2023 Jeep Compass

When driving on expressway at about 70 mph. Engine light comes on. Car loses acceleration. Start stop states it’s unavailable. Have to pull over on side of road and turn car off. Restart car and it drives normally with engine light on. Took it to a local dealership and they stated it need ed a software update. They then test drove the car and problem did not reoccur. The very next day while driving on the expressway again at about 70 mph. Same problem has occurred. The car has 26,996 miles on it as is still under warranty. How can a software update cause a car not to function while driving. If we would have been in a middle lane and unable to pull off on side of road we would have been required to stop and turn off car in the middle of the expressway.

At 2900 miles, my check engine light came on while I was on vacation out of state. Within a couple of seconds, my car started to choke and jerk so bad that the passenger could feel it. It did this intermittently, to the point I knew it needed to be seen before driving 900 miles home. Several times since then, my safety was put at risk due to my vehicle not accelerating when it should. I have had many cars almost hit me from behind when this has happened. Luckily, I have not yet. I took my vehicle to a Jeep dealer in Foley, Alabama because that is where I went for vacation. They looked at it ran the code and told me it was a stored code. I asked him what that meant and could I still drive the vehicle. He said the light should turn off in a few drive cycles. That did not happen. When I got back to North Carolina, I took my vehicle to the dealer I bought it from. I was at 4000 miles and the light was still on and the car was still choking out a lot. The service guy took it back, checked the code, and came back to tell me that the code read per Chrysler, “Do not try to repair vehicle, there is no known repair but we are working on it”. It has been over a month and nothing. However, my car seems to be getting worse.