2026 GMC Yukon

While traveling on [XXX] from Houston back to San Antonio, my truck engine just blew up without any warning whatsoever. We purchased the truck with 3 miles on it, and we have only put 5,000 miles on it. New cars that cost early $100K shouldn’t be having engine failures like this. I’m lost for words now! INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

My yukon denali ultimate had only 3,788 miles on it and on 7/27 while merging onto a highway my vehicle made a sound like it was trying to shift into gear but couldn't and then while I'm pressing the accelerator pedal it's slowing down. There were tractor trailer and vehicles speeding up behind me but I couldn't speed up and I was able to pull over on the shoulder luckily and I'm thankful it did not cause an accident. My yukon would not start no matter what I tried and I ended calling a tow truck and had it towed to my local GMC delearship where I was informed that the engine had seized and they would order a new replacement engine. My yukon is still sitting at the dealership waiting for the repair.

GMC should be haulted from selling trucks with the 6.2L engine. My brand new 2026 GMC Yukon Denali engine imploded on the Interstate going 75mph that nearly killed my entire family. No warning, just out of no where died on the highway, with 4K miles on it. This is sadly going to get someone critically injured and when is enough going to be enough? GMC has some explaining to do, when they charge $85K-$100K for trucks that blow up as soon as you buy them.

GMC should be haulted from selling trucks with the 6.2L engine. My brand new 2026 GMC Yukon Denali engine imploded on the Interstate going 75mph that nearly killed my entire family. No warning, just out of no where died on the highway, with 4K miles on it. This is sadly going to get someone critically injured and when is enough going to be enough? GMC has some explaining to do, when they charge $85K-$100K for trucks that blow up as soon as you buy them.

On July 30th 2026, I was Driving on the highway at about 75 miles per hour and the engine shut down. We were fortunate that we could pull over to the side of the highway. We had the truck towed to Oxendale gmc. Today 8/4/26 I was informed that in fact the engine needs to be replace. No warnings no symptoms, the truck just shut down while driving.

The contact owns a 2026 GMC Yukon. The contact stated that while driving 55 MPH and depressing the accelerator pedal, the vehicle failed to respond as intended. The contact pulled over to the side of the road, turned off and restarted the vehicle; however, the failure persisted. A dealer was contacted. The vehicle was towed to the dealer to be diagnosed, and the contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and informed the contact that there was a wait for the replacement engine. The approximate failure mileage was 3,788.

So the ultimate failure is from a catastrophically failed crankshaft journal thrust bearing. Which could be caused from one of two things: 1) The crankshaft thrust bearings they are putting in these motors are made with inferior materials, probably cheap Chinese crap or 2) The crankshaft end play tolerance was never set properly, giving the crankshaft the ability to move forward and backward in the engine more than it was designed to. Which will over time beat up on the thrust bearing until it fails. In either case it would result in the same progressive issue showing itself. It will start as a squeak here and there. Which, as the soft thrust bearing material is unable to hold the proper oil film thickness for lubrication, will spiral into more and more heat being sent into the adjacent components, plus the buildup of metal particles being sent through the entire engine oiling system. Which will then start killing connecting rod and crankshaft bearings one by one. If the engine survived to this point, it’s now a ticking time bomb. It is either going to just seize up and not run anymore or the exciting route would be a connecting rod breaks and makes a window sized hole in the side of the engine block.

My engine with less than 5,000 miles died (engine was blown). While driving on highway engine died and wheels locked and almost caused a major accident. I had to get a tow and bill cost me 700.00. GMC is giving me the run around. Dealer stated that engine will need to be replaced. GMC is doing nothing to assist me, I have a car note with no truck GMC is the biggest scam.