Latches/locks/linkages. Review the 15 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Seat Belts. Review the 15 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Structure. Review the 5 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

6 crash reports1 fire reports8 injury reports

Engine And Engine Cooling complaints

4 reports

Clear category filter

Mileage unknown · Mar 2, 1999

Engine And Engine Cooling

Read full complaint

EXTREMELY DANGEROUS SITUATION OF STALLING AND DECELERATION DUE TO FACTORY INSTALLED FAULTY PARTS. NATIONAL SERVICE BULLETINS 92-362-6A & 91-442-6E (BOTH ISSUED WHILE MY CAR WAS UNDER ORIGINAL WARRANTY) INDICATE THE NEED FOR "REVISED" PARTS. I RECEIVED NO NOTIFICATION OF THIS POTENTIAL PROBLEM INHERENT IN MY CAR. BY THE TIME MY CAR BEGAN MANIFESTING THESE HIGHLY DANGEROUS STALLS, WARRANTY EXPIRED. NO WILLINGNESS FROM CHEVY GEO TO REPAIR THE CAR TO MAKE IT SAFE FOR USE, WHEN OBVIOUSLY THEY ARE AWARE OF THE PROBLEM. HELP ME! THANK YOU FOR YOUR TIME.

NHTSA ODI #703931

Mileage unknown · Jan 25, 1999

Engine And Engine Cooling

2 CATALYTIC CONVERTERS WERE REPLACED WITHIN A SIX YEAR PERIOD. *AK

NHTSA ODI #702585

Mileage unknown · Mar 13, 1995

Electrical SystemEngine And Engine CoolingLatches/locks/linkages

PURCHASED USED CAR AND FOUND OUT IT WAS A REBUILT, BURNED UP ENGINE, DEALER CLAIMS HE FIXED THE PROBLEM BUT STILL HAVING THE PROBLEM. TT

NHTSA ODI #961766

Mileage unknown · Feb 27, 1995

Engine And Engine Cooling

HM (916) 441-7741; CATALYTIC CONVERTER HAS TWICE RESULTING IN BLOWING HOLE IN MUFFLER TO STALLING WITH NO WARNING. CONVERTER REPLACED TWICE. PLEASE DESCRIBE.

NHTSA ODI #960806

Official recalls

95V103007 · Seat Belts:front:buckle Assembly

May 24, 1995

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence & remedy

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

93V189001 · Latches/locks/linkages:hood:latch

Nov 23, 1993

MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.

Consequence & remedy

Consequence: AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.

Remedy: GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗