2018 Ford Escape

The contact owns a 2018 Ford Escape. The contact stated that while driving at an undisclosed speed, a message was displayed to exit the vehicle immediately. The contact pulled over and called someone to add coolant to the vehicle, but the failure persisted. The contact was constantly adding coolant to the vehicle. The vehicle was taken to the dealer, who determined that coolant was leaking into the engine and that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 84,000.

2018 Ford Escape vehicles equipped with a 2.0L EcoBoost engine may exhibit a low coolant level, white exhaust smoke and/or a runs rough condition with or without an illuminated malfunction indicator lamp (MIL). Diagnostic trouble codes (DTCs) may include P0300, P0301-P0304, P0316, P0217, P1285 and/or P1299 stored in powertrain control module (PCM). This may be due to coolant intrusion into the cylinder. To correct the condition, follow the Service Procedure to replace the long block engine assembly. THis is a known issue with a Techinal service bulletin issued on 6/9/2022. My car has only 87,000 miles on it and will need a new motor because coolant is leaking into the piston and causing a missfire.

Coolant is leaking into the head causing engine failure. This car has fewer than 60,00 miles. From what I have read this is a common problem and is due to a manufacturer’s design flaw. Ford refused to help me in any way when I contacted them. When I took the vehicle to the dealership they informed me that the engine would need to be replaced. The bill would be $13,000.

Check engine light would come on vehicle was not running well, seemed to stall. When I turned off the car I could hear liquid moving around from inside the vehicle. I am a Mom so I am driving with my 2 small children constantly and worried about their safety. The problem was confirmed by the dealership as well as an independent service center.

The vehicle has a 1.5L Ecoboost system which has a design flaw allowing coolant to leak into the engine. I was driving and the temperature went eradically high for no known reason and then instantly dropped. It began repeating this over and over. My mechanic told me it was a cracked head gasket and the coolant was below minimum levels because it was leaking into the engine. He told me it is a known mechanical design flaw with 2012-2019 Ford Escapes. Some were recalled some were not. Ford dealerships told me it is a known problem also. Ford will not stand behind their product and since my vehicle was not randomly picked for a recall, even though it is a known design flaw, they offer no assistance. I went online and read so very many others who have had this happen and that the reason all were not recalled was that there weren't enough complaints. So I wanted to speak out for those who didn't know how to as well as myself. I feel Ford should be held accountable for their actions. I thank God I was not stranded on a highway somewhere due to this issue or worse yet in an accicent.

Check engine light came on 3 weeks ago. Misfire codes on start up and cylinder 3. Mechanic replaced spark plugs, cleaned injectors. One week after repairs, check engine light came back on. Took vehicle back to the shop and after more tests, my engine showed it had suffered coolant intrusion and I was told a total replacement of the engine was needed.

Engine has been replaced three times already. Now, the engine has a constant cylinder 2 misfire with coolant level significantly decreasing. Car is shuddering real bad now. This is not the first time it happened. Before the third engine replacement, the car was moving on its own even with foot on the brakes. Very dangerous vehicle and unsafe.

The contact owns a 2018 Ford Escape. The contact stated that the engine overheated while driving, causing the contact to be four minutes late for work. There was white smoke coming from the exhaust while starting the vehicle. There was an abnormal odor coming from the vehicle. The check engine warning light was illuminated. The contact was concerned about having to purchase another vehicle. The vehicle was taken to the local dealer, where it was diagnosed and determined that there was coolant intrusion in the engine block. The contact stated that the purge valve assembly was replaced, but the failure recurred. The manufacturer was not notified of the failure. The failure mileage was approximately 38,000.