2021 Ford F-150 Hybrid

Experiencing total stop of acceleration in two occasions: 1) when putting the car in reverse and pressing the accelerator and 2) when making a left or right turn after a yield or stop. And when I say loss of acceleration, I don’t mean hesitation, reduced power, or sluggish acceleration. I mean absolutely ZERO acceleration. I’ll press the accelerator and nothing happens. The engine stays basically at idle, and the truck will not accelerate for roughly 5-10 seconds, regardless of how much accelerator I’m giving it. Then suddenly power comes back and the truck drives normally again. This happens with normal operating temps while driving most of the day. It got to a point where it happened once every day. Very scary stuff when you're pulling out into traffic - major safety concerns with oncoming traffic.

I am filing a safety complaint regarding a recurring, hazardous transmission failure during highway and incline driving (specifically experienced on mountain highway passes in Arkansas). While driving at highway speeds on uphill inclines, the transmission severely hesitates and struggles to downshift under load. When it finally engages, it violently slams into gear. During these episodes, the truck experiences a sudden loss of motive power and acceleration lag, accompanied by an engine RPM flare of over 400+ RPM. And most recently, I have Live diagnostic data captured during operation revealed a downshift delay of over 3 seconds where the powertrain control module commanded 8th gear, but the transmission physically remained stuck in 10th gear due to severe internal hydraulic pressure loss. This defect presents a severe safety risk on high-speed roadways. Sudden, unexpected loss of power while climbing grades or merging into traffic creates an immediate risk of rear-end collisions from surrounding vehicles. This issue directly correlates with Ford Technical Service Bulletin TSB 26-2287, which identifies axial movement/slippage of the CDF clutch cylinder sleeve as the root cause of internal fluid leaks and gear failure. Because this internal hardware failure causes unpredictable power delivery and driveability loss at highway speeds, I request that the NHTSA investigate the 10R80/10R80-MHT transmission CDF drum sleeve defect as a critical safety hazard. Finally, Ford motor company, and most cases refuses to repair this known defect under warranty, many owners are experiencing this dealership pushback leaving them with a critical safety issue.

I am reporting a safety-related transmission problem I experienced with my 2021 Ford F-150 equipped with the 10R80 automatic transmission. While driving normally, the transmission suddenly shifts hard/lags on gears 3-5 and sometime higher gears 7-9 at higher speeds. I’ve also noticed a buzzing/metallic rattling coming near the engine from inside. There is also times i can tell i have no power when trying to speed up and the other day i almost thought i was going to get T-Boned. This occurred while on my daily traffic commute to work, creating a potentially dangerous situation because the truck did not respond as expected when I needed predictable acceleration or propulsion. I believe this incident may be related to the known 10R80 CDF clutch-cylinder/sleeve problem. Ford technical information identifies axial movement of the CDF sleeve that can cause hydraulic-circuit leaks and harsh or delayed engagement and shifting. This condition can result in slipping, RPM flares, delayed engagement, unexpected gear changes, harsh downshifts, lurching, or loss of propulsion. This is a safety concern, not merely a transmission quality or reliability issue. Unexpected loss of propulsion or unpredictable shifting while merging, accelerating into traffic, crossing an intersection, turning, or traveling at highway speed can create a collision hazard. Because I personally experienced this unexpected transmission event, I request that NHTSA investigate the 10R80 CDF clutch-cylinder/sleeve condition in Ford F-150s. Please review Ford warranty claims, dealer repair records, transmission replacements, consumer complaints, and field-failure data to determine whether this is a safety defect requiring a recall. I believe owners should not have to wait for a potentially dangerous transmission failure before this known condition is addressed.

Ive noticed that the electric motor sometimes doesnt want to disengage quickly when I step on the brakes. In this incident I had to make a hard brake because someone pulled out in front of me. I had the cruise control on. When I slammed on the brakes the vehicle did not stop fast the vehicle felt as if it was still being pushed by something. Then a small jolt was felt and then the vehicle finally slowed. Had I been going faster or had the car that pulled been closer. This fault would have resulted in an incident

I am reporting a safety-related transmission problem I experienced with my 2021 Ford F-150 equipped with the 10R80 automatic transmission. While driving normally, the transmission suddenly has lost propulsion and RPMs flare while driving steadily uphill. This occurred while merging onto a fast moving highway and while traveling at a steady speed going uphill, creating a potentially dangerous situation because the truck did not respond as expected when I needed predictable acceleration or propulsion. I believe this incident may be related to the known 10R80 CDF clutch-cylinder/sleeve problem. Ford technical information identifies axial movement of the CDF sleeve that can cause hydraulic-circuit leaks and harsh or delayed engagement and shifting. This condition can result in slipping, RPM flares, delayed engagement, unexpected gear changes, harsh downshifts, lurching, or loss of propulsion. This is a safety concern, not merely a transmission quality or reliability issue. Unexpected loss of propulsion or unpredictable shifting while merging, accelerating into traffic, crossing an intersection, turning, or traveling at highway speed can create a collision hazard. Because I personally experienced this unexpected transmission event, I request that NHTSA investigate the 10R80 CDF clutch-cylinder/sleeve condition in Ford F-150s. Please review Ford warranty claims, dealer repair records, transmission replacements, consumer complaints, and field-failure data to determine whether this is a safety defect requiring a recall. I believe owners should not have to wait for a potentially dangerous transmission failure before this known condition is addressed.

I'm reporting a transmission problem on my 2021 Ford F-150 with the 10R80 automatic transmission that I believe is a safety issue, not just a reliability one. The truck currently has about 55,000 miles on it. Right now the truck shifts hard and jerks every time I drive it, and it's especially bad at low speed. The worst situation is creeping through a parking lot looking for a spot, the transmission drops down into first with a clunk and a jerk, and then kicks again when it shifts back up out of first. It's rough enough that I've taken to putting the truck in "Eco" drive mode on purpose, because that softens the shift profile and takes a little of the edge off. Once I'm out of the low-speed stop-and-go and up to normal road speed, it seems to smooth out and drive okay, but the low-speed shifting is genuinely excessively rough. From what I've read, this matches the known 10R80 problem where the CDF clutch sleeve can move axially and cause hydraulic-circuit leaks, which leads to slipping, RPM flares, delayed or harsh engagement, and unexpected shifts. Everything I've found says this condition progressively worsens as the transmission degrades. That's exactly why I'm filing now rather than waiting. A hard, unpredictable shift or a loss of propulsion at the wrong moment — pulling into traffic, crossing an intersection, merging — can easily cause a collision. I don't want to wait until it fails in a dangerous spot and someone in my family gets hurt. I'd like NHTSA to investigate the 10R80 CDF clutch-cylinder/sleeve condition on Ford F-150s and to review Ford's warranty claims, dealer repair records, transmission replacements, and other owner complaints to determine whether this is a defect requiring a recall. Owners shouldn't have to wait for a dangerous failure before a known condition like this is addressed.

I am reporting a safety-related transmission problem I experienced with my 2021 Ford F-150 equipped with the 10R80 automatic transmission. While driving normally, the transmission suddenly slipped at least twice, and shifts violently often. The truck while driving on a 35mph road after just going over a railroad track I went to accelerate and lost gear and the transmission slipped really bad and violently caught a gear after reaching around 4000 rpm. The truck also shifts violently when under moderate acceleration at almost all times in gears 2-5 creating a potentially dangerous situation because the truck did not respond as expected when I needed predictable acceleration or propulsion. I believe this incident may be related to the known 10R80 CDF clutch-cylinder/sleeve problem. Ford technical information identifies axial movement of the CDF sleeve that can cause hydraulic-circuit leaks and harsh or delayed engagement and shifting. This condition can result in slipping, RPM flares, delayed engagement, unexpected gear changes, harsh downshifts, lurching, or loss of propulsion. This is a safety concern, not merely a transmission quality or reliability issue. Unexpected loss of propulsion or unpredictable shifting while merging, accelerating into traffic, crossing an intersection, turning, or traveling at highway speed can create a collision hazard. Because I personally experienced this unexpected transmission event, I request that NHTSA investigate the 10R80 CDF clutch-cylinder/sleeve condition in Ford F-150s. Please review Ford warranty claims, dealer repair records, transmission replacements, consumer complaints, and field-failure data to determine whether this is a safety defect requiring a recall. I believe owners should not have to wait for a potentially dangerous transmission failure before this known condition is addressed.

The contact owns a 2021 Ford F-150. The contact stated that while driving at an undisclosed speed, there was an abnormal sound coming from the rear of the vehicle. No warning lights were illuminated. The contact received notification of NHTSA Campaign Number: 23V896000 (Power Train); however, the part to do the recall repair was not yet available. The local dealer was contacted and informed the contact that the remedy was not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was notified of the failure and informed the contact that the remedy would not be available until the end of 2026. The failure mileage was approximately 30,000.

At a stoplight the truck began running rough. When the light turned green, the truck failed in just 3 blocks (approximately 1 minute). Power was greatly reduced. Check engine illuminated on dashboard, then another red icon, followed by a stop safely now message. Immediately I attempted to pull over from the left lane to the right lane but the truxk Immediately stalled across both lanes, blocking all traffic. Ford dealer has ordered a new fuel pump and the repair is pending.

When starting from a stop or rolling slowly under 15 mph, pressing the accelerator pedal — even flooring it — produces no engine or motor response for 1–3 seconds. The vehicle then suddenly accelerates. This occurs intermittently on both electric and gas power. Safety concern because it delays merging or pulling out into traffic.