2005 Chevrolet Suburban 1500

I HAD A RUSTED BRAKE LINE (DRIVER SIDE FRONT) FAIL JUNE 25TH, 2017. THIS TRUCK IS 12 YEARS OLD AND HAS LESS THAN 90,000 MILES. IMMEDIATELY ALL BRAKING WAS LOST AND THE PEDAL PUSHED TO THE FLOOR. REPEATED PRESSING THE BRAKE ONLY PUMPED OUT ALL THE BRAKE FLUID. THIS WAS A SUDDEN AND CATASTROPHIC LOSS OF BRAKING. THE WORST PART IS, BRAKING IS SUPPOSED TO BE SPLIT AND INDEPENDENT BETWEEN FRONT AND REAR BRAKES, SO IF YOU LOSE THE FRONT, THE REAR BRAKES STILL WORK, AND VICE VERSA. WELL I LOST ALL BRAKING, I HAD NO FRONT OR REAR BRAKING! THIS SHOULD BE A CLEAR SAFETY PROBLEM AND A MANDATORY RECALL! I CRASHED INTO THE CAR IN FRONT OF ME, BECAUSE OF COURSE MY EMERGENCY BRAKE DIDN'T WORK EITHER. DESPITE GM'S INSISTENCE THAT SOMEHOW THIS PREMATURE BRAKE LINE FAILURE IS NORMAL AND THE OWNER'S MAINTENANCE PROBLEM, IT SHOULD BE A VERY SIMPLE ISSUE FOR THE NHTSA TO SIMPLY OPEN A SINGLE BRAKE LINE AND TEST TO REALIZE THE AFFECTED VEHICLES DO IN FACT LOSE ALL BRAKING, NOT JUST FRONT OR REAR. I'VE ALREADY COMPLETELY LOST FAITH IN GM TO DO THE RIGHT THING, BUT I'D LIKE TO BELIEVE THE NHTSA WILL STILL DO THE RIGHT THING, AND NOT LET GM OFF WITH A CLEAR SAFETY PROBLEM WITH THEIR BRAKE DESIGN. THIS CRASH WAS PULLING UP TO THE STOPLIGHT IN PRESCOTT, WI, HEADING INTO TOWN ACROSS THE PRESCOTT BRIDGE. I WAS DRIVING MAYBE 30 MPH WHEN I REALIZED I HAD LOST ALL BRAKES.

FIRST INCIDENT EASTERN PA: 05/19/2014 APROX 119000 MILES: AFTER HITTING THE BRAKES HARD TO AVOID A VEHICLE THAT PULLED IN FRONT OF ME, THE BRAKES FAILED (BRAKE PEDAL WOULD GO TO THE FLOOR WITH LITTLE BRAKING ACTION). MANAGED TO SAFELY STOP. FOUND BURST BRAKE LINE IN THE REAR END OF VEHICLE. TWO REAR CORRODED REAR BRAKE LINES REPLACED BY LOCAL REPAIR SHOP. SECOND INCIDENT MILFORD MA: 09/17/2015 127336 MILES: HIT BRAKES GOING DOWN DRIVEWAY. BRAKES WERE SOFT AND SANK TO FLOOR. BRAKE LINE GOING TO FRONT PASSENGER WHEEL WAS BURST. ALL THE BRAKE FLUID DRAINED QUICKLY OUT OF THE MASTER CYLINDER ONTO THE DRIVEWAY. ORDERED ACDELCO 22932592 GM ORIGINAL EQUIPMENT HYDRAULIC BRAKE PIPE KIT AND AM IN THE PROCESS OF REPLACING ALL BRAKE LINES AS ALL OF THEM OTHER THAN THE TWO REPLACED IN PA ARE VERY CORRODED. THE REPLACEMENT LINES ARE NOT REALLY OEM AS THEY HAVE A NYLON COATING FOR BETTER CORROSION PROTECTION

TL* THE CONTACT OWNS A 2005 CHEVROLET SUBURBAN 1500. WHILE DRIVING IN REVERSE, THE CONTACT WAS UNABLE TO STOP THE VEHICLE BY DEPRESSING THE BRAKE PEDAL. THE CONTACT HAD TO DEPRESS THE BRAKE PEDAL TO THE FLOORBOARD IN ORDER TO STOP THE VEHICLE. THE MECHANIC STATED THAT THE BRAKE LINES WERE ROTTED. THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE FAILURE MILEAGE WAS UNAVAILABLE.

WENT TO MOVE VEHICLE TO ATTACH LANDSCAPE TRAILER. BRAKES WENT DOWN TO THE FLOOR. UPON INVESTIGATION, FOUND BRAKE FLUID ON GROUND FROM DRIVER SIDE RIGHT FRONT. HAD VEHICLE TOWED TO REPAIR STATION AND ASKED MECHANIC TO REPLACE BRAKE LINE AND CHECK ALL OTHER BRAKE LINES. MECHANIC ENDED UP REPLACING 80% OF LINES DUE TO CORROSION. THIS COULD HAVE ENDED UP RESULTING IN AN ACCIDENT IF THE VEHICLE WAS MOVING WITH THE TRAILER ATTACHED CARRYING ATV'S. IN ADDITION, THE CABLE HOLDING THE SPARE TIRE HAD TO BE CUT IN ORDER TO GET ACCESS TO REAR BRAKE LINES. THE CABLE WAS RUSTED MEANING THAT A TIRE COULD NOT BE CHANGED IN THE EVENT OF A FLAT. *TR