Service Brakes. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Service Brakes, Hydraulic. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

2 crash reports0 fire reports2 injury reports

Service Brakes complaints

3 reports

Clear category filter

68,064 miles · Mar 27, 2018

Service Brakes

Read full complaint

TL* THE CONTACT OWNS A 2011 HARLEY-DAVIDSON FLHR (ROAD KING). THE CONTACT STATED THAT NHTSA CAMPAIGN NUMBER: 18V076000 (SERVICE BRAKES, HYDRAULIC) WAS PERFORMED ON MARCH 11, 2018 AT QUEEN CITY HARLEY-DAVIDSON (5960 DIXIE HIGHWAY FAIRFIELD, OHIO 45014 PHONE 513-874-4343) HOWEVER, THE REPAIR DID NOT CORRECT THE FAILURE. THE DEALER CAUSED DAMAGE TO THE ANTI LOCK BRAKE SYSTEM BY FAILING TO PUT THE MOTORCYCLE DATA PORT SERVICE PROCESS AS FOUND. THE MOTORCYCLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 68,064.

NHTSA ODI #11081438

64,000 miles · Apr 7, 2017

Service Brakes

Read full complaint

TL* THE CONTACT OWNS A 2011 HARLEY-DAVIDSON FLHR ROAD KING. WHILE DRIVING APPROXIMATELY 55 MPH APPROACHING A CONSTRUCTION TRAFFIC JAM, THE REAR BRAKE LOCKED UP WHEN APPLIED AND THE FRONTAL BRAKE LEVELER WAS VERY HARD TO APPLY. THE CONTACT HAD TO COAST BETWEEN THE LANES OF TRAFFIC UNTIL THE FRONTAL BRAKE ENGAGED AND CAME TO A STOP. THE CONTACT PUSHED THE MOTORCYCLE TO THE RIGHT LANE THAT WAS CLOSED DUE TO CONSTRUCTION. THE MOTORCYCLE WAS DRIVEN HOME SLOWLY. THE MOTORCYCLE WAS TAKEN TO THE DEALER WHERE IT WAS DIAGNOSED THAT THE HYDRAULIC CONTROL UNIT OF THE ABS FAILURE AND THE ENTIRE ABS HAD TO BE REPLACED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE MOTORCYCLE WAS AT THE DEALER BEING REPAIRED. THE APPROXIMATE FAILURE MILEAGE WAS 64,000. ...UPDATED 05/03/17 *BF *AS

NHTSA ODI #10971085

62,232 miles · Jun 5, 2015

Service BrakesCrash

Read full complaint

WHILE TRYING TO STOP AT A STOP SIGH THE FRONT BRAKES WOULD NOT WORK AT ALL AFTER GETTING STOPPED AND PARKING THE BIKE, THE BREAK LEVER WOULD NOT MOVE. AFTER SEVERAL ATTEMPTS PULLING ON THE BREAK IT LOOSENED UP SO I RODE BIKE TO REPAIR SHOP. EVERY TIME THE FRONT BREAK WOULD ENGAGE (WHICH WAS NOT EVERY TIME), IT WOULD CATCH AND LOCK UP THE FRONT TIRE CAUSING ME TO DROP THE BIKE ONCE. REPAIR SHOP SAID THE ENTIRE ABS SYSTEM WAS NOT WORKING. HARLEY CUSTOMER SERVICE SAID I WOULD HAVE TO ALLOW THEM TO FIX IF BUT THAT IT WOULD BE AT THEIR NORMAL RATE FOR PARTS AND SERVICE. I TOLD THEM THAT I WAS AWARE THEY HAVE RECALLED THE SAME BIKE FOR MANY YEARS BUT NOT FOR THE 2011 MODEL AND THAT IT APPEARS THAT IT IS THE EXACT SAME PROBLEM WITH THE OTHER BIKES THAT HAVE BEEN RECALLED. ANY HELP YOU CAN PROVIDE IS APPRECIATED.

NHTSA ODI #10723670

Official recalls

18V076000 · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip; Service Brakes, Hydraulic:fluid

Jan 29, 2018

Harley-Davidson Motor Company (Harley-Davidson) is recalling all 2008-2011 Touring, CVO Touring and VSRC motorcycles equipped with anti-lock brakes (ABS), including Road King (FLHR), Road King Police (EFI) (FLHP), Road King Police (EFI) (FLHPE), Electra Glide Standard Police (EFI) (FLHTP), Electra Glide Classic (EFI) (FLHTC), Electra Glide Ultra Classic (EFI) (FLHTCU) and Street Glide (EFI) (FLHX), 2008 VROD (VRSCAWA), CVO Road King 4 (FLHRSE4), Night Rod (VRSCDA), CVO Ultra Classic 3 (FLHTCUSE3), Night Rod Special (VRSCDXA), 2008-2010 Road King Classic (EFI) (FLHRC), 2008-2009 Road Glide (EFI) (FLTR) and Electra Glide Standard (EFI) (FLHT), 2009-2010 V-Rod (VRSCAW), 2009 CVO Ultra Classic (FLHTCUSE4) and CVO Road Glide 3 (FLTRSE3), 2009-2011 Night Rod Special (VRSCDX) and V-Rod Muscle (VRSCF), 2010 CVO Ultra Classic 5 (FLHTCUSE5) and CVO Street Glide (FLHXSE), 2010-2011 Electra Glide Ultra Limited (FLHTK) and Road Glide Custom (FLTRX), 2011 Road Glide Ultra 103 (FLTRU103), Street Glide 103 (FLHX103), Road King Classic 103 (FLHRC103), CVO Ultra Classic 6 (FLHTCUSE6), CVO Road Glide Ultra (FLTRUSE), Road Glide Custom 103 (FLTRX103), and CVO Street Glide 2 (FLHXSE2) motorcycles. Deposits may form on components within the brake system if the DOT 4 brake fluid is not replaced for a prolonged period of time beyond the 2-year maintenance schedule specified in the Owners Manual.

Consequence & remedy

Consequence: These deposits may cause a valve within the ABS Hydraulic Control Unit to stick, reducing braking ability and increasing the risk of a crash.

Remedy: Harley-Davidson will notify owners, and dealers will flush the entire brake system with new Platinum Label DOT 4 brake fluid, free of charge. The recall began on February 14, 2018. Owners may contact Harley-Davidson customer service at 1-800-258-2464. Harley-Davidson's number for this recall is 0171.

Additional source detail variants (2)

Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip

Consequence: These deposits may cause a valve within the ABS Hydraulic Control Unit to stick, reducing braking ability and increasing the risk of a crash.

Remedy: Harley-Davidson will notify owners, and dealers will flush the entire brake system with new Platinum Label DOT 4 brake fluid, free of charge. The recall began on February 14, 2018. Owners may contact Harley-Davidson customer service at 1-800-258-2464. Harley-Davidson's number for this recall is 0171.

Service Brakes, Hydraulic:fluid

Consequence: These deposits may cause a valve within the ABS Hydraulic Control Unit to stick, reducing braking ability and increasing the risk of a crash.

11V506000 · Exterior Lighting:brake Lights:switch

Oct 19, 2011

HARLEY-DAVIDSON IS RECALLING CERTAIN MODEL YEAR 2009-2012 TOURING, CVO TOURING AND TRIKE VEHICLES MANUFACTURED FROM JUNE 6, 2008, THROUGH SEPTEMBER 16, 2011. SEE THE ABOVE LIST FOR THE MODELS INCLUDED IN THE RECALL. THE REAR BRAKE LIGHT SWITCH MAY BE EXPOSED TO EXCESSIVE HEAT FROM THE EXHAUST SYSTEM.

Consequence & remedy

Consequence: THE EXCESSIVE HEAT MAY CAUSE THE SWITCH TO NOT ACTIVATE THE BRAKE LAMP OR ACTIVATE THE BRAKE LAMP WHEN NO BRAKE IS APPLIED AND/OR CAUSE A BRAKE FLUID LEAK AT THE BRAKE LIGHT SWITCH, AFFECTING REAR BRAKE PERFORMANCE. EITHER CONDITION MAY INCREASE THE RISK OF A CRASH.

Remedy: HARLEY-DAVIDSON WILL NOTIFY OWNERS, AND DEALERS WILL A INSTALL A REAR BRAKE LIGHT SWITCH KIT, FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN DURING OCTOBER 31, 2011. OWNERS MAY CONTACT HARLEY-DAVIDSON AT 1-414-343-4056.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE16009 · Sudden Brake Failure - Motorcycle

Opened Jul 6, 2016 · Closed Apr 23, 2018

Status: closed (inferred from source dates) · Service Brakes, Hydraulic:antilock/traction Control/electronic Limited Slip:control Unit/module

The Office of Defects Investigation (ODI) opened this investigation in July 2016 based on forty-three (43) Vehicle Owner Questionnaires (VOQ).During the course of this investigation ODI received a total of 145 VOQs related to the alleged defect on the subject motorcycles.Owners allege they experience a sudden and complete loss of brakes on one or both wheels.To better understand the cause of the braking issue on the subject motorcycles, ODI requested NHTSA's Vehicle Research and Test Center (VRTC) conduct inspections and testing of affected vehicle braking systems.Through its work, VRTC determined that deposits were forming on the valves in the Hydraulic Control Unit (HCU) of the Antilock Braking System (ABS). These deposits could prevent the proper function of the HCU and render the brakes ineffective.To understand why deposits were forming in the HCU, Harley Davidson completed an analysis of the Dow 460 brake fluid used as original equipment on the subject motorcycles and determined that it had stability issues if left in the brake system for an extended period of time.Harley Davidson found that if a brake fluid flush was not conducted as outlined in the owner?s manual for the motorcycles, and was left in the system for a period of time beyond their recommendation; deposits could form in the HCU.Through further testing, Harley Davidson identified an alternate, commercially available, brake fluid that did not have the same stability issues as the original fluid and could stop the proliferation of any current brake system deposits.ODI sent Information Request (IR) letters to Harley Davidson and Dow Chemical (the supplier of the brake fluid on the subject motorcycles) to collect information about the subject bikes and the alleged defect.Harley Davidson responded in full on Sept 30, 2016 and Dow responded with a confidential submission on October 25, 2017.ODI analyzed the information contained in both IR responses and concluded that motorcycles manufactured during Model Years (MY) 2008, 2009, 2010, and 2011 were failing at a rate greater than their peers.Based on this analysis and the brake fluid study conducted by Harley Davidson, a group of motorcycles was identified that were potentially affected by the instability of the original brake fluid.2008 marked the introduction of ABS on Harley Davidson motorcycles and a change in the Dow 460 brake fluid used in the 2012 MY vehicles provided the bases for the scope of the affected population.With recall action 18V-076 taken by Harley Davidson this investigation is closed as further use of agency resources does not appear to be warranted.The ODI reports cited above can be reviewed at: https://www.nhtsa.gov/ using the complaint identification numbers attached to this resume.