2009 Honda Civic

EXCESSIVE TIRE WEAR COMING FROM BOTH BACK TIRES.THEY BOTH WEAR FROM THE INSIDE. HAD NEW TIRES PUT ON CAR,THEY BOTH ARE ALREADY WEARING ON INSIDE. HONDA DID AN ALIGNMENT WHEN TIRES WERE NEW. THESE TIRES WERE ROTATED TO THE FRONT AND NOW I GETTING EXCESSIVE ROARING SOUND IN THE FRONT AND VIBRATION WHEN AT SLOWER SPEEDS.CAR ALSO NOW PULLS TO THE LEFT. TOOK CAR BACK TO HONDA AND THEY SAID THEY FIND NO PROBLEMS. *TR

AFFECTED PARTS ON THE ONLINE FORM DOES NOT LIST "TIRES". LIKE MANY OTHER COMPLAINTS I DETECTED EXTREME UNEVEN WEAR ON THE REAR TIRES. WHEN I TOOK MY VEHICLE TO A TIRE CENTER THE GUY SAID THAT THIS IS A KNOWN ISSUE WITH THIS CAR. HE SAID THAT THERE IS NO RECALL AND THAT I COULD GO TO A HONDA SERVICE CENTER AND HAVE A WEDGE INSTALLED THAT WOULD PREVENT THIS WEAR. SINCE THIS IS NOT A RECALL ITEM I WOULD HAVE TO PAY OUT OF POCKET. I HAVE NOT PURSUED THIS WEDGE BUT IN MY OPINION EXTREME UNEVEN WEAR DUE TO A KNOWN MECHANICAL ISSUE IS A SAFETY PROBLEM AND THERE SHOULD BE A RECALL TO INSTALL THIS WEDGE AT NO EXPENSE. *TR

I HAD UNEVEN WEAR ON MY TIRES AND HAD AN ALIGNMENT ACCOMPLISHED BY A CERTIFIED MECHANIC AT FIRESTONE. AFTER SEVERAL ATTEMPT TO ALIGN THE CAMBER ON THE RIGHT BACK REAR TIRE THEY WERE FORCED TO LEAVE IT AT -1.7...WHICH IS .02 OUT OF TOLERANCE. THE CAMBER ADJUSTMENT ARE IS IN PROPER WORKING ORDER BUT THE MECHANIC SAYS THIS IS A CONSTANT PROBLEM WITH 2006-2009 HONDAS DUE TO THE ARMS DESIGN. THIS IS A SERIOUS PROBLEM THAT CAN CAUSE STEERING, SUSPENSION, AND TIRE WEAR ISSUES. *TR

BACK ON 3/30/13, I HAD MY VEHICLE IN FOR SERVICE, AND MY TPS LIGHT WAS ON, AS IT TYPICALLY CAME ON FOR TIRE PRESSURE. I DIDN'T THINK ANYTHING OF IT PREVIOUSLY, AS WE WOULD ALWAYS JUST ADD AIR AS NEEDED. HOWEVER, THE TIRE PRESSURE WAS LOWER THAN USUAL. SO WE HAVE BEEN MONITORING IT MORE CLOSELY. I LIVE IN NEW ENGLAND AND PUT 4 SNOW TIRES ON AROUND NOVEMBER AND REMOVE THEM AROUND APRIL. I PURCHASED THE 2009 HONDA CIVIC AS A LEFT OVER IN JAN 27, 2010. I PURCHASED 4 BLIZZAK SNOW TIRE IN 1/10, 2 TIRES IN 4/12, 2 MORE BLIZZAK SNOW TIRES IN 11/13, AS THEY WERE WORN, 2 MORE TIRES IN 4/14 AND WILL BE PURCHASING 2 MORE BLIZZAK SNOWS THIS WINTER. I ONLY HAVE 45,244 MILES ON THE VEHICLE. RECENTLY, I HAVE HAD AN ISSUE REQUIRING THE REAR TIRES TO BE PATCHED. ON 5/22/14, THE TPS LIGHT WAS ON, SO I WENT TO THE GARAGE ON MY WAY TO WORK TO GET SOME AIR. ON 5/23/14, THE LIGHT CAME BACK ON SO I STOPPED AGAIN, THEY LOOKED AT THE TIRES AND FOUND I HAD A LEAK, REQUIRING A PATCH. IN AUGUST, THE SAME ISSUE. THE LIGHT CAME ON, FILLED WITH AIR, ONLY IT DIDN'T COME BACK ON UNTIL 5 DAYS LATER. STOPPED AT THE GARAGE CLOSER TO MY OFFICE AND I NEEDED 2 PATCHES IN BOTH REAR TIRES. ONE OF WHICH WAS PATCHED 6 MONTHS AGO. THE LIGHT JUST CAME ON AGAIN LAST WEEK AND WHILE I WAS FILLING UP WITH AIR (THE PSI WAS 27 IN BOTH REARS AS THEY SHOULD BE 32), THERE WAS ANOTHER HONDA CIVIC BEHIND ME WITH THE SAME ISSUE. NEEDING AIRS AND ALREADY HAD A PATCHED TIRE. THIS IS GETTING REALLY EXPENSIVE, AS WELL AS RIDICULOUS! MY FATHER HAS A HEART CONDITION AND I DON'T NEED TO WORRY ABOUT FAULTY TIRES IF IN CASE OF AN EMERGENCY! *TR

WE HAVE HAD TO REPLACE AN INCREDIBLE NUMBER OF TIRES, INCLUDING MICHELINS, DUE TO VERY IRREGULAR WEAR AND EXTREME VIBRATION, BEGINNING WITH OUR FIRST SET OF TIRES IN 2009. THE REAR END HAS BEEN THE WORST, WHERE ONE WOULDN'T THINK GREAT TIRE WEAR AND FLAT SPOTS ETC. WOULD BE NORMAL -- AS WE ARE VERY BUSY PEOPLE AND LIVE IN A RURAL AREA, WE HAVE JUST PUT ON NEW TIRES, GOT REPEATED ALIGNMENTS, AND MOVED ON ETC. FINALLY, OUR LOCAL MECHANIC HAS FINALLY ADVISED US JUST A FEW DAYS AGO OUR PROBLEMS HAVE BEEN DUE TO THE CONTROL ARM INTERACTION WITH TIRES ISSUE FROM THE FACTORY, THAT HAVE REPORTEDLY OCCURRED WITH THIS 2009 HONDA CIVIC MODEL (THAT HE WOULD SOLVE WITH NEW CONTROL ARM ASS'Y AND ALIGNMENT FOR $842.29). *TR

I BOUGHT A SET OF CONTINENTAL PROCONTACT TIRES 205/55/16 FOR A HONDA CIVIC. ON 12-12-13 AND DROVE TO HARRISONBURG VA ABOUT 200 MILES ON 12-17-13. THAT NIGHT THE TIRE PRESSURE INDICATOR LIT UP SINCE IT WAS LATE WE WAITED UNTIL MORNING TO CHECK THE TIRE AT WHICH TIME IT WAS FLAT. EMBEDDED IN THE TIRE WAS A WIRE GOING FROM NEAR THE WHEEL ALONG THE SIDEWALL TOWARD THE TREAD. IT WAS ABOUT 5 INCHES IN LENGTH AND ABOUT 0.125 INCHES IN DIAMETER. BOTH ENDS WERE IN THE TIRE AND THERE APPEARED TO BE A SLICE IN THE SIDEWALL BENEATH THE WIRE. WENT TO WALMART WHERE THE TIRE WAS EXAMINED, THEY PULLED ONE END OUT BUT THE OTHER DIDN'T BUDGE. HAD TO GO TO ANOTHER STORE FOR THE REPLACEMENT. THEY WERE ALSO NOT ABLE TO PULL THE WIRE OUT. UPON RETURNING HOME I TOOK THE DAMAGED TIRE TO THE STORE IT WAS ORIGINALLY PURCHASED FROM. THEY CONTACTED CONTINENTAL AND I RECEIVED A FULL REFUND AND THE TIRE WAS RETURNED TO CONTINENTAL. UPON EXAMINATION IT SEEMED THAT THE WIRE WAS EMBEDDED IN THE TIRE DURING MANUFACTURE AS EVIDENCED BY THE "SLICE" IN THE SIDEWALL FROM WHICH THE WIRE EMERGED WHILE DRIVING LEADING TO AIR LOSS, THE IMPOSSIBILITY OF PULLING THE WIRE FROM THE WHEEL AREA AND THE ABSENCE OF PENETRATION OF THE WIRE ON THE WHEEL ASPECT.. I DO HAVE PHOTOS OF THE WIRE AND SIDEWALL AND TIRE INTERIOR SHOWING THE ABOVE. MY STRONG FEELING, AND THAT OF THE ORIGINAL TIRE SHOP, WAS THAT THE WIRE WAS MOLDED INTO THE TIRE DURING MANUFACTURE. THE DIAMETER OF THE WIRE WAS MUCH GREATER THAN STEEL MESH WIRE. MOST LIKELY THE WIRE WAS FORCED TO THE SURFACE AS A CONSEQUENCE OF TIRE COMPRESSION DURING THE DRIVE. I ALMOST FEEL THAT IT WAS INTENTIONALLY ADDED TO THE MOLD BECAUSE OF THE LENGTH AND POSITION AS WELL AS THE DIAMETER. *TR

MY VEHICLE WAS AT MY MECHANICS FOR AN OIL CHANGE. PART OF THEIR SERVICE IS TO CHECK THE TIRE PRESSURE. A TIRE WAS A LITTLE LOW. UPON PLACING THE AIR CHUCK ON THE VALVE STEM, THE VALVE STEM EXPLODED. POTENTIAL DAMAGE TO THE CAR AND THE PERSON WHO WOULD BE ADDING AIR WAS LUCKILY AVOIDED. HONDA HAD IN JULY 09 (SAME MONTH WE PURCHASED THIS CAR) ISSUED A SERVICE BULLETIN CONCERNING USING ONLY A SHALLOW AIR CHUCK ON CIVICS AS THEY MIGHT EXPLODE. HONDA AND THE DEALERSHIP BOTH REFUSED TO REPAIR AT NO CHARGE. CLAIMING THAT THE MECHANIC WAS AT FAULT. NOTE THAT THE MECHANIC WHO WAS OPERATING THE PROPER AIR CHUCK AT MY REPAIR SHOP IS HONDA CERTIFIED AND ONLY USED A SHALLOW AIR CHUCK. HONDA HAS A PRINTED BROCHURE IN THEIR SHOW ROOM THAT EXPLICTLY STATES THAT A DRIVER MUST GO TO A DEALERSHIP OR ANYWHERE THAT AIR IS AVAILABLE AND FILL TO THE PROPER PRESSURE WHEN THE TPMS LIGHT COMES ON. MOST AIR FILL PLACES AT GAS STATIONS HAVE THE LONG HANDLE VERSION OF THE AIR CHUCK, WHICH IN THE SERVICE BULLETIN IS STRICTLY PROHIBITED! NOT ONLY DID HONDA REFUSE TO REPAIR AT NO CHARGE, THEY ALSO CHARGED US FOR A FRONT END ANALYSIS. $175.00 BECAUSE OF A KNOWN DEFECTIVE PART. MY WIFE REFUSED TO DRIVE THE CAR ON THE INTERSTATE OR TO GO ABOVE 50 MPH AFTER THAT BECAUSE OF THE POTENTIAL OF A ROCK OR SOME OTHER OBJECT HITTING THE VALVE STEM. WE HAD MANY TRIPS WHERE WE HAD TO USE MY 1990 JEEP INSTEAD OF THE HONDA AT EXTRA EXPENSE. WE RECENTLY WERE FINALLY ABLE TO GET RID OF THE HONDA AND PURCHASED A 2013 HYUNDAI ELANTRA LIMITED. WE WERE NOT WANTING TO PURCHASE A NEW CAR FOR AT LEAST ANOTHER TWO YEARS. THE POTENTIAL FOR VEHICLE DAMAGE, AND EVEN MORE IMPORTANT TO THE PERSON PUTTING AIR IN A TIRE IS TREMENDOUS. ALSO, WHAT ABOUT A BLOW OUT, AND THEN A WRECK. ALL FOR AN INEXPENSIVE PART. WE WILL NEVER OWN ANOTHER HONDA IF THEY ARE SO BLATANTLY WILLING TO DISREGARD THEIR OWN FINDINGS. *TR

TL* THE CONTACT OWNS A 2009 HONDA CIVIC. THE VEHICLE WAS EQUIPPED WITH BRIDGESTONE TURANZA EL400 TIRES, SIZE 205/55/R16. THE CONTACT WAS DRIVING APPROXIMATELY 60 MPH AND FELT A SEVERE VIBRATION ACCOMPANIED BY A WHINING NOISE FROM THE REAR OF THE VEHICLE. THE VEHICLE WAS TAKEN TO THE DEALER WHERE THE CONTACT WAS INFORMED THAT BOTH THE REAR DRIVER AND PASSENGER TIRES WERE OUT OF ROUND AND EXHIBITED SIGNIFICANT CUPPING. THE MANUFACTURER WAS NOTIFIED OF THE PROBLEM. THE APPROXIMATE FAILURE MILEAGE WAS 17,000. THE DOT NUMBER WAS 0BT2 PM23208 UPDATED 05/08/12*LJ THE CONSUMER HAD ALL FOUR TIRES REPLACED.