temp" a few times. Replaced transmission pan, due to a leak, new fluid added, in September 2022. Vehicle indicated "Transmission over Temp" a few weeks later. Didn't drive it a few days, haven't seen the warning sign yet. 3. Numerous oil leaks. Serpitean belt replaced along with other repairs. 4. When I bought vehicle, it had no heat and coolant was leaking in on passenger side floor. 5. Jeep shifts to 3rd gear and won't shift down or back into drive until I turn off vehicle and back on. Very dangerous I was a busy road, US 41 heading north, and had to pull over.

The contact owns a 2005 Jeep Grand Cherokee. The contact stated that while idle, the vehicle would overheat with the transmission temperature sensor warning light illuminated. The contact also stated that the vehicle would shudder and hesitate upon depression of the accelerator pedal. The vehicle was taken to an independent mechanic who informed him that the vehicle had to be serviced by an authorized dealer. Upon investigation, the contact linked the failure to NHTSA Campaign Number: 05V396000 (Power Train). The manufacturer was not notified of the failure. The vehicle was not repaired. The failure mileage was approximately 160,000.

Automatic Transmission contamination caused from rain water or AC condensation dripping directly on to transmission dipstick tube . During times of heavy rainfall, contaminated transmission fluid will overflow and puddle underneath the vehicle. Transmission fluid has been analyzed at Blackstone Laboratories and provided results showing h2o being present in the fluid, with no traces of engine coolant. Transmission shutters and shifts hard, reaches excessive temperatures under moderate loads. Dealership and independent transmission shop both have acknowledged an issue with the transmission and a water contamination.

PCM HAS BEEN REPLACEMENT MULTIPLE TIMES BY DIFFERENT REPAIR SHOP. When computer fails it has failed a circuit with 02 sensors which kills engine power randomly while driving on highways. It has turned ABS light on and Service 4x4 randomly and won’t let the vehicle travel over 10mph. Very dangerous on roads. I’ve had three computers installed in the last Year and a half and have given me 3 close calls almost causing accident. That’s 3 too many. I’m not the only one with the computer issues ask around to owners with these jeeps. How many close called does someone need for Chrysler to not even repair but Just to look into. Do people need to die in an accident for people to take this seriously. The issue is NOT from lack of maintenance either. If my ABS module was failed I would no. My vehicle has a 115,000miles on it and when this dangerous intermittent issues occur there are no DTC codes stored. This is a total epic failure done by Chrysler. If they don’t find something soon about theses vehicles. I will be sure never to by another Jeep product. I don’t drive this vehicle unless I’m alone never-mind one of my niece or nephews With me in this death trap I’ve learned my lesson On this one Chrysler Please help NHTSA!!

WHEN DESCRIBING WHAT HAPPENED WITH YOUR VEHICLE, TELL US SPECIFICALLY IF THE VEHICLE WAS STATIONARY, IN MOTION, ON A CITY STREET OR A HIGHWAY, TURNING, BRAKING, ETC. DESCRIBE THE FAULT OR PROBLEM THAT CREATED THE UNSAFE CONDITION. IF YOU KNOW, STATE THE COMPONENT PART OR SYSTEM THAT YOU BELIEVE MAY BE THE CAUSE OF THE SAFETY RISK. IF YOU ARE UNCERTAIN, SIMPLY STATE UNKNOWN AND PROVIDE YOUR BEST ASSESSMENT OF THE INCIDENT AND CAUSE IN YOUR DESCRIPTION. IF YOU HAVE OTHER INFORMATION - REPAIR INVOICES, POLICE ACCIDENT REPORTS, INSURANCE CLAIM FORMS, ETC. - SCAN THEM ELECTRONICALLY AND UPLOAD THEM ALONG WITH YOUR COMPLAINT. IF YOUR COMPLAINT IS ABOUT A RECALL AND YOU HAVE THE RECALL NUMBER AVAILABLE, PLEASE PROVIDE IT. ADDITIONALLY, IF YOU LATER OBTAIN INFORMATION AND EVIDENCE RELATED TO YOUR COMPLAINT, PLEASE RETAIN IT FOR AT LEAST FIVE YEARS, IN THE EVENT THAT WE CONTACT YOU FOR FURTHER INFORMATION. LESS *TR

MY 2005 JEEP GRAND CHEROKEE LAREDO (3.7 LITER V6) HAS ABOUT 78,500 MILES. IN 2018 MY JEEP HAD AN ENGINE SERVICE SOON LIGHT INCIDENT. I HAD THE OBDII READ BY O'REILLY AUTO PARTS FOR THE FAILURE CODES. THE CODES DOWNLOADED WERE U0404 & P0700. I WENT TO MY MECHANIC AND HE STATED, 'DRIVE IT FOR A WHILE AND IT SHOULD GO AWAY', HE WAS RIGHT - THE FAILURE CODE (DASH LIGHT) WENT AWAY. NOW, FEB. 7, 2020 MY ENGINE SERVICE LIGHT WENT ON. AGAIN I WENT TO O'REILLY AUTO PART TO HAVE THE OBDII ERROR CODES READ. AGAIN, THE ERROR CODES CAME UP U0404 & P0700. I DID SOME RESEARCH (ON THE WEB) AND FOUND A YOUTUBE VIDEO THAT ADDRESSED THESE TWO EXACT FAILURE CODES. PLEASE SEE THE YOUTUBE VIDEO, WEB ADDRESS, BELOW THAT EXPLAINS THE FAILURE AND REPAIR. HTTPS://M.YOUTUBE.COM/WATCH?V=YD71KNUO2AU THIS VIDEO CLEARLY SHOWS THE REASON FOR THESE TWO ERROR CODES. THE SHIFTING CONSOLE PRINTED CIRCUIT BOARD (PCB) HAS ALLOWED (OVER TIME) THE TRANSFER OF MATERIAL BETWEEN THE DIFFERENT DRIVE SELECTION POINTS (DRIVE, REVERSE, PARK) ON THE PCB TO BE SHORT CIRCUITED (BRIDGED) CAUSING A FALSE SIGNAL TO THE OTHER CONTROL DEVICES. THIS IS NOT LISTED AS A SERVICEABLE ITEM BY JEEP. AS A RESULT JEEP IS RESPONSIBLE FOR THIS FAILURE BECAUSE THEY DO NOT STATE THAT THIS IS A SERVICE PREVENTABLE FAILURE. THANK YOU FOR CONSIDERING MY COMPLAINT.