2018 Chevrolet Malibu

The contact owns a 2018 Chevrolet Malibu. The contact stated that while coming to a stop, the brake pedal suddenly became inoperable. There was no warning light illuminated. The contact stated that excessive force was required to depress the brake pedal. The contact stated that the brake pedal went to the floorboard while stopping the vehicle. The contact then stated that after pulling into a parking lot, the contact attempted to restart the vehicle; however, the vehicle failed to start with the check engine warning light illuminated. The vehicle was taken to an independent mechanic, but was not diagnosed or repaired. The dealer was contacted, but the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 111,000.

After diagnostic troubleshooting from DTCs on a check engine light, it was discovered that the brake vacuum pump connected to the engine was completely nonfunctional. Previous symptoms included stiff brake, loss of brake power at random brake periods which could have cause and accident with other drivers, and finally malfunctioning sensors attributed to the exhaust system. This also led the vehicle to be unable to pass state regulated Emissions testing because of the inability to maintain proper emissions levels. Brake Vacuum pump that was removed from vehicle to inspect and diagnose is still available for inspection. Recent findings show that Chevrolet/GM is aware of the issue in their vehicles but refuses to address or replace faulty brake vacuum pumps. It is a common problem amongst 2013-2022 Chevrolet Malibus. Vehicle that is in question was inspected by a certified mechanic shop with failed emissions test. Solid check engine light appeared once the brake had become harder to push and stop the car. OBD scans show DTC codes that were pertaining to MAF and MAP malfunctions in readouts and communications to the ECM. After further inspection, the ABS module had been acting as "backup" for hydrolic brakes system that had zero vacuum to power the brake booster, this could have caused the engine to stall, longer than normal stopping distances (stronger risk of rear ending other drivers), and multiple components and sensors to fail, requiring them to also be replaced.

The vacuum pump for the brake assist is made from bad metal which can break and screw up the camshaft, chevy knows of this problem they have a recall for the 2017 model but not the 2018 which they both have the same exact problem, they need to take care of this it is a major safety issue, I have no brakes and it could potentially ruin my engine.

The contact owns a 2018 Chevrolet Malibu. The contact stated that there was a strong fuel odor coming from the vehicle. The contact stated that the engine was difficult to turn over. The TPMS warning light was illuminated. The vehicle was taken to an independent mechanic who determined that the fuel injectors were leaking. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 123,074.

The contact owns a 2018 Chevrolet Malibu. The contact stated that while driving at an undisclosed speed, the vehicle was jerking, and the message "Power Steering Assist Fault" was displayed. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 127,605.