2026 GMC Sierra 1500

I am submitting this complaint to report what I believe is a serious safety-related defect involving the General Motors 6.2L L87 V8 engine installed in my 2026 GMC Sierra Denali. On July 10, 2026, while driving on a public highway near Bogata, Texas, the engine suddenly began making severe mechanical noises before catastrophically failing without warning. The engine seized completely while the vehicle was in motion. At the time of failure, the truck had only 13,517 miles. The sudden loss of engine power left my wife and me stranded on the roadside. Had this occurred while crossing an intersection, merging into traffic, passing another vehicle, towing a trailer, or traveling in heavier traffic, the consequences could have been far more serious.

While traveling from [XXX] to [XXX] for vacation, I was in [XXX], and when I pulled off the interstate and came to a stop sign the vehicle quit. At first, I was unable to restart the Vehicle, but after sometime I got it started and was able to pull it off the road while the engine was making very loud clattering noise and the vehicle would not stay running. Prior to this there were no warning, lights or indications that the engine was going to quit. I checked the engine oil and it was full. I had the vehicle transported to a GMC dealer in [XXX], where it was diagnosed as requiring a new engine. The vehicle is a 2026 GMC Sierra 1500 Denali purchased in December 2025 and has 8,865 miles on it. A little over 4000 miles I had the vehicle oil changed at Starling GMC Titusville Fl. At the time of my service visit, I asked the service writer, [XXX] to check the engine idle because at times it seemed to run a little rough and it quit while pulling in my driveway one day. [XXX] advised me that there is no idle adjustment on the vehicle, so I said I’ll just keep an eye on it. There were never any indications of an engine problem prior to this or even as of now there are no warnings displayed on the instrument panel. I also subscribe to onstar and it indicates everything in the vehicle is normal with no issues. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The telematics module for the OnStar system continues to stop working, I have had this truck in a dealership service center multiple times for them to reset the system (instead of replacing the defective parts). Along with the infotainment system not working properly (cuts in and out, blinks on/off, delay in actions) Doors unlock while driving, front/rear cameras come on when I stopping at an intersection, I have given them documentation of the diagnostic reports from dealerships

6 month old, 9,000 miles 2026 Sierra 1500 with Duramax 3 liter suffered an engine control module failure 4 hours into a 12.5 hour drive home from family vacation. First a transmission service warning flashed, then an emissions system failure with a forced speed reduction warning. This happened with two children and a dog in the vehicle. OnStar did diagnotics and said I had to see a dealer. Fortunately one was nearby and they determined the engine control module needed to be replaced--but i was 8.5 hours' drive from home with kids and dog and would have had to stay for 2-4 days awaiting parts and repair. I traded the truck at the dealer for a new vehicle and drove that home. This was a major safety concern traveling with children and a dog on a nearly 100 degree day. And it was a brand new vehicle.

When going up my 5% grade driveway the truck has slammed into “park” while moving two times. The car turns off as it slams into park and a “ service transmission” warning is on the dash. It leaves small skid marks from doing this while moving. It has 1790 miles on it. Dealer has had it a week and says they cannot duplicate the issue. Google search seems to indicate many trucks have had the same issues going up an incline.

I bought the truck with 2 miles , shut off on me within 1,300 miles wouldn’t turn on , supposedly it was a bad fuse that was burned out , Second time it shut off on me again , all my sensors were going off and on and truck wouldn’t turn back on , they told me they couldn’t figure out the problem evaczue they had disconnected the battery and it erased all the codes 3rd time , they changed my oil and they forgot to torque the screw back correctly and all the oil spilled and cost my engine to lock up and mess up , they replaced the motor with a new one 4th time , supposedly it needs a replacement for a catalytic converter which is being replaced now as we speak or sometime this week

I purchased this new full-size heavy-duty pickup, and at purchase the selling dealer installed a 3-inch suspension lift kit with 37-inch tires on 22-inch wheels as a paid dealer upfit. The lift kit manufacturer publishes a maximum tire size of 35 inches on a 20-inch wheel for this kit; the tires and wheels the dealer installed exceed that spec. The lift manufacturer confirmed directly that they would never approve exceeding the 35-inch tire / 20-inch wheel recommendation. The dealer's assistant manager confirmed that NO calibrations of any kind were performed after the lift and 37-inch tires were installed, and said nothing is recalibrated when a lift is done with 37-inch tires. This vehicle is factory-equipped with forward collision alert, automatic emergency braking, front pedestrian braking, lane departure warning, and automatic high-beam control. These crash-avoidance systems rely on forward-facing camera and sensor aim, which depends on ride height and suspension geometry. A 3-inch lift with 37-inch tires materially changes that geometry. With no calibration performed, there is no assurance these safety systems are aimed or functioning to spec. The truck was also never aligned after the lift and the tires are cupping. The headlights were never re-aimed for the higher ride height, and the speedometer was never recalibrated and reads inaccurately. The oversized tires also contact the body. The left front tire has torn into the front fender, the fender well is misaligned, and it is forcing the lower front edge of the driver's door out of alignment. The dealer's only proposed remedy is to keep cutting the fender wells; the trimming already done has exposed electrical wiring behind the wheel well to mud, water, and road debris. I am reporting this because the assistant manager's statement suggests it may be the dealer's standing practice—other customers may be driving lifted trucks with uncalibrated crash-avoidance systems without knowing it.