IllustrationCONSUMER RECEIVED RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR. DEALER WAS NOT IN OPERATION. *AK
2001 Daewoo Nubira
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 2001 Daewoo Nubira do not stand out strongly from the model-year median of 63.
About this comparison →How this year compares
Owner complaints by model year
Compare all Nubira years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
100–25K
1525–50K
1050–75K
475–100K
0100–150K
0150K+
39 reports with mileage · 83 unknown
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Engine And Engine Cooling. Review the 80 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 28 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Suspension. Review the 8 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
4 crash reports1 fire reports2 injury reports
What owners actually said
122 reportsDEALERSHIPS REFUSED TO HONOR CAM SHAFT POSITION SENSOR RECALL 04V357000 BECAUSE THEY WERE NO LONGER HONORING THIS MODEL WARRANTY WORK. THIS WAS THE SECOND DEALER CALLED.*AK
CONSUMER RECEIVED NHTSA RECALL 04V357000 REGARDING CRANK SHAFT POSITION SENSOR. NO DEALERSHIP WAS AVAILABLE, THE PHONE PROVIDED IN THE RECALL LETTER WAS NOT WORKING. *AK
CONSUMER RECEIVED RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR FROM THE MANUFACTURER AND WENT TO THE DAEWOO DEALERSHIP WHERE THE VEHICLE WAS PURCHASED. THE SERVICE DEPARTMENT WANTED TO CHARGE CONSUMER $40.00 FOR A DIAGNOSTIC TEST JUST TO BE SURE THAT THE DEFECT WAS AS DESCRIBED IN THE RECALL NOTICE. CURRENTLY, DEALERSHI…
Read full complaint
CONSUMER RECEIVED RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR FROM THE MANUFACTURER AND WENT TO THE DAEWOO DEALERSHIP WHERE THE VEHICLE WAS PURCHASED. THE SERVICE DEPARTMENT WANTED TO CHARGE CONSUMER $40.00 FOR A DIAGNOSTIC TEST JUST TO BE SURE THAT THE DEFECT WAS AS DESCRIBED IN THE RECALL NOTICE. CURRENTLY, DEALERSHIP WAS TELLING CONSUMER THAT PARTS WILL NOT BE AVAILABLE FOR 3 TO 4 WEEKS. *AK
CHECK ENGINE LIGHT IS ON. VEHICLE CANNOT GO OVER 40 MPH. NO DEALER TO REPAIR THE CAM SHAFT SENSOR RECALL 04V357000. *AK
FRONT LOWER BALL JOINTS FAILURE CAUSED THE FRONT TIRES TO WEAR OUT PREMATURELY. DEALERSHIP REPAIRED THE PROBLEM. *AK
RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR. CONSUMER WAS UNABLE TO FIND A DEALERSHIP NOR CONTACT THE NUMBER PROVIDED ON THE RECALL LETTER FOR DAEWOO SERVICE CENTER. *AK
CONSUMER RECEIVED A RECALL NOTICE(04V357000) FOR THE CAM POSITION SENSOR. DEALER WAS NOT IN OPERATION. *JB
04 V 357 000/CAMSHAFT POSITION SENSOR/MIL: THE CONSUMER WAS UNABLE TO FIND AN AUTHORIZED DEALER IN THE AREA TO PERFORM THE RECALL. *JB
THE CHECK ENGINE LIGHT WAS ON. THE RECALL LETTER STATED THE CAMSHAFT WAS DEFECTIVE. THE DEALER STATED THE ID NUMBER FOR THE PART DID NOT MATCH AND CHARGED THE CONSUMER FOR THE REPAIR. CAMSHAFT SENSOR 04V357000. *JB
Official recalls
304V394000 · Engine And Engine Cooling
Aug 6, 2004
ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.
Consequence & remedy
Consequence: THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.
Remedy: DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. OWNERS SHOULD CONTACT DAEWOO PUERTO RICO AT 1-877-362-1234 OPTION 6.
04V357000 · Engine And Engine Cooling
Jul 14, 2004
ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.
Consequence & remedy
Consequence: THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.
Remedy: DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.
02V257000 · Service Brakes, Hydraulic:foundation Components:hoses, Lines/piping, And Fittings
Sep 18, 2002
CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES." A CRACK CAN DEVELOP IN THE OUTER RUBBER LAYER OF THE FRONT BRAKE HOSE(S).
Consequence & remedy
Consequence: THIS CAN RESULT IN BRAKE HOSE RUPTURE, BRAKE FLUID LEAKAGE, AND LOSS OF VEHICLE BRAKING.
Remedy: DEALERS WILL INSTALL NEW REDESIGNED FRONT BRAKE HOSES. OWNER NOTIFICATION BEGAN OCTOBER 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAEWOO AT 1-877-362-1234, SELECTION 1.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.