2016 Hyundai Tucson

The engine in this 2016 Hyundai Tucson has experienced progressive failure symptoms consistent with the known rod bearing defect covered under Hyundai's engine warranty extension campaign. Symptoms include: excessive oil consumption requiring frequent top-offs over several months, severely degraded acceleration, failure to upshift under load, and an audible metallic crunching noise occurring around 4,000 RPM. A knock sensor fault code (P1326) was previously triggered (on 2/16/26), confirmed by a mechanic (on 2/17/26), and cleared. The dealer was visited (on 2/17/26) and refused to perform the campaign repair, stating no active code was present at that time. The vehicle is available for inspection. The problem has not been confirmed by the dealer despite a visit; the dealer declined to act citing absence of an active code. The vehicle has not been inspected by police or insurance. Warning symptoms include the prior knock sensor code, oil consumption, loss of power, and the current mechanical noise. Symptoms first appeared several months ago and have progressively worsened. The dealer's refusal to act under the existing campaign despite documented symptoms has left this vehicle in a dangerous condition on public roads.

The contact owns a 2016 Hyundai Tucson. The contact stated that while driving at an undisclosed speed, there was an abnormal sound coming from the engine compartment. Moments later, the vehicle stalled after driving a very short distance. An independent mechanic arrived at the residence to perform an oil change and found metal shavings inside the oil. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 94,000.

Hyundai Tucson Sport 2016 GDI engine. I am the original owner of this truck I have taken care of this truck so much it being my first brand new purchase. No oil leaks NOTHING! When I first purchased the vehicle I noticed that it would stall when I would accelerate but did not think too much of it since it was brand new. A few years passed started to notice frequent oil changes were supposed to be made. Another few years turbocharger went out had to get it replaced. The engine consumes so much oil at first I thought it was because the turbocharger was out so when I got it fixed I thought that would fix that issue and it didn’t. I got an oil change March 2, 2026 and on March 21, 2026 I was on the highway and the truck started to shake really bad I exited the highway went straight to the oil place they said I had no oil on the dipstick I got ANOTHER oil change (expensive) and when I turned on the car to leave the car shook again and the engine light was flickering on and off and finally stayed on the dash board. Barely made it home. Got a tow truck to tow it to Hyundai dealership they told me they will not see it unless I pay the diagnostic fee of $200 and even then they think it’s the engine with everything I described to them. They said since there are no recalls on the Tucson that Hyundai will not do anything for me I would have to pay out of pocket for everything. Had to pay the tow truck again to tow it to my house ($250). My car has all the symptoms all the other cars have that they have recalled. This is a huge safety issue because i drive on the highway a lot and everyone knows a car with no oil is extremely dangerous.

I am writing regarding the diagnosis provided for my vehicle [XXX] . I was informed today that the engine failure is being attributed to a "water hose failure" rather than the engine defects covered under the active safety recall/settlement regarding Connecting Rod Bearing failure. As there were no coolant leaks before or after the vehicle was towed to your dealership. I am formally requesting a re-evaluation and more detailed evidence. Given the known history of these engines seizing, I need to ensure this diagnosis is absolutely correct and not a symptom of the internal defect. I request the following information be provided immediately: 1. Evidence of Overheating: Did the vehicle store any specific "overheating" codes in the ECU prior to the engine shutting off? 2. Oil Pan Inspection: Has the oil pan been removed to inspect for metal shavings or debris? If the connecting rod bearings failed (the recall issue), there will likely be metallic debris in the oil, regardless of the condition of the water hose. 3. Bearing Clearance Test (BCT): Was the mandated Bearing Clearance Test performed? If not, I request that this be done, or that a teardown be performed to inspect the rod bearings specifically. 4. Causal Link: Can you provide evidence that the water hose failed causing the engine to seize, rather than the engine seizing causing a pressure spike that damaged the cooling system? I have no transportation to work and school. They would not honor a loaner. This has happened since Decemeber of 2025. I await your written response with the requested photos and technical data. My case # with Hyundai Consumer Affairs # XXX Please provide: All relevant photographs Freeze-frame and ECU data Technician diagnostic notes Results of oil pan inspection and/or BCT (if performed) Any physical evidence supporting the stated cause of failure I request this information be sent in writing at your earliest convenience. Thank you for your attention to INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U

Vehicle: 2016 Hyundai Tucson Issue Category: Engine / Powertrain / Vehicle Safety Complaint: I am reporting a serious safety issue involving my 2016 Hyundai Tucson equipped with a Theta II engine. My vehicle first displayed an engine oil warning light. I immediately took the vehicle to an authorized Hyundai dealership, where I was charged approximately $500 for an oil change and diagnostic testing. I was told there were no issues with the vehicle. Within approximately 20 miles of leaving the dealership, the vehicle suddenly entered limp mode while driving and displayed diagnostic code P1326. This created a dangerous situation as the vehicle lost power unexpectedly. I returned the vehicle to the dealership, where a software update was performed. However, within another 20–30 miles, the exact same issue occurred again, with the vehicle entering limp mode and triggering code P1326. Hyundai has now refused to repair the engine under warranty and is attempting to attribute the issue to a catalytic converter problem, despite the presence of code P1326, which is associated with engine rod bearing failure and is part of a known defect affecting these vehicles. This condition presents a significant safety risk, as the vehicle can lose power suddenly while driving, increasing the risk of a crash. I believe this issue is directly related to the known Hyundai Theta II engine defect, which has been the subject of recalls and a class action settlement. I am requesting that NHTSA investigate Hyundai’s handling of these failures and their refusal to repair vehicles experiencing known engine defects that pose a safety risk

The transmission began slipping and hesitating within days of purchase. The vehicle intermittently fails to accelerate when pressing the gas pedal, especially when pulling into traffic or crossing intersections. This creates a serious safety risk because the vehicle does not respond when needed, leaving me exposed to oncoming traffic. The issue is intermittent and does not always trigger warning lamps or fault codes. The problem has been reproduced multiple times by me while driving under normal conditions. The selling dealer performed only a brief test drive and stated they could not duplicate the issue, but the hesitation and failure‑to‑accelerate continue to occur. The vehicle has not yet been inspected by Hyundai, but the symptoms match known issues with the 2016 Tucson’s dual‑clutch transmission and TCM logic. There were no warning lights prior to the failure, and the symptoms first appeared within the first week of ownership. The vehicle is available for inspection upon request.

"On [XXX], my 2016 Hyundai Tucson (VIN [XXX] ) experienced severe engine power loss and mechanical noise under load while driving uphill, creating a dangerous safety situation. This occurred 2 days after a dealer visit (February 19, 2026) where an open KSDS Service Campaign (TSB HCE22-14-E600-TL, Issue 10D021) — directly related to engine monitoring — was left incomplete. The dealer subsequently denied an engine evaluation citing mileage over 150,000, despite the open campaign having no mileage restriction and despite a prior verbal commitment to cover repairs. Multiple follow-up attempts by phone, email, and WhatsApp have been ignored." INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Excessive oil consumption caused engine failure on December 17, 2025. My truck stopped and I was stranded on Highway I55 South for 4 hours. Hyundai and the Extended warranty has denied fixing my truck. It is still at [XXX] Hyundai as of today. Hyundai’s failure to properly diagnose or repair this issue when it was first reported under warranty has caused financial burden, diminished vehicle value, loss of use and inconvenience, and emotional distress and stress. This is a legitimate safety concern. I am demanding resolution of an ongoing excessive oil consumption defect in my 2016 Hyundai vehicle. This defect began while the vehicle was under warranty and has continued despite proper maintenance and compliance with Hyundai’s service requirements. I expect Hyundai to honor its legal and contractual obligations without further delay. Please contact [XXX] [XXX] Hyundai) @ [XXX] for details regarding repairs, oil consumption tests, etc. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The engine, specifically cylinder # 3, has had a catastrophic failure at 114,000 miles. Engine repair shops and engine experts have determined the only fix is a complete engine replacement. Cost estimates are $8500 for a new engine + labor estimated at $2000. Scrap value is estimated at $1000 - $1500 The dealer from whom we bought the car in late 2015 said it is out of warranty. This is unacceptable. Please, please issue a recall on the engine of this vehicle. The vehicle is available for inspection if requested. Failure was catastrophic Problem has been confirmed by engine experts The car is not drivable to a manufacturing facility The engine has not been inspected by police nor our insurance company There we no warning lamps or messages Symptoms include shuddering at initial acceleration beginning at 75,000 miles Dealer said there was no problem and recommended and performed a transmission fluid change

The contact owns a 2016 Hyundai Tucson. The contact stated that the check engine warning light was illuminated, and there was a ticking sound coming from the front of the vehicle. The vehicle was taken to Auto Zone, where a mechanic diagnosed the vehicle with a knock sensor failure. The knock sensor was replaced. The mechanic informed the contact that the vehicle was included in Manufacturer Campaign: CS966 for the transmission control module (TCM). The vehicle was taken to the dealer, who confirmed that the vehicle was included and the software update was performed. After the vehicle was repaired, the check engine warning light was no longer illuminated; however, approximately 30 minutes later, the vehicle failed to exceed 35 MPH, and the check engine warning light started flashing. The vehicle was returned to the dealer, and the contact was informed that the software update caused the vehicle to enter LIMP Mode to protect the engine. The dealer informed the contact to drive the vehicle for 30 days or a total of 500 -1000 miles, and if the vehicle continued to enter LIMP Mode or failed to operate as needed, to return the vehicle for the engine to be replaced. There were no additional repairs performed. The manufacturer was not informed of the failure. The failure mileage was approximately 125,000.