2021 Chrysler Pacifica

The contact owns a 2021 Chrysler Pacifica. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed; however, the vehicle failed to accelerate as intended. The contact stated that the engine seized. No warning lights were illuminated. The vehicle was restarted and driven to the residence. The vehicle was taken to the dealer, but the failure was not duplicated. The contact was informed that several unknown software updates were completed. The failure reoccurred three months later. The contact stated that the failure was a persistent failure. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure. The failure mileage was approximately 50,000.

We took our 2021 Pacifica Hybrid to the dealership for Recall 52D. The first charge at home after the recall melted one of the charging "pins" in the car, and on our home Level 2 charger. Our dealership now says it's the fault of our charger, and we'll have to pay $2000+ for a repair. Our charger handle is still fine, no damage, only the "pin" is melted. For safety reasons, we can't charge the vehicle, and aren't driving it, as it's still at the dealership.

The contact owns a 2021 Chrysler Pacifica. The contact stated that the second-row seat failed to remain in the upright position, causing the seat to collapse forward or backward while the vehicle was being driven. The vehicle was inspected by a dealer who confirmed the seat failure but stated that the vehicle was not covered under NHTSA Campaign Number: 22V181000 (Seats). The contact received an estimate for the part; however, the part was on backorder. An independent mechanic later inspected the vehicle and suggested that the vehicle should be covered under the recall; however, inquiries to other dealers and the manufacturer resulted in consistent confirmation that the VIN was not under recall. A temporary repair was performed on the vehicle by the initial dealer; however, a permanent repair was not performed. The failure mileage was approximately 74,000.

Driving on the interstate at high speed, when check engine light comes on, warning message - Stop Safely Vehicle Will Shut Off - and red turtle warning indicator (limp mode). After a short time, vehicle will no longer accelerate. I pulled over to the shoulder, stopped and shut off engine. Restarted after a few minutes and everything appeared to work fine, with check engine light on. About 15 minutes later, it happened again. The dealership serviced the vehicle. Found error code P0A78 for driver moteo "A" inverter performance. Used Stellantis Technical Service Bulletin 08-253-24 to diagnose (both modules were out of date) and complete the indicated updates. This is a known issue that has affected many vehicles (per internet forums and that Stellantis has created a TSB. It is an extremely dangerous situation causing the vehicle to enter "limp mode" and requiring the driver to stop in a matter of minutes. Stellantis should recall all potentially affected vehicles to update the modules proactively.

This 2021 Chrysler Pacifica Hybrid has a severe and recurring history of catastrophic high-voltage hybrid powertrain and transmission failures that cause a sudden loss of motive power while driving, presenting an immediate safety hazard. The vehicle has already required two full automatic transmission (eFlite EVT) replacements under factory warranty due to internal failures. It has experienced multiple high-voltage component repairs, including software modules for the power inverter. The vehicle is currently experiencing a recurring failure and is displaying active diagnostic trouble code P0A78 (Drive Motor "A" Inverter Performance), indicating a critical fault in the high-voltage hybrid propulsion system. Prior to the current failure, the check engine light illuminated, and the vehicle experienced propulsion system degradation. This failure mode risks a sudden shutdown of the hybrid drive system at highway speeds, creating a severe risk of rear-end collisions or being stranded in active traffic. The recurring nature of these transmission and inverter failures indicates a systemic safety defect in the hybrid propulsion system. The issue and the active P0A78 code have been pulled, reproduced, and confirmed by an authorized dealership (Diehl Automotive of Robinson), where the vehicle is currently held and available for inspection. The manufacturer has been notified via an open corporate case (#97399722).

The contact owns a 2021 Chrysler Pacifica. The contact received notification of NHTSA Campaign Number: 26V362000 (Electrical System); however, the part for the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted. The dealer stated that the manufacturer had approved the battery pack as a remedy, but the part had not arrived. The contact stated the dealer had the vehicle for a month due to not having the part available, even though the remedy stated that it would be available 2 - 3 days. The manufacturer was made aware of the issue and redirected the contact to locate other dealers who might already have the high-voltage battery for repair in stock. The contact had not experienced a failure.

The vehicle is affected by a Chrysler safety recall. When I brought it to an authorized dealership for the recall repair, they informed me that a warning light was illuminated and that they needed to perform a diagnostic inspection before completing the recall. After the inspection, they stated they could not determine the cause of the warning light and refused to complete the recall repair. The vehicle is available for inspection upon request. The recall involves a safety issue that could put me, my passengers, and others at risk. Because the recall has not been completed, I do not feel safe operating the vehicle. In addition, I have been unable to use the vehicle for work because it has not been repaired. Yes. The authorized Chrysler dealership confirmed that the warning light was present and performed a diagnostic inspection. However, they were unable to identify the cause of the warning light and refused to complete the recall repair. They informed me that the case had been escalated to a Chrysler/Stellantis engineer. es. The vehicle was inspected by an authorized Chrysler dealership. The dealership escalated the case to a Chrysler/Stellantis engineer, but after more than three weeks, no solution or repair has been provided. The dealership informed me that a warning light was illuminated and required diagnosis before the recall could be completed. After performing the diagnostic inspection, they were unable to determine the cause of the warning light. The recall repair has been delayed for more than three weeks without any resolution or estimated completion date.

I took the van to get the safety recall done in 2026, Feb 25. For the rear view back up camera. I took it to the same dealership that I bought the car from, Jones Junction. However, upon further complications with the back up camera, this issue has never been fixed or resolved. If anything, the issue has become worse. I am unable to use my camera 98% of the time. It freezes. It goes black or is unavailable to see anything out of. It's a safety recall for a reason. I want this issue fixed. As I have been driving like this with the issue for quite some time. What are my next steps? I prefer not to have to dealer hop if I can help it. But I might have to. Is there a patch they may have to do to re-install the software for the camera? Or would they have to go and flash it again and what ever else? My true gut tells me that I dont think this specific dealership ever did the recall, correctly.