Suspension. Review the 26 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Electrical System. Review the 13 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Vehicle Speed Control. Review the 13 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

3 crash reports0 fire reports2 injury reports

Fuel System, Other complaints

2 reports

Clear category filter

Mileage unknown · Mar 9, 2010

Fuel System, OtherVehicle Speed Control

Read full complaint

2007 DODGE CALIBER R/T AWD. MY WIFE FOUND 2 SMALL BRASS BUSHINGS ON THE DRIVERS SIDE FLOOR. WHILE I WAS DRIVING THE CAR, DURING ACCELERATION ONTO AN INTERSTATE, IT APPEARED THAT THE ACCELERATOR PEDAL STUCK AND CAR CONTINUED TO ACCELERATE EVEN AFTER I REMOVED FOOT FROM PEDAL. I PULLED THE PEDAL UP WITH MY FOOT TO FREE UP PEDAL. I SEARCHED ONLINE AND FOUND A COUPLE OF OTHER REFERENCES TO A SIMILAR PROBLEM OCCURRING WITH OTHER CALIBER OWNERS. TOOK VEHICLE TO MY PREFERRED MECHANIC, AND HE HAS TO ORDER A NEW ACCELERATOR PEDAL ASSEMBLY. *TR

NHTSA ODI #10318078

45,000 miles · Feb 24, 2010

Fuel System, OtherVehicle Speed Control

Read full complaint

MY 2007 DODGE CALIBER HAS HAD 5 EPISODES OF THE ACCELERATOR GOING TO THE FLOOR AND THE CAR SPEEDING UP AND THE RPM GOING TO HIGH, EACH TIME I HAVE BEEN DRIVING. THE FIRST TIME FROM ARIZONA TO ARKANSAS AND AT APROX 800 MILES IT HAPPENED AND AS ONE IS WHEN TRAVELING I WAS TIRED AND THINGS WERE CLUTTERED SO I ASSUMED IT WAS THE FLOOR MAT AND PULLED IT DOWN AND WENT ON. I WAS ABLE TO PUT THE CAR IN NEUTRAL SO THAT I DID NOT SPEED UP AND HIT THE CAR IN FRONT OF ME. THE SECOND TIME I WAS DRIVING AND AFTER ABOUT 20 MILES IT DID THE SAME THING AND I TOOK THE MATT OUT. I WAS ABLE TO STICK MY FOOT UNDER THE PEDDLE AND PULL IT UP AND PUT THE CAR IN NEUTRAL AND THEN BACK IN DRIVE AND IT WAS THEN BEHAVING NORMAL. THE NEXT TIME I WAS SURPRISED BECAUSE I DID THINK IT WAS THE MATT AND THE MATT WAS GONE. DOING THE SAME THING PUTTING THE CAR IN NEUTRAL AS I WAS DRIVING AND BACK IN DRIVE , THIS TIME I HAD TO KEEP DOING THIS AS I COASTED ON THE ROAD AND ON THE 3 RD TIME IT WENT BACK TO NORMAL. THE REST IF THE TIMES WERE ON THE SAME TRIP TO THE DEALER, A 50 MILE TRIP, ALL THE SAME , THE CAR ACCELERATOR PEDAL GOES DOWN, THE CAR SPEEDS UP , I PUT IT IN NEUTRAL AND PULL THE PEDAL UP AND THEN AFTER A FEW TIMES IT WORKS FOR A UNDETERMINED AMOUNT OF MILES. THE DEALER HAS NOW TOLD ME THEY RESET THE SYSTEM AND IT SHOULD NOT HAPPEN AGAIN BUT SHOULD IT THEN THEY WILL NEED TO REPLACE SOME THINGS. DODGE IN RUSSELLVILLE ARKANSAS, I HOPE IT IS FIXED. MY FEAR IS THIS WILL HAPPEN AS I'M PULLING OUT SOMEWHERE AND CAUSE A WRECK, OR IT WILL HAPPEN TO SOMEONE ELSE AND THEY WON'T THINK SO FAST TO PUT CAR IN NEUTRAL, ON THE INTERNET I FOUND MANY STORIES ABOUT THE DODGE CALIBER ACCELERATOR THROTTLE NOT WORKING CORRECTLY AND DODGE DEALERS NOT SURE WHAT THE PROBLEM WAS , PLEASE CHECK INTO THIS TO SAVE LIVES BEFORE ANY ARE LOST THAT DON'T NEED TO BE LOST. THANK YOU *TR

NHTSA ODI #10313630

Official recalls

No recalls in this snapshot.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

PE10012 · Sticking Accelerator Pedal

Opened Apr 29, 2010 · Closed Aug 26, 2010

Status: closed (inferred from source dates) · Vehicle Speed Control:accelerator Pedal

In their Defect Information Report (DIR) of June 3, 2010, Chrysler Group, LLC (Chrysler) notified NHTSA that it will conduct a safety recall of approximately 25,265 model year 2007 Dodge Caliber vehicles and 71 model year 2007 Jeep Compass vehicles manufactured from March 7, 2006 through May 19, 2006.The recall will remedy a defect in the accelerator pedal assembly (accelerator pedal) of the Electronic Throttle Control (ETC) system that can cause the accelerator pedal to stick in an open position and not return to the idle position when released.As stated in the opening resume, the subject vehicles (Caliber) are equipped with an ETC accelerator pedal manufactured by the CTS Corporation, the same supplier of the ETC accelerator pedal used in the recently recalled Toyota vehicles.The ETC accelerator pedal used in Caliber and Compass vehicles is not the same as those used in the recalled Toyota vehicles.They are of a different design, were manufactured using different tooling, and fail in a different manner.According to Chrysler and CTS, oversized bearing pockets in the ETC accelerator pedal housing of the Caliber and Compass vehicles allows the accelerator pedal pivot shaft bearings to dislodge from the housing.If this occurs, the accelerator pedal can stick in an open position (i.e., fails to return to the closed position) or be slow to return.Chrysler's DIR notes that the subject vehicles are equipped with Smart Brake Technology and contends that the impact of a binding or sticking accelerator pedal can be negated by its Smart Brake system.In Chrysler's view, the system enables the brake pedal input to override the throttle control system and safely depower the vehicle and minimizes the potential for safety consequences resulting from the defect in the accelerator pedal.Further, Chrysler states, as a result of the presence of this technology, Chrysler Group LLC has concluded that the condition described in this report does not present an unreasonable risk to motor vehicle safety.ODI does not concur with Chrysler's position that the Smart Brake technology employed in the subject vehicles eliminates unreasonable risks to safety stemming from the ETC accelerator pedal defect.Aside from the fact that the technology is applicable only to situations where the brake pedal is activated, the Smart Brake system implemented in the subject vehicles will override a stuck throttle under a discrete set of conditions.Because driver behaviors (e.g., kicking at the accelerator pedal to dislodge it, or pumping the brake pedal instead of steady application) may delay or prevent activation of the Smart Brake system in the subject vehicles, ODI believes that this Smart Brake system does not totally eliminate unreasonable risks to safety posed by this defect or the necessity of a safety recall in this case.See Safety Recall file 10V-234 for recall details.