Structure. Review the 18 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Back Over Prevention. Review the 14 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Electrical System. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

7 crash reports0 fire reports1 injury reports

Fuel/propulsion System complaints

2 reports

Clear category filter

49,995 miles · Oct 26, 2020

Fuel/propulsion SystemPower Train

VEHICLE IS NOT GETTING RECOMMENDED MILEAGE AND IS HARD SHIFTING

NHTSA ODI #11366470

55,054 miles · Jul 12, 2018

Fuel/propulsion System

ENGINE STOPPED WHILE DRIVING IN WALMART PARKING LOOT. WOULD NOT START. TOWED TO GARAGE WHO TRACED THE CAUSE TO. FUEL PUMP CONTROL MODULE. THERE IS AN EXISTING RECAL FOR THIS PROBLEM FROM 2013 TO 2014 FORD FLEX HOWEVER MY VIN SHOWS AS NOT COVERED. WHATEVER CRITERIA TO LIMIT RECALL APPEARS TO BE INVALID

NHTSA ODI #11111043

Official recalls

25V732000 · Structure:body

Oct 24, 2025

Ford Motor Company (Ford) is recalling certain 2017-2019 Flex vehicles. The driver and front passenger B-Pillar door trim may detach while driving.

Consequence & remedy

Consequence: Door trim that detaches while driving can create a road hazard, increasing the risk of a crash.

Remedy: Dealers will repair or replace the B-pillar trim as necessary, free of charge. Interim letters, notifying owners of the safety risk, were mailed December 17, 2025. Additional letters will be sent once the remedy is available, anticipated March 2027. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25SB8. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on October 28, 2025.

25V695000 · Back Over Prevention: Sensing System: Camera

Oct 13, 2025

Ford Motor Company (Ford) is recalling certain 2015-2019 Flex, 2015 Explorer, Lincoln MKT, Lincoln MKZ, 2015-2016 C-Max, Escape, Taurus, 2016 Fusion, 2018-2019 Taurus, 2019 Lincoln MKT, Fiesta, and 2020 Mustang vehicles. The rearview camera may display a distorted, intermittent, or blank image when the vehicle is in reverse.

Consequence & remedy

Consequence: A rearview camera that fails to properly display an image can reduce the driver’s view behind the vehicle, increasing the risk of a crash.

Remedy: Dealers will inspect and replace the rearview camera as necessary, free of charge. This will be a phased campaign, with the remedy becoming available in different phases based on model and model years. Interim letters notifying owners of the safety risk were mailed on October 25, 2025. Additional letters will be mailed once the final remedy is available on each phase. Mustang owner notification letters were mailed January 2, 2026. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25SA9. Vehicle Identification Numbers (VINs) involved in this recall became searchable on NHTSA.gov on October 14, 2025.

20V072000 · Suspension:rear

Feb 10, 2020

Ford Motor Company (Ford) is recalling certain 2013-2018 Lincoln MKT and Ford Flex and Taurus vehicles with the Police Interceptor or SHO Performance Pack. The rear suspension toe links may fracture due to stress on the rear suspension.

Consequence & remedy

Consequence: A fractured rear toe link will cause a sudden change in vehicle handling and increase the risk of a crash.

Remedy: Ford will notify owners, and dealers will replace the rear suspension toe links, free of charge. Remedy parts are not currently available. Owners were notified about the recall on March 3, 2020. A second notice will be mailed when remedy parts become available, which is currently expected to be the end of September 2020. The recall began October 28, 2020. Owners may contact Ford customer service at 1-866-436-7332 or Lincoln customer service at 1-800-521-4140. Ford's number for this recall is 20S04.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE25007 · B-Pillar Trim Detachment

Opened Aug 7, 2025 · Closed Aug 5, 2026

Status: closed (inferred from source dates) · Structure:body:roof And Pillars

On August 7, 2025, the Office of Defects Investigation (ODI) opened PE25007 to investigate instances of B-pillar trim detachment in model year (MY) 2019 Ford Flex vehicles manufactured by Ford Motor Company. During the investigation, MY 2011-2018 Ford Flex vehicles were analyzed as peer vehicles, and subsequently incorporated into the subject population because they use B-pillar trim pieces that are substantially similar to those used on the MY 2019 Ford Flex vehicles. In July 2025, prior to the opening of PE25007, ODI and Ford met to discuss B-pillar trim detachment in Ford Flex vehicles. Ford reported that its warranty analysis indicated that Flex B-pillar trim had a low detachment rate and that Ford did not believe this condition posed an unreasonable risk to motor vehicle safety. In July 2025, Ford closed its internal investigation. Because ODI’s analysis of complaint data indicated a high failure rate and an increasing failure trend, PE25007 was subsequently opened. In responding to the information request for PE25007, Ford reassessed the warranty search criteria used in its July 2025 internal investigation. The reassessment found the detachment rate to be substantially higher than what Ford had originally determined. Consequently, in October 2025, Ford issued recall 25V732based on the reassessed and accurate high failure rate. This recall instructed dealers to inspect the driver and front passenger B-pillar trim pieces and repair/replace if necessary. The vehicles included in this recall were MY 2017-2019 Ford Flex with production dates between February 17, 2017 and December 2, 2019. In January 2026, Ford issued 25V732 Amendment 1, which updated the remedy to remove the inspection criteria and instead proactively secure the driver and front passenger B-pillar trim with adhesive. The scope of vehicles included in the recall was unchanged by Amendment 1. ODI’s analysis of 25V732 found that both the scope and remedy were insufficient and that an unreasonable safety risk remained despite the recall. MY 2016 Ford Flex was excluded from the recall scope and the rear B-pillar trims on both the driver and passenger side were excluded from the recall. The failure rates of both MY 2016 Ford Flex and rear B-pillar trim pieces were found to be higher than the failure rates in similar trim detachment recalls issued by both Ford and other vehicle manufacturers. Starting in January 2026, ODI and Ford had multiple meetings to discuss Ford’s PE25007 response data and ODI’s concern about the 25V732 scope and remedy. In June 2026, Ford issued 25V732 Amendment 2. This amendment expanded the scope of the recall to add MY 2016-2017 Ford Flex vehicles produced before February 17, 2017. Additionally, this amendment updated the remedy to include removal of and reapplication or replacement of both rear driver and rear passenger B-pillar trim pieces in addition to front driver and front passenger B-pillar trim pieces. This updated remedy applies to all MY 2016-2019 vehicles. Ford expects to complete the mailing of remedy owner notification letters by March 26, 2027. Also, Ford informed ODI that prior model year (MY 2011-2015) vehicles were referred to Ford’s Customer Satisfaction forum for consideration of an extended warranty program. In view of recall 25V732 and its associated amendments, ODI is closing this Preliminary Evaluation (PE). The Agency reserves the right to take additional action if warranted by future circumstances. To review the ODI reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.