2020 Jeep Gladiator

Instrument Panel Failure. The center LCD screen that displays speed, tachometer, oil temp, coolant temp, oil pressure, battery voltage, and transmission temps, fuel gauge, tire pressure readings, warning messages, and many other things just stopped working. This is obviously a safety risk and can cause an increased risk to safety and crashes, as it has been recalled on many other Jeep Gladiators and Wranglers. This screen started out working upon purchase, but would often have a digital background that would show up. The dealership it was purchased from informed us there was nothing wrong with the screen. It just stopped working and there is nothing on the display.

My 3.5 instrument intermittently goes out for days and will come back on and back off again. I took it to the nearest dealer but this did not sjow up on his scan but it out again. As you will see in the photo the vehicle is running but no display. Milage is a little over 69,000. Dealer informed me that many of these were recalled but not my particular vehicle. He said it would cost me $1600 to get it repaired. It appears to me the recall may need to be expanded. I also contacted the jeep website but was told my vehicle was not covered under the recall.

The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at various speeds, the instrument panel failed to display critical safety information as intended. No warning lights were illuminated. The vehicle was taken to a local Midas, where the battery was replaced; however, the failure persisted, and the vehicle was diagnosed and determined to need a new instrument panel. The local dealer was contacted. The vehicle was not diagnosed or repaired due to the cost. The manufacturer was not made aware of the failure. The failure mileage was approximately 45,000.

The start-stop system reports unavailable, then within a few miles of driving, the check engine light will come on, followed by problems with the transmission shifting gears, sometime causing the vehicle to stay in first or second gear while accelerating and creating a dangerous driving situation. Power cycling the vehicle sometimes helps. Diagnostic trouble codes show low voltage in one or more O2 sensors, "too lean" warnings and cylinders randomly misfiring. Engine runs very rough at idle with the strong smell of gas in the exhaust. Dash information shows battery voltage around 12.3 at start up increasing to low 13 while idling. This occured around 40,000 miles and dealer replaced the aux battery and reset system. It occurred again around 60,000 miles (20 months later) and owner replaced both auxiliary battery (testing showed bad) and main battery. System functioned normally after resetting codes. It occurred again about 8 months later at 72,000 miles. The F42 fuse was pulled, cleared codes and reset computer by removing battery power for 1 hour. System returned to normal.

On Friday, May 22, 2026, at approximately 59,442 miles, the vehicle's instrument panel cluster (IPC) failed suddenly and without warning. The vehicle was driven to a store in [XXX] , with the display functioning normally, but upon restarting the vehicle less than an hour later, the central information screen went completely blank. The screen remains permanently blank and fails to display any driver information. At night, turning the vehicle on causes the screen to emit a faint dark gray backlight, but no text, gauges, or data populate. This failure creates an immediate safety hazard. With a permanently blank cluster, I am forced to drive without access to a speedometer, fuel gauge, odometer, or critical vehicle warning and safety lights, severely impacting my ability to maintain safe speeds and monitor vehicle health on public roads. The vehicle was inspected on May 27, 2026, by an authorized Jeep dealership (Lopp Motors in Dodge City, KS). The technician confirmed the failure and noted: "INFO SCREEN BETWEEN TACH AND SPEEDO IS BLANK. NO CODES IN SYSTEM PERTAINING TO CONCERN. TECH TRIED TO RESET CLUSTER AND PERFORMED PROXI ALIGNMENT – WOULD NOT ALIGN. ATTEMPT A VEHICLE CONFIG RESTORE – STILL NO CLUSTER OPERATION. INSTRUMENT CLUSTER REQUIRES REPLACEMENT." This identical component failure is the subject of NHTSA Campaign 24V-652 (Jeep Recall 30B); however, my 2020 model year VIN is currently excluded due to manufacturer time-in-service parameters. The vehicle and the failed component are available for inspection upon request. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2020 Jeep Gladiator. The contact stated while driving at an undisclosed speed, the infotainment center display blinked on and off. The vehicle was taken to an independent mechanic where it was diagnosed with a failed instrument cluster panel. The vehicle was not repaired. The contact was advised to take the vehicle to the dealer. In addition, the contact was informed of a recall NHTSA Campaign Number: 24V652000 (Electrical System) however the contact's VIN was not associated. The manufacturer was not made aware of the failure. The failure mileage was approximately 40,000.