2024 GMC Yukon Xl

Purchase this Vehicle November 1st 2025 as a GM certified used vehicle. Had several issues with the camera system including the backup camera. Would go offline and not be usable for days. Vehicle went back to shop several times for this with no resolution. Now February 18th 2026 at approximately 630PM EST (after sunset) on the way into work traveling on the highway the engine lost power and engine shutdown. Vehicle shifted into neutral with the indication to press the start button in order to shift into Drive. This cause all of the lights to shutdown when it tried to start the engine. I was barely able to pull this over to the shoulder before I lost forward motion. Narrow shoulder. Tried to restart again with the same results. Call towing company. They attempted to jump start vehicle. Same results. All power shutdown. Truck was loaded onto flatbed and towed to dealership. Dealership states bad battery. Got authorization to replace battery from the dealer in which I purchased the truck. hey attempted to start and then it burned out the main fuse. They determined that the engine had seized and they were going to replace the engine. I looked up to find that GM had performed the engine oil replacement procedure in June of 2025. This vehicle is listed in the "recall" for defective L87 engines. Clearly changing the oil had no effect to remedy the issue. I have no faith that the new engine will not fail the same way this one did.

This is a Post-Remedy Failure of Recall 25V-274 (GMC 6.2L L87 Engine). Following a full engine replacement performed by the dealer under this safety recall, the vehicle has suffered a catastrophic electrical compromise. The vehicle is currently throwing codes P2534 (Low Ignition Voltage) and U3018 (BCM Communication). Safety Hazards: The vehicle experiences sudden loss of power, engine stalling at highway speeds, and total failure of the exterior turn signals (hyper-flash). The AC system has been disabled by the Body Control Module due to low voltage, creating a hazard in high temperatures. This vehicle fits the exact profile of NHTSA Recall Query RQ26-001 and Engineering Analysis EA25-007. The manufacturer's remedy for the safety recall has failed to restore the vehicle to a safe operating condition, and the dealership is attempting to charge diagnostic fees to investigate their own defective recall workmanship.

The contact owns a 2024 GMC Yukon XL. While the contact's wife was driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. In addition, the contact's wife noticed an abnormal knocking sound before the engine seized. The check engine warning light illuminated. The vehicle was towed to the dealer, where it was diagnosed and DTC: P0305 (lifter on cylinder 5); was retrieved, and the intake valve detached and damaged the camshaft. The contact was informed that the lifters and related parts, camshaft, and the coolant pump needed to be replaced. The vehicle was repaired; however, the failure reoccurred. The vehicle was taken back to the dealer where it was diagnosed with engine failure due to the metal shavings found in the oil. The contact was informed that the engine needed to be replaced. The vehicle was not diagnosed. In addition, the failure had occurred within 2,500 miles of the initial repair. The manufacturer was made aware of the failure ,and a case was filed. The failure mileage was approximately 14,589.

****This complaint is an addendum to ODI Complaint #11715415 **** This report updates the prior complaint to reflect complete engine seizure and pending engine replacement following post-repair loss of propulsion. I respectfully request that NHTSA include my vehicle’s failure in its ongoing evaluations related to L87 engine failures, including Recall 25V-274, Engineering Analysis EA25007, and Recall Query RQ26001. My 2024 GMC Yukon XL Denali experienced progressive internal engine failure beginning at approximately 61, 975 miles. First attempt: The vehicle required camshaft and lifter replacement due to internal mechanical damage. Immediately after 4.5 week repair, the vehicle suffered sudden loss of motive power at highway speed.  The engine shut down without warning at 75 mph with children in the car. (Car was in owners possession for no more than 15 hours, and was driven 25 miles on the highway when it switched to neutral and shut down). Second attempt: The vehicle was towed back to the dealership. Additional electrical repairs were then attempted. (Fuse box) It shut down again during dealer testing. Third attempt: Subsequent internal inspection revealed cylinders 5 and 6 seized, requiring full engine replacement. This represents: • Repeated loss of motive power • Escalation from top-end failure to catastrophic lower-end seizure • Failure occurring immediately after dealer-performed repair(s) • A 2024 model-year vehicle with relatively low mileage Given NHTSA’s ongoing investigations into post-remedy failures (RQ26001) and out-of-scope bearing failures (EA25007), I request that this incident be evaluated as part of the broader defect pattern analysis.

About 4 weeks ago my vehicle began shaking uncontrollably while driving. The check engine light illuminated and multiple warnings appeared including emissions system, variable valve timing system, engine and transmission failures shown on the GMC app. I contacted the selling dealership and was given an appointment 4 days later. Later that day I drove less than 5 miles to pick up my children from school. During that drive the vehicle filled with a strong gasoline odor and exhaust fumes were overwhelming. I feared the vehicle could catch fire. I contacted the dealership again, stated the vehicle was unsafe, dropped it off at approximately 8:00 PM and was required to obtain my own rental vehicle. After one week I was told the engine required a camshaft and lifter replacement. Inspected & approved by extended warranty, parts were ordered and installed. I retrieved the vehicle on 23 days after the initial failure. The following morning (24th day) while driving approximately 75 mph on a major interstate with my children the vehicle suddenly shifted into neutral and would not re-engage. I was unable to shift into any gear and coasted to a narrow shoulder inches from traffic and guardrail.The dashboard stated the vehicle could not shift into gear and instructed me to push the start button. The engine would not restart. We were stranded approximately two hours in 10-degree weather on a major interstate with heavy semi-truck traffic. Roadside assistance was required. 3 days later the dealership stated the failure was a fuse block. After replacement the vehicle was test driven and stated to be operating normally. A second dealership employee test drove the vehicle, it died again and had to be towed back to the dealership. The battery was replaced after draining while disabled. Repeated mechanical and electrical failures resulted in complete loss of power at highway speeds and placed my children and me in immediate danger. I no longer believe this vehicle is safe to operate.

I am filing this complaint regarding a serious and ongoing safety issue with my GMC Yukon Denali that began with a complete engine failure while driving on the highway with my entire family in the vehicle. While driving at highway speed (about 60–70 mph), the vehicle suddenly lost power and shifted into neutral on its own. While still moving, I tried multiple times to shift back into Drive so I could safely get off the road, but it would not engage. I was only able to coast partially onto the shoulder before the vehicle came to a complete stop, still partly exposed to traffic. The engine shut off and would not restart at all. It would not go into Drive or Neutral, and the vehicle was completely dead. And it had to be towed. The dealer later told me the engine had failed and that a new engine was installed. About a week later, I picked the vehicle up. Less than 20 minutes after leaving the dealership and getting back on the highway, smoke started coming from the vehicle and warnings appeared, messages that the engine was overheating and that I needed to stop the engine immediately. The vehicle was not drivable again and had to be towed back. I again had to arrange transportation home. A few days later, I picked the vehicle up again. Since then, I have had serious four-wheel-drive and drivetrain issues. The vehicle became stuck in 4 Low and I could not get it out for over a day. When it finally came out, the drive mode buttons stopped working correctly. Selecting 2 High sometimes puts it into 4 High, selecting Auto puts it into 2 High, and Auto mode no longer appears. Even when it shows 4 High, the steering is restricted cannot steer 100% to the right or left and the vehicle binds, pops, and jumps when turning. I believe this vehicle is unsafe and poses a serious risk.

Transmission appears to be lunging and shuttering. Dealer has indicated that the valve body need to be replaced or the vehicle could leave me stranded or without propulsion while driving. From my research this appears to be related to other safety recall and service campaigns for this type of vehicle and the transmission that I have in my vehicle. Also the camera system doesn't work correctly as it relates to parking assist and collision control. My repair dealership has stated they are having trouble getting GM to cover this repair.

Good morning. It’s about the safety recall for loss of propulsion due to manufacturing defects that can lead to engine damage and engine failure. GM notified me about this in September 2025 . So, I drove my vehicle to the dealership to inspect my vehicle , my SUV passed the examination, they replaced the oil recommending now another one with higher viscosity, new oil cap and an owner’s manual insert free of charge. Ladies and gentlemen; My concern from here on now is, just doing this is going to give me a peace of mind? Meaning the manufacturer defects issue is not longer in my vehicle? I paid a top dollar for this specific unit because I like to travel across the country even to go to Mexico. Right now I’m driving the truck silent, no music at all.driving the vehicle just to go to the store, to buy groceries,very short trips, around my neighborhood Trying to hear any noise, any knocking noise on my engine, observing the dashboard controls constantly, my family and I decided to stop traveling due to my vehicle is not secure to do it with this particular 6.2 engine because my notification letter from GM says that if the vehicle fails during operation will lose control increasing the risk of crash. As a GM customer, using my vehicle with my family I don’t feel safe and comfortable with my vehicle therefore I am asking and expecting for a better solution from General Motors. Not just replacing the oil for another one with a higher viscosity because doing this only is telling me that it’s just a cheap remedy, but the manufacturer defects are still there with my vehicle . I know they extended the warranty to cover this defect if something happens in the future, but isn’t about that , is about the safety, the concerns, the feelings of the family members involved in this insecure situation while driving this vehicle in the highway at 70 miles an hour.Ladies and gentlemen. I am pretty sure you can help us with this petition , GM should be able to do something way better.