2006 Chevrolet Silverado 1500

I HAVE A HOME IN THE HILLS OF WEST VIRGINIA AND HAD JUST RETURNED FROM TOWN AFTER DRIVING UP AND DOWN LOCAL MOUNTAIN ROADS. I PARKED IN THE DRIVEWAY WITHOUT INCIDENT. WHEN I STARTED THE TRUCK TO MOVE IT IN DRIVEWAY AND PRESSED ON THE BRAKE PEDDLE, THE PEDDLE WENT COMPLETELY TO THE FLOOR AND I WAS TOTALLY WITHOUT BRAKES. LUCKILY, I WAS ON A FLAT SURFACE AND USED MY EMERGENCY BRAKE TO STOP VEHICLE. WHEN I STEPPED ON THE BRAKES AGAIN, I NOTICED A STREAM OF BRAKE FLUID SQUIRTING OUT FROM THE AREA UNDER THE DRIVER SIDE DOOR. UPON FURTHER INVESTIGATION I REALIZED THAT ONE OF THE BRAKE LINES ALONG THE FRAME HAD FAILED DUE TO CORROSION. ONLY ONE OF THE 4 BRAKE LINES HAD FAILED, HOWEVER, THE ENTIRE BRAKING SYSTEM WAS RENDERED COMPLETELY INOPERABLE. ABSOLUTELY NO REDUNDANT BRAKING AVAILABLE, EXCEPT FOR THE EMERGENCY BRAKE. IF THIS HAPPENED WHILE DRIVE ON THE HIGHWAY OR DOWN THE MOUNTAIN, IT COULD HAVE BEEN CATASTROPHIC. THE TRUCK HAS NO VISIBLE BODY OR FRAME CORROSION. HOW COULD THE THE SAFETY-CRITICAL BRAKE LINES CORRODE WHEN THE REST OF THE VEHICLE IS IN GOOD SHAPE RUST-WISE? SEEMS GM HAS USED SUB-STANDARD BRAKE LINES IN THE VEHICLE. I HAVE RESEARCHED THIS ISSUE AND IT IS A WELL-DOCUMENTED PROBLEM THAT GM KNOWS ABOUT AND SHOULD BE REQUIRED TO ADDRESS.

THERE IS EXTREME FRAME RUST CAUSING THE SPARE TIRE MOUNT TO BECOME DETACHED FROM THE FRAME WHILE DRIVING ALONG THE HIGHWAY. FORTUNATELY THIS HAPPENED ON A SECONDARY ROAD IN SOUTH WEST VIRGINIA. THE SHOCK ABSORBER WAS THE ONLY THING THAT HELD THE SPARE TIRE MOUNT FROM COMING COMPLETELY LOOSE FROM THE TRUCK. AFTER INSPECTING THE FRAME, THERE IS EXCESSIVE RUST ON THE MAIN FRAME AND ONE OF THE CROSS MEMBERS IS NEARLY RUSTED THROUGH. THIS TRUCK IS NINE YEARS OLD AND ONLY HAS 63K MILES. I HAVE THE TRUCK AT THE DEALERSHIP FOR THEM TO SEE IF IT IS SAFE TO DRIVE I AM AWAITING TO HEAR FROM THEM TO SEE IF GM IS GOING TO HELP ME WITH THIS MATTER.

TL* THE CONTACT OWNS A 2006 CHEVROLET SILVERADO 1500. WHILE DRIVING APPROXIMATELY 35 MPH, THE BRAKE PEDAL WAS DEPRESSED, BUT THE VEHICLE HESITATED TO STOP. THE VEHICLE WAS TOWED TO AN INDEPENDENT MECHANIC FOR DIAGNOSTIC TESTING. THE MECHANIC REPLACED THE BRAKE SYSTEM BUT THE FAILURE RECURRED. THE VIN WAS UNAVAILABLE. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 110,000.

TL* THE CONTACT OWNS A 2006 CHEVROLET SILVERADO 1500. UPON INSPECTING UNDERNEATH THE VEHICLE, THERE WAS EXTENSIVE RUST AND CORROSION ON THE BRAKE LINES. THE CONTACT ALSO INDICATED THAT THE BRAKE LINES PREMATURELY FRACTURED. VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 87,000. UPDATED 11/04/15*LJ UPDATED2/2/2016*JS

I FILLED UP MY GAS TANK ON 8-10-2015 AND WAS DRIVING AT 70 MILES A HOUR WHEN THE ENGINE JUST SHUT DOWN. I RESTARTED IT AND IT STARTED MISSING OUR REAL BAD, I THOUGHT IT WAS MAYBE SOME BAD GAS. I NOTIFIED THE GAS STATION AND THEY STARTED CHECKING THE GAS OUT. WHILE THEY WERE DOING THAT, I TOOK IT TO A MECH. AS THEY SAID IT WAS PROBABLE THE GAS, PUT A CAN OF SEAFOAM AND TRY TO USE THE GAS UP. I DID AND IT KEPT GETTING WORSE , IT WOULD NOT IDLE AND KEPT STALLING OUT. I TOOK IT TO A MECH AND THEY FOUND A INTERMITTING WIREING PROBLEM. IT WAS A "IGNITION COIL WIRE HARNESS"TOOK TO DAYS TO FIND, THEY REPLACED IT AND RUNS GOOD NOW..ODOMETER READING WAS 55315. THEY CHECKED EVERY THING TWICE BEFORE THEY FOUND THE PROBLEM IN THE 2 DAYS THEY HAD IT.

WHEN SLOWING DOWN TO STOP,APP 5 TO 10 MPH,BEFORE STOP.BRAKE PEDEL WILL SOFT AND PLUSE LIKE BRAKES WENT AWAY BUT STOPING YOU.ITS FEELS LIKE YOU LOST YOUR BRAKES.ITS BEEN STEATY APP 9 OUT OF 10 TIMES. HAD VEHICLE CHECK OUT SEVERAL PLACES FOR BAKES ISSUES,NEW ROTORS ,PADS ,DRUMS,AND SHOES .PLUG IN COMPUTER NO CODES ON BRAKES OR ABS SYSTEM.ITS CAN BE SCARY WHEN DRIVING TRYING TO STOP.

TRAVELED TO STORE ABOUT FOUR BLOCKS AWAY FROM MY RESIDENCE. UPON RETURNING, I NOTICED MY BRAKES BARELY WORKING WHILE GOING DOWNHILL ON STREET. I HAD TO DOWNSHIFT AND USE EMERGENCY BRAKE TO GET TO BOTTOM OF HILL. AT BOTTOM OF HILL IS MY DRIVEWAY. I WAS ABLE TO ENTER MY DRIVEWAY AND PARK. I COULD SEE A LIQUID DRIPPING RAPIDLY -- BRAKE FLUID-- UNDER THE TRUCK ABOUT THE MIDDLE OF THE DRIVERS SIDE DOOR. I OPENED THE HOOD AND CHECKED THE BRAKE FLUID LEVEL, ONLY A SMALL AMOUNT LEFT. WITHIN FIVE MINUTES THE REST OF THE BRAKE FLUID HAD DRAINED OUT WITH GRAVITY. THANKFULLY NO ONE WAS IN FRONT OF ME OR CROSSING THE STREET. NOTE: THERE WAS NO INDICATION ON DASH LIT PRIOR TO THIS HAPPENING. BRAKING LOSS HAPPENED FIRST. SEEMS LIKE BRAKE LINE JUST SPLIT/BURST.

LEAVING MY DRIVE WAY MY BRAKE PEDDLE WENT ALL THE WAY TO THE FLOOR. I HAD TO USE EMERGENCY BRAKE TO STOP TRUCK. AFTER CHECKING FOR PROBLEM I FOUND THAT THE METAL BRAKE LINE FROM THE MASTER CYLINDER TO THE BRAKES HAD RUSTED THROUGH IN THE ENGINE AREA AND BRAKE FLUID WAS BEING SPRAYED ON THE MANIFOLD. (IF ENGINE WAS HOTTER THEIR COULD HAVE BEEN A FIRE.) TRUCK IS SITTING IN MY DRIVEWAY STILL NOT FIXED.