2007 Dodge Caliber

CONTROL ARM BROKE AND AXLE SNAPPED. THE CAR WAS INSPECTED IN SEPTEMBER. ALIGNMENT. NEW TIRES. I WAS UNABLE TO STEER OR STOP. SEEMS THE FRAME CANNOT SUPPORT THE WEIGHT OF THE CAR. THE MANUFACTURER IS AWARE OF THIS PROBLEM. THIS HAPPENED VERY UNEXPECTEDLY. I HAD BEEN ON HIGHWAY ALL DAY. BROKE AT HOME DEPOT PARKING LOT LESS THAN 1 HR. AFTER EXITING EXPRESSWAY. *SEE VOQ 11090509*

TL* THE CONTACT OWNS A 2007 DODGE CALIBER. WHILE DRIVING IN A PARKING LOT, THE FRONT DRIVER'S SIDE WHEEL DETACHED FROM THE VEHICLE. AS A RESULT, THE VEHICLE CRASHED INTO A LIGHT POLE. THE AIR BAGS DEPLOYED. THERE WERE NO INJURIES SUSTAINED. A POLICE REPORT WAS FILED. THE VEHICLE WAS TOWED TO THE DEALER (CANANDAIGUA CHRYSLER DODGE JEEP, 2591 ROCHESTER RD, CANANDAIGUA, NY 14424) WHERE IT WAS DIAGNOSED THAT THE CONTROL ARM FAILED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED AND INFORMED THE CONTACT THAT THE VEHICLE COULD NOT BE REPAIRED DUE TO THE CRASH; THEREFORE, THE CONTACT WOULD BE RESPONSIBLE FOR THE REPAIR COST. THE FAILURE MILEAGE WAS 130,000. *SEE VOQ 11090513*

TL* THE CONTACT OWNS A 2007 DODGE CALIBER. WHILE DRIVING 30 MPH, AN ABNORMAL NOISE WAS HEARD UNDERNEATH THE VEHICLE COMING FROM THE REAR DRIVER'S SIDE WHEEL. IN ADDITION, THE STEERING WHEEL VIBRATED. THE CONTACT DROVE THE VEHICLE HOME. THE CONTACT WAS ABLE TO INSPECT THE VEHICLE AND NOTICED RUST ON THE CROSSMEMBER. THE VEHICLE WAS NOT TAKEN TO A DEALER FOR DIAGNOSTIC TESTING OR REPAIRS. THE MANUFACTURER WAS NOT MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 131,000.

IN 2016 IT WAS DISCOVERED MY SUB-FRAME WAS RUSTED THRU. DISCOVERED DODGE HAD A SERVICE BULLENTIN NOT A RECALL SERVICE BULLETIN # 23-012-14, RE: BODY ISSUE DATE: MAY 19, 2014. THIS BULLETIN IS SUPPLIED AS TECHNICAL INFORMATION ONLY AND IS NOT AN AUTHORIZATION FOR REPAIR. NOTE: THIS ONLY APPLIES TO VEHICLES IN THE CANADIAN MARKET AND IN SALT BELT STATES WHICH INCLUDE CONNECTICUT, DELAWARE, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MISSOURI, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, WASHINGTON, D.C., WEST VIRGINIA AND WISCONSIN. DODGE ONLY REPLACED FRONT SUB-FRAME, NOW REAR SUB-FRAMES AND ALL ALONG ROCKER PANELS IS COMPLETELY ROTTED, ENOUGH THAT IT WON'T PASS PENNSYLVANIA STATE INSPECTION. I'VE OWNED VEHICLES IN THE PAST THAT WERE OLDER THAN THIS CALIBER & NEVER HAD THE RUST & ROT ISSUE I DO WITH THIS VEHICLE. IT IS JUST 10 YRS OLD!

TL* THE CONTACT OWNS A 2007 DODGE CALIBER. WHILE DRIVING 25 MPH, THE CONTACT HEARD AN ABNORMAL NOISE. THE CONTACT PARKED THE VEHICLE, INSPECTED THE UNDERCARRIAGE, AND NOTICED RUST FROM THE FRONT TO THE BACK OF THE SUBFRAME. THE CONTACT CALLED LOWERY BROS. CHRYSLER-JEEP, INC. AT (315) 472-7844 (647 W GENESEE ST, SYRACUSE, NY 13204), BUT THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER INFORMED THE CONTACT THAT THE VIN WAS NOT INCLUDED IN A RECALL. THE FAILURE MILEAGE WAS 116,000.

I BOUGHT A USED DODGE CALIBER OFF OF A FRIEND IN 2016. I RECENTLY STARTED HEARING A WEIRD METAL CLANKING IN THE FRONT DRIVER'S SIDE WHEEL AREA. I HAD BEEN ADVISED A YEAR PRIOR THAT I WOULD BE NEEDING TIRE RODS, STRUTS, AND BALL JOINTS IN THE NEAR FUTURE. SO I TOOK IT IN THE BE REPAIRED. AFTER SPENDING OVER $1000 TO GET IT ALL REPAIRED. I DROVE OFF AND THE NOISE WAS STILL THERE. WENT BACK TO THE SHOP AND AFTER 35-40 MINUTES OF ROCKING THE VEHICLE WE WERE ABLE TO RECREATE THE NOISE AND LOCATED THE NOISE WAS COMING FROM THE AREA OF THE CONTROL ARM AND SUB-FRAME. AFTER FURTHER INSPECTION WE FOUND THE THE SUB-FRAME TO BE RUSTED THROUGH WHICH WAS CAUSING THE METAL TO POP AND CRACK AS IT WAS FLEXING. I CONTACTED THE LOCAL DODGE SERVICE CENTER AND THEY ADVISED THERE WERE NO RECALLS IN REFERENCE TO THE SUB-FRAME. AFTER CHECKING ON LINE I FOUND THAT THERE HAD IN FACT BEEN A EXTENDED WARRANTY FOR THE SUB-FRAME FOR MY YEAR MAKE AND MODEL, BUT IT HAD EXPIRED IN 2016. I CALLED CHRYSLER AND THEY WERE AWARE OF THE ISSUE, BUT WOULD NOT HONOR THE ORIGINAL "WARRANTY" THAT THEY HAD PLACED ON THE SAME PART. SUBSEQUENTLY I ALSO FOUND THAT THEY HAD THE SAME "WARRANTY" ISSUED FOR THE SAME PART FOR THE SAME MAKE AND MODELS FROM 2008-20012. AFTER RESEARCH THROUGH THE INTERNET I FOUND HUNDREDS OF VEHICLE OWNERS LIKE ME THAT HAVE HAD THE SAME ISSUE WITH THE SAME RESULTS. I WAS NOT THE ORIGINAL OWNER AND WOULD HAVE NOT RECEIVED ANY NOTIFICATION FROM CHRYSLER ABOUT THE ISSUE WITH THE PART.

I HAVE OWNED THIS DODGE CALIBER FOR 6 YEARS NOW AND THE LOWER CONTROL ARMS ON THIS VEHICLE ARE A VERY POOR DESIGN. IN THE 6 YEARS THAT I HAVE OWNED THIS CAR I HAVE REPLACED THE LOWER CONTROL ARMS 3 TIMES. BOTH CONTROL ARMS WERE REPLACED EACH TIME BECAUSE THE BUSHINGS WERE BAD, CRACKED AND SPLIT. NOW FOR THE FOURTH TIME I WILL BE REPLACING THESE CONTROL ARMS BECAUSE OF THIS SAME ISSUE.

TL* THE CONTACT OWNS A 2007 DODGE CALIBER. THE CONTACT STATED THAT THE REAR DRIVER'S SIDE AND REAR CENTER SEAT BELTS BECAME DETACHED FROM THE REAR SUPPORT OF THE VEHICLE. THE VEHICLE WAS TAKEN TO BRENNER CHRYSLER JEEP (LOCATED AT 6039 CARLISLE PIKE, MECHANICSBURG, PA 17050, (717) 766-7686) WHERE IT WAS DIAGNOSED THAT THE SEAT BELTS NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 125,000. THE VIN WAS NOT AVAILABLE.