2021 Ford F-150 Hybrid

Ive noticed that the electric motor sometimes doesnt want to disengage quickly when I step on the brakes. In this incident I had to make a hard brake because someone pulled out in front of me. I had the cruise control on. When I slammed on the brakes the vehicle did not stop fast the vehicle felt as if it was still being pushed by something. Then a small jolt was felt and then the vehicle finally slowed. Had I been going faster or had the car that pulled been closer. This fault would have resulted in an incident

I am reporting a safety-related transmission problem I experienced with my 2021 Ford F-150 equipped with the 10R80 automatic transmission. While driving normally, the transmission suddenly has lost propulsion and RPMs flare while driving steadily uphill. This occurred while merging onto a fast moving highway and while traveling at a steady speed going uphill, creating a potentially dangerous situation because the truck did not respond as expected when I needed predictable acceleration or propulsion. I believe this incident may be related to the known 10R80 CDF clutch-cylinder/sleeve problem. Ford technical information identifies axial movement of the CDF sleeve that can cause hydraulic-circuit leaks and harsh or delayed engagement and shifting. This condition can result in slipping, RPM flares, delayed engagement, unexpected gear changes, harsh downshifts, lurching, or loss of propulsion. This is a safety concern, not merely a transmission quality or reliability issue. Unexpected loss of propulsion or unpredictable shifting while merging, accelerating into traffic, crossing an intersection, turning, or traveling at highway speed can create a collision hazard. Because I personally experienced this unexpected transmission event, I request that NHTSA investigate the 10R80 CDF clutch-cylinder/sleeve condition in Ford F-150s. Please review Ford warranty claims, dealer repair records, transmission replacements, consumer complaints, and field-failure data to determine whether this is a safety defect requiring a recall. I believe owners should not have to wait for a potentially dangerous transmission failure before this known condition is addressed.

I'm reporting a transmission problem on my 2021 Ford F-150 with the 10R80 automatic transmission that I believe is a safety issue, not just a reliability one. The truck currently has about 55,000 miles on it. Right now the truck shifts hard and jerks every time I drive it, and it's especially bad at low speed. The worst situation is creeping through a parking lot looking for a spot, the transmission drops down into first with a clunk and a jerk, and then kicks again when it shifts back up out of first. It's rough enough that I've taken to putting the truck in "Eco" drive mode on purpose, because that softens the shift profile and takes a little of the edge off. Once I'm out of the low-speed stop-and-go and up to normal road speed, it seems to smooth out and drive okay, but the low-speed shifting is genuinely excessively rough. From what I've read, this matches the known 10R80 problem where the CDF clutch sleeve can move axially and cause hydraulic-circuit leaks, which leads to slipping, RPM flares, delayed or harsh engagement, and unexpected shifts. Everything I've found says this condition progressively worsens as the transmission degrades. That's exactly why I'm filing now rather than waiting. A hard, unpredictable shift or a loss of propulsion at the wrong moment — pulling into traffic, crossing an intersection, merging — can easily cause a collision. I don't want to wait until it fails in a dangerous spot and someone in my family gets hurt. I'd like NHTSA to investigate the 10R80 CDF clutch-cylinder/sleeve condition on Ford F-150s and to review Ford's warranty claims, dealer repair records, transmission replacements, and other owner complaints to determine whether this is a defect requiring a recall. Owners shouldn't have to wait for a dangerous failure before a known condition like this is addressed.

I am reporting a safety-related transmission problem I experienced with my 2021 Ford F-150 equipped with the 10R80 automatic transmission. While driving normally, the transmission suddenly slipped at least twice, and shifts violently often. The truck while driving on a 35mph road after just going over a railroad track I went to accelerate and lost gear and the transmission slipped really bad and violently caught a gear after reaching around 4000 rpm. The truck also shifts violently when under moderate acceleration at almost all times in gears 2-5 creating a potentially dangerous situation because the truck did not respond as expected when I needed predictable acceleration or propulsion. I believe this incident may be related to the known 10R80 CDF clutch-cylinder/sleeve problem. Ford technical information identifies axial movement of the CDF sleeve that can cause hydraulic-circuit leaks and harsh or delayed engagement and shifting. This condition can result in slipping, RPM flares, delayed engagement, unexpected gear changes, harsh downshifts, lurching, or loss of propulsion. This is a safety concern, not merely a transmission quality or reliability issue. Unexpected loss of propulsion or unpredictable shifting while merging, accelerating into traffic, crossing an intersection, turning, or traveling at highway speed can create a collision hazard. Because I personally experienced this unexpected transmission event, I request that NHTSA investigate the 10R80 CDF clutch-cylinder/sleeve condition in Ford F-150s. Please review Ford warranty claims, dealer repair records, transmission replacements, consumer complaints, and field-failure data to determine whether this is a safety defect requiring a recall. I believe owners should not have to wait for a potentially dangerous transmission failure before this known condition is addressed.

The contact owns a 2021 Ford F-150. The contact stated that while driving at an undisclosed speed, there was an abnormal sound coming from the rear of the vehicle. No warning lights were illuminated. The contact received notification of NHTSA Campaign Number: 23V896000 (Power Train); however, the part to do the recall repair was not yet available. The local dealer was contacted and informed the contact that the remedy was not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the failure and informed the contact that the remedy would not be available until the end of 2026. The failure mileage was approximately 30,000.

The vehicle is currently at Kayser Automotive Group located at 2303 West Beltline Hwy Madison, WI 53713, their direct line is [XXX], since the diagnoses of the corrosion of the DCN. SYSTEMS & COMPONENTS THAT FAILED: A faulty or clogged engine bay drain plug failed to divert water, causing significant water accumulation that routed into the interior cabin. This water intrusion directly soaked interior carpeting and exposed the Data Communication Network (DCN) connector and Body Control Module (BCM) wiring harness to moisture, resulting in severe pin corrosion and electrical communication faults. The vehicle and all affected components are fully available for inspection upon request. SAFETY RISK: The DCN connector and Body Control Module control critical vehicle operations, exterior lighting, instrument clusters, and safety/driver-assistance systems. Water corrosion on these communication buses causes unpredictable, uncommanded electrical failures and module communication dropouts while operating the vehicle at speed, creating a severe crash hazard to occupants and surrounding traffic. DEALER CONFIRMATION & INSPECTIONS: The issue was physically inspected and confirmed by an authorized Ford dealership service department, Kayser Automotive Group located at 2303 West Beltline Hwy Madison, WI 53713. Dealership technicians verified the water accumulation path, identified the faulty/clogged drain pathway, and documented physical corrosion on the DCN wiring connector. A Technical Assistance Center (TAC) case was requested to escalate the defect to Ford Corporate. WARNING LAMPS & PRIOR SYMPTOMS: Initial symptoms appeared as heavily saturated interior floor carpets and standing water pooling near the cowl/dash area. Shortly thereafter, intermittent electrical glitches, warning lamps on the instrument cluster, and network communication Diagnostic Trouble Codes (DTCs) appeared as the corrosion worsened. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The computer system malfunctioned; the front panel warning was "Stop vehicle and check regen. brakes". I put my car in drive and when I hit the gas pedal the car reversed instead of going forward. I got it towed to the dealer at Piazza Hyundai in Limerick PA. The service did not provide me with an explanation about the warning and showed little concerns to the issues, I was given a month time frame for looking at my car. I consider this a safety issue as the car did not respond appropriately to D and R, I suspect a computer failure.

On July 15, 2026, I took the vehicle to Lafontaine Ford for maintenance and to address open recalls. I was informed that the open recall for the low-pressure fuel pump (campaign 25S75) did not have a solution available. Due to the severity of the recall, I contacted the Ford Customer Care Center. A representative stated that a solution would be available on July 17, 2026, and that they would contact Lafontaine Ford to prioritize the vehicle for repair on July 18, 2026. On July 17, 2026, I followed up with Lafontaine Ford and confirmed they had received no contact or notation from Ford regarding prioritization. Lafontaine Ford also stated they had no information on when parts would become available and that nothing could be done at that time. I then contacted the Ford Customer Care Center again because no action had been taken, even though the recall has been open since approximately July 8, 2025. A Ford Customer Care Center representative confirmed that no remedy was available for my model year and that they did not know when one would be available. Due to the seriousness of the recall, I requested a courtesy vehicle. The Ford representative contacted Lafontaine Ford regarding this request and then disconnected the call. The Lafontaine Ford representative informed me they could not provide a courtesy vehicle without written confirmation from Ford due to the dealership having no reasonable timeframe of when parts/remedy would be available. When I called the Ford Customer Care Center back and explained what Lafontaine Ford had told me, I was treated indifferently and was disconnected twice. I eventually spoke with a supervisor who refused to escalate the concern or provide any assistance with the documentation Lafontaine Ford said they needed in order to provide a courtesy vehicle. The low-pressure fuel pump is the component identified in the recall and can fail, resulting in loss of engine power or stall while driving. This creates a significant safety risk, part

The contact owns a 2021 Ford F-150. The contact received notification of NHTSA Campaign Number: 25V455000 ( FUEL SYSTEM, GASOLINE) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.