VEHICLE WAS PARKED AND CONSUMER WENT INSIDE. THEN TURNED VEHICLE ON AND IT ACELLERATED DUE TO THOTTLE PEDAL GETTING STUCK. VEHICLE WAS TURNING AROUND AND AROUND INSIDE HE PARKING LOT. CONSUMER KEPT KICKING THE PEDAL UNTIL IT LET UP. ALSO, WHEN SHE PUT KEY IN THE IGNITION, SHE HAD TO PULL AND TUSSLE IT FOR IT TO COME OUT.…
Read full complaint
VEHICLE WAS PARKED AND CONSUMER WENT INSIDE. THEN TURNED VEHICLE ON AND IT ACELLERATED DUE TO THOTTLE PEDAL GETTING STUCK. VEHICLE WAS TURNING AROUND AND AROUND INSIDE HE PARKING LOT. CONSUMER KEPT KICKING THE PEDAL UNTIL IT LET UP. ALSO, WHEN SHE PUT KEY IN THE IGNITION, SHE HAD TO PULL AND TUSSLE IT FOR IT TO COME OUT. *AK AFTER HAVING WORK DONE ON THE VEHICLE FOR THE SUDDEN ACCELERATION PROBLEM, THE CONSUMER RECEIVED RECALL 98V045002. THE CONSUMER WAS HAVING PROBLEMS WITH THE SEAT BELT RELEASING ON IT'S OWN. ON APRIL 13, 2000, THE DEALER REPLACED THE FUEL DOOR RELEASE SPRING, THE GAS TANK DOOR WOULDN'T OPEN. THE BRAKE LIGHT WAS ILLUMINATED. THE LOCK CYLINDER WAS RECODED ON JANUARY 31, 2000 DUE TO THE KEY WOULD NOT GO INTO THE IGNITION, SOMETIMES THE CONSUMER COULD MOVE THE STEERING WHEEL FROM LEFT TO RIGHT AND THE KEY WOULD WORK IN THE IGNITION. A NEW BATTERY WAS REPLACED ON JANUARY 28, 2000. NEW SPARK PLUGS WERE INSTALLED ON JANUARY 28, 2000. ON APRIL 13, 2000, THE AIR CONDITIONER COMPRESSOR WAS REPLACED. ON APRIL 13, 2000 THE GENERATOR BELT WAS REPLACED BECAUSE IT WAS WORN. *SLC
VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
Consequence & remedy
Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.
Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.
Consequence & remedy
Consequence: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.
Illustration