2025 GMC Yukon

This has happened twice. Once in November 2025 and then in January 2026. With super cruise engaged while going around a curve super cruse disengages and the steering wheel turns to driving straight. You have about one or two seconds to take control or crash. This happened while driving about 70 mph on interstate I 70 and next on Ohio 122 going about 45 mph. On I 70 it was a gentle curve and on 122 it was a much sharper curve. Super cruse must give a warning that it about to disengage that is much longer than one or two seconds.

2025 Yukon Denali - Purchased in July of 2025 Specifically to pull air stream trailer. Vehicle Was equipped with necessary tow package for this purpose! #1 problem: Went into limp mode, stopped in traffic, towed to dealer. One week to repair and replace fuel system. ( under 700 Miles ) #2 Problem: Went into limp mode while pulling trailer, vehicle lost all the transmission fluid on ground. In shop sixteen days waiting for new transmission parts. ( Under 700 Miles ) #3 Problem: Vehicle stopped in traffic, towed to dealer where it was determined it needed new engine. In shop Nov 27, 2025, still in shop as of Jan 14, 2026. No ETA on engine or delivery. ( Under 2000 Miles ) #4 Problem: During last failure attempt to use "on star" failed, still not resolved. This vehicle is a danger to the owner and its passengers as well as others when it simply stops working in the middle of a busy highway with a 23' trailer in tow. Not to mention I have $160,000 invested in a car and camper I have yet to be able to use.

My 2025 GMC Yukon AT4 Ultimate experienced reduced acceleration, and I immediately took it to the dealer. The dealer concluded it was a thrust bearing failure, and GM has authorized a complete engine replacement. I wanted to report this issue, as I believe it represents a potential safety concern. I would like to clarify whether GM has identified the root cause of this problem and redesigned the replacement engine to prevent recurrence. Additionally, I want to be able to track the replacement engine through its serial number for documentation purposes. I am submitting this report to formally document my concern. While GM has acknowledged the thrust bearing issue through a memo #25-NA-307, they have not confirmed whether the redesigned replacement engine will prevent this failure from happening again. Please advise. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

I bought a brand new 2025 GMC Yukon AT4 3.0 Diesel on 8/16/25 (had 213 miles on). A month later, with only 2000 miles on the vehicle, I was driving down the road and got a warning "reduced acceleration, drive with caution". Car would hardly accelerate. Had it towed to the dealer on 9/22/25. They found metal shavings in the engine oil. Said there was a quarter inch play around the camshaft (manufacture defect). Told me I need a completely new engine. It's now 12/2/25 and I still don't have a car, and mine hasn't been repaired.

On November 5, 2025, this 2025 diesel GMC Yukon Denali brand new vehicle went into "limp mode" 75 days after purchase with 3,957 miles on the odometer. Vehicle began to decelerate on a busy road. Warning lights went on to indicate that accelerating was no longer possible. Other fast-moving vehicles on the road came very near to the Yukon and quickly passed it/weaved around it, jeopardizing the lives of this Yukon's driver and occupants. At times, the Yukon diesel vehicle would only reach 15 MPH. Vehicle eventually driven to nearest GM dealership. The GM dealership service center reported a P06D code and reported that the engine experienced catastrophic engine failure. A new diesel engine has been ordered but is not yet available to the dealership for installation. (The dealership also reports that two other new GM diesel SUVs are waiting on new engines due to catastrophic engine failure.)