2008 Chevrolet Hhr

Air Bags

This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on February 10, 2014 that they are recalling 619,122 model year 2005-2007 Chevrolet Cobalt, and 2007 Pontiac G5 vehicles. On February 25, 2014, GM increased the recall to include an additional 748,024 model year 2006-2007 Chevrolet HHR and Pontiac Solstice vehicles and 2003-2007 Saturn Ion vehicles and 2007 Saturn Sky vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. On March 27, 2014, GM notified the agency that the defective ignition switches may have been used as service replacement parts on other vehicles, and as a result GM will be recalling certain model year 2008-2010 Chevrolet Cobalt, Saturn Sky, and Pontiac G5 and Solstice, and 2008-2011 Chevrolet HHR vehicles. The part numbers for the service parts are 10392423 (a/k/a ACDelco D1461F), 10392737, 15857948, 15854953, 15896640, and 25846762. This expansion represents an additional 823,788 vehicles.

Consequence: If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury.

Remedy: GM will notify owners, and dealers will replace the ignition switch, free of charge. An interim notification was issued to owners of 2007 and earlier models on March 10, 2014, informing them of the safety defect. Owners of 2008 and later vehicles will be mailed an interim letter on April 21, 2014. All affected owners will receive another letter once parts are available. The recall began on April 18, 2014. Owners may contact Chevrolet at 1-800-222-1020, Pontiac at 1-800-762-2737 or Saturn at 1-800-553-6000. GM's number for the initial recall is 13454 and 14063 for the expansion. GM’s recall number for the vehicles that may have received the replacement parts is 14092. Note: Until the recall repairs have been performed, it is very important that customers remove all items from their key rings, leaving only the vehicle key. The key fob (if applicable), should also be removed from the key ring. Always wear your seatbelt.

Electrical System:ignition:switch

This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on February 10, 2014 that they are recalling 619,122 model year 2005-2007 Chevrolet Cobalt, and 2007 Pontiac G5 vehicles. On February 25, 2014, GM increased the recall to include an additional 748,024 model year 2006-2007 Chevrolet HHR and Pontiac Solstice vehicles and 2003-2007 Saturn Ion vehicles and 2007 Saturn Sky vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. On March 27, 2014, GM notified the agency that the defective ignition switches may have been used as service replacement parts on other vehicles, and as a result GM will be recalling certain model year 2008-2010 Chevrolet Cobalt, Saturn Sky, and Pontiac G5 and Solstice, and 2008-2011 Chevrolet HHR vehicles. The part numbers for the service parts are 10392423 (a/k/a ACDelco D1461F), 10392737, 15857948, 15854953, 15896640, and 25846762. This expansion represents an additional 823,788 vehicles.

Consequence: If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury.

Remedy: GM will notify owners, and dealers will replace the ignition switch, free of charge. An interim notification was issued to owners of 2007 and earlier models on March 10, 2014, informing them of the safety defect. Owners of 2008 and later vehicles will be mailed an interim letter on April 21, 2014. All affected owners will receive another letter once parts are available. The recall began on April 18, 2014. Owners may contact Chevrolet at 1-800-222-1020, Pontiac at 1-800-762-2737 or Saturn at 1-800-553-6000. GM's number for the initial recall is 13454 and 14063 for the expansion. GM’s recall number for the vehicles that may have received the replacement parts is 14092. Note: Until the recall repairs have been performed, it is very important that customers remove all items from their key rings, leaving only the vehicle key. The key fob (if applicable), should also be removed from the key ring. Always wear your seatbelt.

Fuel/propulsion System

On July 5, 2020, the Office of Defects Investigations (ODI) opened PE20-011 to investigate instances of metal fuel lines under the vehicle corroding and leaking fuel in model year (MY) 2008 through 2010 Chevrolet Cobalt and 2008 through 2009 Chevrolet HHR passenger cars manufactured by General Motors (GM). The metal fuel lines are corroding and leaking fuel in the area between the front and rear wheels on the driver's side of the vehicle before the muffler. Most consumers allege a fuel odor and/or an observable fuel leak that alerts them to the condition.The subject metal fuel lines have a protective AGE coating and, in the vicinity of the left rear wheel, are further wrapped in a foil heat shield. The AGE coating consists of an annealed zinc aluminum alloy metal coating with extended corrosion protection paint. Under certain conditions, water and corrosive road deicing agents may enter a crevice between the heat shield and the AGE coating. With extended environmental exposure in high corrosive environments, the AGE coating can degrade. If it degrades enough, the base metal lines may begin to corrode beneath the heat shield.Corrosion to the fuel lines may eventually cause a perforation to develop in the line, allowing fuel vapors to escape from between the line and the heat shield, emitting a fuel odor that will be detectable to the vehicle operator. If the corrosion progresses, fuel may begin to weep from the line. Further metal degradation due to corrosion could create a drip or a mist of fuel. If this occurs, vehicle owners may see drips, spots, or puddles on the ground near the rear portion of the vehicle, primarily along the driver's side rear wheel.The majority of allegations (85%) were reported for vehicles that are operated in the salt belt region of the United States. This area includes states in the Northeast, mid-Atlantic, and Midwest regions. Additionally, the average failure mileage in the subject vehicles is approximately 111,000 across all data sources.Considering the low manufacturer complaint/warranty rates of fuel line replacement, the fact that the majority of failures are concentrated in salt belt states, high failure mileages, as well as the field exposure time for the subject vehicles, and the highly detectable and progressive nature of this failure over time, the potential safety consequences of this issue are very low. To date, there have been no reported crashes, injuries, or fatalities related to this issue. There are two reported fires in ODI data and no reported fires in GM data. Both ODI reported fires were minor, occurred after the vehicle was parked, and were extinguished utilizing fire extinguishers.In view of the progressive failure occurring at high mileages, the age of the subject vehicles, the high detectability of the leak, and the majority of failures occurred in salt belt states, this Preliminary Evaluation is closed. The agency reserves the right to take additional action if warranted by new circumstances.Review the ODI reports cited above at nhtsa.gov under the attached identification numbers.

Fuel System, Gasoline

On July 5, 2020, the Office of Defects Investigations (ODI) opened PE20-011 to investigate instances of metal fuel lines under the vehicle corroding and leaking fuel in model year (MY) 2008 through 2010 Chevrolet Cobalt and 2008 through 2009 Chevrolet HHR passenger cars manufactured by General Motors (GM). The metal fuel lines are corroding and leaking fuel in the area between the front and rear wheels on the driver's side of the vehicle before the muffler. Most consumers allege a fuel odor and/or an observable fuel leak that alerts them to the condition.The subject metal fuel lines have a protective AGE coating and, in the vicinity of the left rear wheel, are further wrapped in a foil heat shield. The AGE coating consists of an annealed zinc aluminum alloy metal coating with extended corrosion protection paint. Under certain conditions, water and corrosive road deicing agents may enter a crevice between the heat shield and the AGE coating. With extended environmental exposure in high corrosive environments, the AGE coating can degrade. If it degrades enough, the base metal lines may begin to corrode beneath the heat shield.Corrosion to the fuel lines may eventually cause a perforation to develop in the line, allowing fuel vapors to escape from between the line and the heat shield, emitting a fuel odor that will be detectable to the vehicle operator. If the corrosion progresses, fuel may begin to weep from the line. Further metal degradation due to corrosion could create a drip or a mist of fuel. If this occurs, vehicle owners may see drips, spots, or puddles on the ground near the rear portion of the vehicle, primarily along the driver's side rear wheel.The majority of allegations (85%) were reported for vehicles that are operated in the salt belt region of the United States. This area includes states in the Northeast, mid-Atlantic, and Midwest regions. Additionally, the average failure mileage in the subject vehicles is approximately 111,000 across all data sources.Considering the low manufacturer complaint/warranty rates of fuel line replacement, the fact that the majority of failures are concentrated in salt belt states, high failure mileages, as well as the field exposure time for the subject vehicles, and the highly detectable and progressive nature of this failure over time, the potential safety consequences of this issue are very low. To date, there have been no reported crashes, injuries, or fatalities related to this issue. There are two reported fires in ODI data and no reported fires in GM data. Both ODI reported fires were minor, occurred after the vehicle was parked, and were extinguished utilizing fire extinguishers.In view of the progressive failure occurring at high mileages, the age of the subject vehicles, the high detectability of the leak, and the majority of failures occurred in salt belt states, this Preliminary Evaluation is closed. The agency reserves the right to take additional action if warranted by new circumstances.Review the ODI reports cited above at nhtsa.gov under the attached identification numbers.

Fuel System, Other:delivery:hoses, Lines/piping, And Fittings

On July 5, 2020, the Office of Defects Investigations (ODI) opened PE20-011 to investigate instances of metal fuel lines under the vehicle corroding and leaking fuel in model year (MY) 2008 through 2010 Chevrolet Cobalt and 2008 through 2009 Chevrolet HHR passenger cars manufactured by General Motors (GM). The metal fuel lines are corroding and leaking fuel in the area between the front and rear wheels on the driver's side of the vehicle before the muffler. Most consumers allege a fuel odor and/or an observable fuel leak that alerts them to the condition.The subject metal fuel lines have a protective AGE coating and, in the vicinity of the left rear wheel, are further wrapped in a foil heat shield. The AGE coating consists of an annealed zinc aluminum alloy metal coating with extended corrosion protection paint. Under certain conditions, water and corrosive road deicing agents may enter a crevice between the heat shield and the AGE coating. With extended environmental exposure in high corrosive environments, the AGE coating can degrade. If it degrades enough, the base metal lines may begin to corrode beneath the heat shield.Corrosion to the fuel lines may eventually cause a perforation to develop in the line, allowing fuel vapors to escape from between the line and the heat shield, emitting a fuel odor that will be detectable to the vehicle operator. If the corrosion progresses, fuel may begin to weep from the line. Further metal degradation due to corrosion could create a drip or a mist of fuel. If this occurs, vehicle owners may see drips, spots, or puddles on the ground near the rear portion of the vehicle, primarily along the driver's side rear wheel.The majority of allegations (85%) were reported for vehicles that are operated in the salt belt region of the United States. This area includes states in the Northeast, mid-Atlantic, and Midwest regions. Additionally, the average failure mileage in the subject vehicles is approximately 111,000 across all data sources.Considering the low manufacturer complaint/warranty rates of fuel line replacement, the fact that the majority of failures are concentrated in salt belt states, high failure mileages, as well as the field exposure time for the subject vehicles, and the highly detectable and progressive nature of this failure over time, the potential safety consequences of this issue are very low. To date, there have been no reported crashes, injuries, or fatalities related to this issue. There are two reported fires in ODI data and no reported fires in GM data. Both ODI reported fires were minor, occurred after the vehicle was parked, and were extinguished utilizing fire extinguishers.In view of the progressive failure occurring at high mileages, the age of the subject vehicles, the high detectability of the leak, and the majority of failures occurred in salt belt states, this Preliminary Evaluation is closed. The agency reserves the right to take additional action if warranted by new circumstances.Review the ODI reports cited above at nhtsa.gov under the attached identification numbers.