IllustrationBRAKE ON PASSENGER SIDE REAR OF 2007 HOLIDAY RAMBLER MOTOR HOME HUNG UP AND BECAME VERY HOT. THE CHASSIS IS WORKHORSE AND COULD BE 2006. *TR
2007 Holiday Rambler Admiral
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Admiral years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 2 of 3 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Structure. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
Service Brakes, Hydraulic complaints
1 reportsOfficial recalls
207V016000 · Electrical System: Instrument Cluster/panel
Jan 24, 2007
ON CERTAIN MOTOR HOMES, AN INCORRECT SCREW WAS USED TO INSTALL THE BLACK AND WHITE CRT BACK-UP MONITOR IN THE DASH. THE INCORRECT SCREWS ARE 1/4" LONGER THAN SPECIFIED AND MAY CONTACT A PC BOARD INSIDE THE MONITOR WHICH COULD POTENTIALLY HIT A HIGH VOLTAGE CIRCUIT ON THE PC BOARD OF APPROXIMATELY 10,000-13,000 VOLTS.
Consequence & remedy
Consequence: IF THE SCREW MAKES CONTACT WITH THE HIGH VOLTAGE TRACER ON THE PC BOARD AND SOMEONE WOULD TOUCH THE SCREW HEAD WHILE THE POWER IS ON, AN ELECTRICAL SHOCK COULD OCCUR CAUSING INJURY.
Remedy: DEALERS WILL INSPECT THE BACK-UP MONITOR TO VERIFY THE OPERATION OF THE MONITOR FREE OF CHARGE. IF THE MONITOR IS OPERATING PROPERLY, THE REPAIR WILL CONSIST OF REPLACING THE INCORRECT SCREW WITH THE SPECIFIED SCREW AND TESTING FOR PROPER OPERATION. IF THE MONITOR IS NOT OPERATING PROPERLY ON INITIAL INSPECTION, THE MONITOR WILL BE REPLACED USING THE CORRECT SCREW. THE RECALL BEGAN ON FEBRUARY 9, 2007. OWNERS MAY CONTACT MONACO AT 877-332-9239.
06V361000 · Engine And Engine Cooling
Sep 19, 2006
ON CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH GM 8.1L V8 ENGINES, IMPROPER HARDENING DURING THE HEAT TREATMENT PROCESS CAN CAUSE THE FUEL RAIL PULSE DAMPER RETAINER CLIP TO FRACTURE, RESULTING IN INADEQUATE RETENTION OF THE DAMPER. IF THE DAMPER BECOMES LOOSE, FUEL COULD BE PUMPED BY THE FUEL PUMP INTO THE UNDER HOOD AREA.
Consequence & remedy
Consequence: IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD RESULT.
Remedy: WORKHORSE IS HANDLING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN (PLEASE SEE 06V225). DEALERS WILL REPLACE THE FUEL RAIL PULSE DAMPER RETAINER CLIPS ON THESE ENGINES FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 877-294-6773 OR MONACO AT 1-800-685-6545.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.