IllustrationREAR DRIVE SIDE FLANGE BEARING TOTAL FAILURE 4 TIMES BEFORE 30000 MILES. BEARINGS TOTALLY GROUND DOWN AND ROUGH. T $220.00 A POP, IT IS BECOMING EXPENSIVE AND AN IMMINENT DANGER TO ALL RIDERS. *JS
2003 Honda VTX1800
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all VTX1800 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
310–25K
1025–50K
050–75K
075–100K
0100–150K
0150K+
41 reports with mileage · 12 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Power Train. Review the 18 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Suspension. Review the 17 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Wheels. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports0 fire reports0 injury reports
Power Train complaints
18 reportsREAR TIRE WAS WORN OUT UPON REPLACING TIRE I INSPECTED BEARINGS AND THEY FELL OUT. ORDERED NEW BEARINGS ON LINE AND REPLACED THEM. *TR
I WAS REMOVING REAR WHEEL ON MY 2003 HONDA VTX C MODEL TO REPLACE WORN TIRE AND WITH THE WHEEL OFF I DID A CHECK OF THE WHEEL BEARINGS. I FREQUENTLY VISIT THE HONDA VTX OWNERS SITE TO KEEP UP ON MAINTENANCE ISSUES AND HAVE FOUND THAT MANY OTHER OWNER HAVE HAD A FAILURE OF THIS ONE PARTICULAR BEARING ASSEMBLY REFERRED TO AS " FIN…
Read full complaint
I WAS REMOVING REAR WHEEL ON MY 2003 HONDA VTX C MODEL TO REPLACE WORN TIRE AND WITH THE WHEEL OFF I DID A CHECK OF THE WHEEL BEARINGS. I FREQUENTLY VISIT THE HONDA VTX OWNERS SITE TO KEEP UP ON MAINTENANCE ISSUES AND HAVE FOUND THAT MANY OTHER OWNER HAVE HAD A FAILURE OF THIS ONE PARTICULAR BEARING ASSEMBLY REFERRED TO AS " FINAL DRIVEN FLANGE A , HONDA PART NUMBER 42630-MCH-000. I DID A CHECK OF THE BEARING AND FOUND THAT IT WOULD BARELY ROTATE, IT HAD COMPLETELY FAILED. CONSIDERING THIS IS ON A MOTORCYCLE, I THINK THIS IS A SERIOUS SAFETY ISSUE. I HAVE ORDERED A NEW PART FROM HONDA AND I HOPE THAT THEY HAVE ADDRESSED THIS MANUFACTURING DEFECT. *TR
FLANGE BEARING ON MOTORCYCLE FINAL DRIVE ENGAGEMENT FELL APART AFTER 9500 MILES. *TR
HONDA VTX DRIVE FLANGE BEARING FAILURE. REPAIRED AT HOME. NO ACCIDENT. *TR
(1)VIBRATION IN REAR WHEEL OF HONDA VTX1800C 2003 (2)UPON DISASSEMBLY OF REAR WHEEL, BEARINGS IN THE SPLINE FLANGE WERE FOUND TO BE TOTALLY DISINTEGRATED. ALTHOUGH THE BEARINGS HAD NOT YET WELDED THEMSELVES TOGETHER. (3)MOTORCYCLE HAD HONDA WARRANTY, HONDA REFUSED TO REPAIR,FIXED MYSELF. STILL HAVE OLD PARTS. *NM
(1) 2003 HONDA VTX 1800C MOTORCYCLE REAR DRIVEN FLANGE BEARING FAILURE. WHEN REMOVING TIRE/WHEEL ASSEMBLY FOR TIRE REPLACEMENT, (2) I DISCOVERED THE SMALL BEARINGS PRESSED INTO THE DRIVEN FLANGE (MOUNTED ON REAR WHEEL) WERE VERY ROUGH AND HARD TO SPIN, USING MY INDEX FINGER IN THE AXLE HOLE. I REMOVED THE FLANGE FROM THE WHEEL…
Read full complaint
(1) 2003 HONDA VTX 1800C MOTORCYCLE REAR DRIVEN FLANGE BEARING FAILURE. WHEN REMOVING TIRE/WHEEL ASSEMBLY FOR TIRE REPLACEMENT, (2) I DISCOVERED THE SMALL BEARINGS PRESSED INTO THE DRIVEN FLANGE (MOUNTED ON REAR WHEEL) WERE VERY ROUGH AND HARD TO SPIN, USING MY INDEX FINGER IN THE AXLE HOLE. I REMOVED THE FLANGE FROM THE WHEEL AND DISCOVERED THE BEARING SEAL MISSING, PROBABLY CHEWED UP; THE CAGE THAT SPACES THE BALL BEARINGS HAD DISINTEGRATED INTO LITTLE PIECES AND HAD BEEN EXPELLED FROM THE BEARING/SLEEVE AREA ONTO THE MAIN REAR AXLE BEARING (WHICH IS STILL OKAY); THE TWO BEARINGS INSIDE THE FLANGE WERE ROUGH AND FELT LIKE THEY RATCHETED INSTEAD OF TURNING SMOOTHLY. (3) I PRESSED THEM OUT, MEASURED THE HOUSING BORE, CLEANED IT AND SLIGHTLY ENLARGED (APPROX 0.0005 IN.) THE BOTTOM OF THE BORE WITH MACHINE TOOLS AND SANDING DRUMS TO WHERE THE NEW BEARINGS ARE A PRESS FIT WITHOUT BINDING -- THE ORIGINAL BORE SEEMED SLIGHTLY TAPERED -CONE SHAPED- AND CAUSED THE OUTER BEARING RACE TO PINCH DOWN ON THE BALLS AND REMOVE ANY CLEARANCE BUILT INTO THE BEARING, CAUSING THE RATCHETING FEELING. REFERRED TO THIS SITE BY VTXOA (VTX OWNER'S ASSOCIATION) WEBSITE. *JB
REAR AXLE BUSHING/BEARING FAILURE. 1 OF THE 2 BEARINGS HAD FAILED. I FOUND THIS BY PURE LUCK CHANGING MY REAR TIRE. THIS WAS DISCOVERED IN PREPARATION FOR A LONG WEEKEND RIDE TO THE HONDA GATHERING AT THERE FACTORY. I PURCHASED NEW BEARINGS FOR $54 A PIECE. AND REPLACED THEM MYSELF . *NM
2003 HONDA VTX1800R MOTORCYCLE REAR DRIVE UNIT BEARING FAILURE. THE MOTORCYCLE WAS TWO YEARS OLD WITH 20K MILES ON IT. DURING A ROUTINE REAR WHEEL REMOVAL, THE TWO RADIAL BALL BEARINGS P/N: 6304UU (20X47X20.9) (TOYO) WERE FOUND TO BE SEVERELY DAMAGED, MISSING BEARINGS ETC.... THIS IS THE SECOND TIME THIS HAS HAPPENED. THIS CAN R…
Read full complaint
2003 HONDA VTX1800R MOTORCYCLE REAR DRIVE UNIT BEARING FAILURE. THE MOTORCYCLE WAS TWO YEARS OLD WITH 20K MILES ON IT. DURING A ROUTINE REAR WHEEL REMOVAL, THE TWO RADIAL BALL BEARINGS P/N: 6304UU (20X47X20.9) (TOYO) WERE FOUND TO BE SEVERELY DAMAGED, MISSING BEARINGS ETC.... THIS IS THE SECOND TIME THIS HAS HAPPENED. THIS CAN RESULT IN A CATASTROPHIC REAR DRIVE FAILURE WHILE OPERATING THE MOTOR VEHICLE WITH DEATH AND INJURY AS A POSSIBLE RESULT ALSO WHO EVER IT WAS AT HONDA REPORTING THE VTX TO HAVE 106HP SHOULD BE FLAGGED FOR A FLAT OUT LIE. *JB
WHILE REPLACING REAR TIRE ON MY VTX 1800C I NOTICED THE FLANGE BEARING WAS ROUGH,THE LOCAL DEALER REPLACED IT UNDER WARRANTY. NO ACCIDENTS OR DAMAGE. *NM
Official recalls
0No recalls in this snapshot.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.