THIS CAR IS A 97 Z28 WITH THE 350CI MOTOR AND 4 SPEED AUTO TRANSMISSION. WHAT HAPPENS IS THAT WHEN THE FRONT WHEELS ARE NOT TURNING, THE REAR BRAKES DO NOT ENGAGE, NO MATTER HOW HARD YOU PUSH DOWN ON THE BRAKE PEDAL. THE ISSUE PRESENTS ITSELF UNDER ICY CONDITIONS. THE FIRST TIME IT HAPPENED WAS WHEN I PULLED INTO A SPOT A…
Read full complaint
THIS CAR IS A 97 Z28 WITH THE 350CI MOTOR AND 4 SPEED AUTO TRANSMISSION. WHAT HAPPENS IS THAT WHEN THE FRONT WHEELS ARE NOT TURNING, THE REAR BRAKES DO NOT ENGAGE, NO MATTER HOW HARD YOU PUSH DOWN ON THE BRAKE PEDAL. THE ISSUE PRESENTS ITSELF UNDER ICY CONDITIONS. THE FIRST TIME IT HAPPENED WAS WHEN I PULLED INTO A SPOT AT A FAST FOOD PLACE, THE PARKING SPOT WAS ICY WHILE THE REST OF THE LOT WAS ICE FREE. AS I PULLED INTO THE SPOT, I PUT ON MY BRAKES AND THE FRONT WHEELS STOPPED, BUT THE REAR DID NOT. THEY WERE ON THE CLEAR PART OF THE PARKING LOT AND THEY SHOULD HAVE STOPPED MY FORWARD MOTION, HOWEVER THEY DID NOT. SLID AHEAD UNTIL THE FRONT HIT THE SNOW BANK. THOUGHT THIS WAS UNUSUAL, BUT DIDN'T CONCERN MYSELF ABOUT IT ANY MORE. NEXT TIME I BECAME AWARE OF THE PROBLEM WAS WHEN I HAD THE REAR (BOTH) WHEELS OF THE CAR OFF THE GROUND AND I PUT THE CAR IN DRIVE AS I WANTED TO CHECK IF ONE OF THE REAR RIMS WAS BENT. WELL NO IT WASN'T BUT WHEN I GOT BACK IN THE CAR TO PUT IT IN PARK, I PRESSED ON THE BRAKE PEDAL TO STOP THE REAR WHEELS FROM TURNING, AND THEN WENT TO PUT THE GEAR SHIFT LEVER IN PARK. BIG GRINDING NOISE. SO I PRESSED HARDER ON THE BRAKE AND TRIED TO PUT IT IN PARK AGAIN, AGAIN BIG GRINDING NOISE. SO I LOOKED AT THE REAR WHEELS WHILE PRESSING THE BRAKE, AND WHAT TO MY SURPRISE, THE REAR WHEELS DO NOT STOP! THIS CAN'T BE A GOOD THING. TODAY AS I BACKED OUT OF THE GARAGE, THE DRIVEWAY WAS A LITTLE ICY. SO AS I BACKED UP, I PUT ON THE BRAKES, AND OF COURSE, ONLY THE FRONT WHEELS STOPPED AND THE REAR WHEELS KEPT PULLING THE CAR DOWN THE DRIVEWAY. NOT A GOOD THING IF A CAR IS PASSING BY ON THE STREET. SO WHAT'S UP WITH THIS. YES MY CHECK ENGINE LIGHT IS ON, BUT I WAS TOLD BY THE CHEV DEALER THAT IT IS FROM THE TRANSMISSION BECAUSE SOMETIMES, WHEN IT IS HOT, IT WILL SHIFT HARD.
THESE VEHICLES WERE MANUFACTURED WITH SEAT BELT RETRACTORS OUT OF DESIGN POSITION WHICH CAN CAUSE THE RETRACTOR TO LOCK-UP ON SLOPES LESS SEVERE THAN THE FMVSS REQUIREMENT. THIS DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."
Consequence & remedy
Consequence: IN THE EVENT OF A VEHICLE COLLISION, UNBELTED OCCUPANTS ARE MORE AT RISK OF INJURY THAN THOSE USING SEAT BELTS.
Remedy: DEALERS WILL INSPECT THE SEAT BELTS FOR PROPER FRONT SEAT BELT RETRACTOR POSITION. RETRACTORS FOUND TO BE IMPROPERLY POSITIONED WILL BE REINSTALLED CORRECTLY.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
EA97024 · Fuel Tube Retaining Clip Failure
Opened Nov 13, 1997 · Closed Sep 29, 1998
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
MOST OF THE REPORTS REVIEWED IN THIS INVESTIGATION ARE FIRE INCIDENTS IN WHICH FUEL LEAKAGE HAS BEEN ALLEGED AS THE CAUSE OR THE AREA OF ORIGIN IS CONSISTENT WITH THE ALLEGED DEFECT.THERE IS NO EVIDENCE THAT THE SUBJECT CLIP WAS A FACTOR IN ANY OF THESE FIRE INCIDENTS AND NHTSA TESTING INDICATES THATBROKEN OR DISLODGED RETENTION CLIP DOES NOT RESULT IN SIGNIFICANT MOVEMENT OF THE FUEL LINE BUNDLE TOWARD THE LEFT SECONDARY AIR INJECTION CHECK VALVE.FAILURE OF THE CLIP PLACES THE FUEL LINE BUNDLE ASSEMBLY IN THE SAME CONFIGURATION AS THE 1993 MODEL YEAR LTI VEHICLES.A SAFETY-RELATED DEFECT TREND HAS NOT BEEN IDENTIFIED AT THIS TIME AND FURTHER USE OF AGENCY RESOURCES DOES NOT APPEAR TO BE WARRANTED.THE CLOSING OF THIS INVESTIGATION DOES NOT CONSTITUTE A FINDING BY NHTSA THAT NO SAFETY-RELATED DEFECT EXISTS.THE AGENCY RESERVES THE RIGHT TO TAKE FURTHER ACTION IF WARRANTED BY THE CIRCUMSTANCES.
PE97036 · Fuel Tub Retaining Clip Failure
Opened Jul 24, 1997 · Closed Nov 13, 1997
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
OWNERS HAVE REPORTED FAILURES OF THE FUEL TUBE RETENTION CLIP THAT ATTACHES TO THE PLASTIC THROTTLE LINKAGE COVER.ACCORDING TO GM, THE SUBJECT RETENTION CLIP (P/N 12048089) WAS IMPLEMENTED IN PRODUCTION ON OCTOBER 12, 1993, TO ADDRESS A CONCERN WITH INCORRECT ASSEMBLY PLANT FUEL LINE ROUTING.MIS-ROUTED FUEL TUBES MAY FAIL FROM CONTACT WITH A HOT AIR CHECK VALVE, CREATING A FIRE HAZARD IN THE ENGINE COMPARTMENT.GM MAINTAINS THAT NO PROBLEMS SHOULD OCCUR IF THE CLIP IS PROPERLY INSTALLED AND ISN'T MISHANDLED DURING SUBSEQUENT SERVICE OPERATIONS.SOME OWNERS HAVE ALLEGED TO ODI THAT THE SUBJECT CLIP BECOMES BRITTLE OVER TIME AND MAY ALSO PULL FREE OF THE THROTTLE LINKAGE COVER ATTACHMENT HOLE.
1997 Chevrolet Camaro Problems, Complaints & Recalls | Skip That Year
Illustration