2018 Chevrolet Silverado 1500

TRANSMISSION STARTED SHIFTING WEARD CONTACTED DEALERSHIP. THEY STATE THIS UNIT IS NOT UNDER RECALL BUT IT IS AN 6L80 AND IT IS ALL OVER YOU TUBE AND THE INTERNET ABOUT FAILURES THAT START WITH THE PM VALVE AND/OR THE TORQUE CONVERTER HOUSING THAT IS STAMPED BUT MOUNTING BRACKETS ARE WELDED TO IT CAUSING HARDED STEEL TO MEET STAMPED STEEL CAUSING FRICTION AND WEAR THAT POLUTES THE REMAINDER OF THE TRANSMISSION AND CAUSES FAILURE BEFORE 100000 MILES; USUALLY JUST AFTER 50000ISH. WHEN TRANSMISSION FAILS IT CAN CAUSE LOSS OF PROPULSION OR COLLION.

The high pressure fuel pump has failed at only 60,000 miles. My Safety along with the safety of others has been put at risk from major loss of power... not safely stopping the vehicle due to fuel pressure malfunction. Certified Chevy Dealer diagnosed high pressure fuel pump Come to find out from the dealer... a warning sign was the electric start button not working. Engine light did NOT come on till after the truck had major power loss/ misfire/ stall.

While driving my 2018 Silverado, the 5.4L, 327c.i. engine began idling very rough, shaking and periodically stalling. The check engine light began blinking and it threw codes PO308 & PO301. After compression test & new plugs/wires, it was found that the injectors had open circuits on injector #'s 1 & 8. The only way to replace the injector is through the bank. In this case both banks 1 & 2 were affected. Cylinder #1 is through bank #1 & cylinder #8 is through bank # 2. After removing the intake manifolds and injectors, it was found that the injectors were not providing fuel to the engine causing a misfire on 2 random cylinders #1 & #8. Called the dealer to order parts and discovered they have already been superseded. Original part# is 12698484 and it has been superseded by part# 12710481. Then injectors were replaced & new intake manifold gasket installed w/ proper torque. After repair completed and engine tested, the problem was resolved. Repair shop's invoice will be attached for reference.

The plastic fuel pump module (GM part # 13510918) has cracked. The top flange that rests against the top of the fuel tank has an approximately 3 inch crack. The indications were a failed EVAP Check Engine Light PO442 (Small leak). The vehicle had less than 35K miles at the time. Contacted dealer who stated that it was a common problem. Also contacted GM but they provided no assistance. This crack could lead to fuel leaking from the top of the tank. The issue required the fuel pump module assembly to be replaced.

The component or system that failed or malfunctioned, FUEL PUMP ( METAL FLAKING IN FUEL SYSTEM ) has caused 1 or more CYLINDERS to FAIL. It is available for inspection upon request. My safety as well as the safety of many other motorists was put at high risk due to the fact that I had a 40ft. trailer hitched to the truck at the time the engine power was reduced. thus causing my vehicle to loose power while driving on a major highway. The 2018 Chevy Silverado was diagnosed by the Chevrolet Dealership doing-business-as ASCHENBACH CHEVROLET located at 925 East Main Street, Wytheville, VA 24382. The vehicle has not been inspected by the Manufacturer. When pressing down on the gas pedal, the truck would not accelerate as normal, then a message appeared on the dash-screen ENGINE LOOSING POWER. MAJOR ENGINE FAILURES & REPRODUCED REPAIRS: **JANUARY 2022 ENGINE REBUILT/REPLACED - Seguin Chevy Dealership **APRIL 2022 FAILED KNOX SENSORS - POWER REDUCED - Rush Elgin Chevy **NOVEMBER 2022 ENGINE REPLACEMENT, FAILED FUEL INJECTORS, GLO PLUGS & COOLANT LEAK - Robbins Chevy Dealership ** SEPTEMBER 2023 FAILED FUEL PUMP, FUEL INJECTORS - Aschenbach Chevy

UNKNOWN I had performed preventative maintenance this evening, fuel filter replacement and noticed after I pulled the fuel filter from the housing and tipped housing back upright, there was what appeared to be brass/gold metal shavings in the bottom of the housing in a little puddle of fuel. If there is metal shavings in the filter, that is a problem. Not sure if it would be fuel pump, or lift pump. Truck runs fine, I do get some hesitation from time to time, but not always. No warning lights/indicators, no water in fuel indicator, or presence of water in fuel. I am worried about safety if metal shavings contaminate entire fuel system, plugging injectors shutting down the truck on the interstate.