IllustrationWIRE SHORTED OUT CAUSING ELECTRICAL FAILURES.
1996 International Harvester 3800
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all 3800 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 2 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Structure. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
Electrical System complaints
1 reportsOfficial recalls
396V239000 · Vehicle Speed Control:accelerator Pedal
Nov 27, 1996
VEHICLE DESCRIPTION: SCHOOL BUSES EQUIPPED WITH THE INTERNATIONAL I6 ELECTRONIC ENGINE AND AN EXTRA THICK BUS BODY FLOOR. THE ACCELERATOR PEDAL TO FLOOR CLEARANCE IS APPROXIMATELY 1.2 INCHES WITH A STANDARD BUS BODY FLOOR. HOWEVER, SOME CUSTOMERS ORDERED AN ADDITIONAL 3/4 INCH THICK FLOOR AND EXTRA THICK FLOOR MATS TO SERVE AS INSULATION IN COLD CLIMATES. WHEN THIS EXTRA FLOORING IS USED, THE BOTTOM EDGE OF THE ACCELERATOR PEDAL, WHEN DEPRESSED, CAN COME IN CONTACT WITH THE FLOOR.
Consequence & remedy
Consequence: SHOULD THE ACCELERATOR PEDAL CONTACT THE FLOOR, THE PEDAL COULD GET CAUGHT AND NOT RETURN TO THE IDLE POSITION INCREASING THE RISK OF A VEHICLE ACCIDENT.
Remedy: DEALERS WILL INSPECT THE FLOORING ON THESE BUSES TO INSURE THERE IS A MINIMUM OF 1/4 INCH CLEARANCE. ON BUSES WITH LESS THAN 1/4 INCH CLEARANCE, THE DEALER WILL REMOVE THE PEDAL AND CUT OFF THE BOTTOM OF THE PAD TO OBTAIN THE PROPER CLEARANCE.
96V174000 · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip
Sep 13, 1996
THE WIRING FROM THE ELECTRONIC CONTROL UNIT WAS CONNECTED TO THE WRONG WHEEL SENSOR OR TO THE WRONG BRAKE MODULATOR VALVE. IT IS POSSIBLE THAT EITHER OR BOTH WIRING MAY HAVE OCCURRED AT EITHER THE FRONT OR REAR AXLE OR BOTH AXLES.
Consequence & remedy
Consequence: SHOULD THE ANTI-LOCK BRAKING SYSTEM (ABS) WIRING BE CROSSED, IT WOULD RESULT IN A SIGNIFICANT DEGRADATION IN VEHICLE STOPPING DISTANCE. A SIGNAL WOULD BE SENT TO THE WRONG BRAKE CHAMBER WHEN A BRAKE IMBALANCE IS DETECTED. THIS CONDITION INCREASES THE RISK OF A VEHICLE ACCIDENT.
Remedy: DEALERS WILL INSPECT THE ABS WIRING AND, IF NECESSARY, PROPERLY CONNECT.
96V041000 · Wheels:hubcap/cover
Mar 1, 1996
THE FRONT WHEEL HUB CAN DEVELOP CRACKS AT THE WHEEL MOUNTING STUDS. WHEN MOUNTED TO THE HUB, THE HYDRAULIC BRAKE DISC ROTOR DOES NOT PROPERLY SUPPORT THE HUB AT THE WHEEL STUDS CAUSING EXCESSIVE STRESS AND FATIGUE CRACKS IN THE HUB.
Consequence & remedy
Consequence: SHOULD SUFFICIENT CRACKS OCCUR, THE MOUNTING FLANGE PORTION OF THE HUB ALONG WITH THE WHEEL COULD SEPARATE FROM THE VEHICLE WITHOUT WARNING. SHOULD THIS OCCUR WHILE THE VEHICLE IS DRIVEN, THE DRIVER COULD LOSE CONTROL OF THE VEHICLE AND/OR THE SEPARATED WHEEL AND HUB COULD STRIKE ANOTHER VEHICLE, PEDESTRIAN OR PROPERTY.
Remedy: DEALERS WILL INSTALL NEW, REDESIGNED HUBS ON THESE VEHICLES.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.