Electrical System. Review the 104 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Seat Belts. Review the 71 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Fuel System, Gasoline. Review the 59 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

19 crash reports61 fire reports14 injury reports

Exterior Lighting complaints

16 reports

Clear category filter

Mileage unknown · Oct 15, 1996

Exterior LightingFire

BULB IN PLASTIC HOUSING OF HIGH MOUNTED BRAKE LIGHT CAUGHT FIRE.

NHTSA ODI #509917

Mileage unknown · May 17, 1996

Exterior Lighting

REAR WINDOW BRAKE LIGHT, 3 THIRD LIGHT, LAMP WHEN OVER HEATED MELTED FROM THE BOLT. *AK

NHTSA ODI #984593

Mileage unknown · Aug 21, 1995

Exterior Lighting

PURCHASE CAR NEW HAD TO REPLACE THE HEAD LIGHT TEN TIMES ON BOTH SIDE . TT

NHTSA ODI #970746

Mileage unknown · Jun 28, 1995

Exterior Lighting

HEADLIGHT WENT OUT AT NIGHT WITHOUT WARNING DUE TO DEFECTIVE HEADLIGHT SWITCH. *AK

NHTSA ODI #967870

Mileage unknown · Jun 20, 1995

Exterior Lighting

THIRD BRAKE LIGHT MELTED DOWN AROUND THE BULB, RELEASING SMOKE INTO PASSENGER COMPARTMENT. *AK

NHTSA ODI #967343

Mileage unknown · Date not reported

Exterior Lighting

THIRD (3RD) LIGHT STARTED SMOKING, CASING AROUND LIGHT COMPLETELY MELTED, WHOLE BRAKE LIGHT/CASING REMOVED. *AK

NHTSA ODI #987349

Official recalls

93V057000 · Electrical SYSTEM:IGNITION:ANTI-THEFT:CONTROL Module

Apr 15, 1993

THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.

Consequence & remedy

Consequence: THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.

Remedy: IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.

92V117000 · Fuel System, Gasoline

Aug 19, 1992

FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.

Consequence & remedy

Consequence: SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.

Remedy: INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.

90V076000 · Vehicle Speed Control:accelerator Pedal

Apr 17, 1990

INTERFERENCE OCCUR BETWEEN BOLT THAT SECURES A FUEL LINE SHIELD TO THE LOWER PORTION OF THE DASH PANEL AND THE ACCELERATOR PEDAL.

Consequence & remedy

Consequence: THIS COULD CAUSE THE ACCELERATOR PEDAL TO STICK AT THE WIDE OPEN THROTTLE POSITION AND RESULT IN LOSS OF CONTROL WITH THE RISK OF A VEHICLE ACCIDENT.

Remedy: CUT OFF EXTRA LENGTH OF BOLT THAT PROTRUDES ABOVE SURFACE OF WELD NUT TO PREVENT INTERFERENCE.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗